Maniway Electronics MW1239 Bluetooth Speaker User Manual J081 1239 ETL

Download:
Mirror Download [FCC.gov]
Document ID	1782065
Application ID	ii1WYb0xWlS2nwpIEPdQPw==
Document Description	user manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	99.22kB (1240245 bits)
Date Submitted	2012-09-04 00:00:00
Date Available	2012-09-04 00:00:00
Creation Date	2012-07-30 08:59:21
Producing Software	Corel PDF Engine Version 3.0.0.739
Document Lastmod	0000-00-00 00:00:00
Document Title	J081--1239认证说明书 ETL.cdr
Document Creator	CorelDRAW
Document Author:	meigong

Maniway
2.1CH BLUETOOTH SPEAKER
MODEL:MW-1239
Delu
xe M
usic
Statio
PLEASE READ BEFORE OPERA TING EQUIPMENT
Warning:
To reduce the risk of electric shock, do not
remove cover (or back) as there are no userserviceable parts inside. Refer servicing to
qualified personnel.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding plug. A polarized plug has two blades with one
wider than the other. A grounding plug has two blades and
a third grounding prong. The wide blade or the third prong
is provided for your safety. If the provided plug does not fit
into your outlet, consult an electrician for replacement of
the obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at the plugs, convenience receptacles, and at
the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the
manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified
by the manufacturer, or sold with the apparatus. When a cart
or rack is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
WARNING:SHOCK HAZARD. DO NOT OPEN
AVIS:RISQUE DE CHOC ELECTRIOUE, NE PAS OUVRIR
CAUTION TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER TO QUALIFIED SERVICE PERSONNEL.
- This lightning flash with arrowhead symbol within an
equilateral triangle is intended to alert the user to
the presence of non-insulated ’dangerous voltage’
within the product’s enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock.
- The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance instructions
in the literature accompanying the appliance.
This equipment is a Class II or double insulated
electrical appliance. It has been designed in such a
way that it does not require a safety connection to
electrical earth.
13. Unplug the apparatus during lightning storms or when unused
for long periods of time.
14. Refer all servicing to qualified personnel. Servicing is required
when the apparatus has been damaged in any way, such as
power supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus has been
exposed to rain or moisture, does not operate normally, or
has been dropped.
15. CAUTION: These servicing instructions are for use by qualified
service personnel only. To reduce the risk of electric shock,
do not perform any servicing other than that contained in the
perating instructions unless you are qualified to do so.
16. Do not install this equipment in a confined or building-in
space such as a book case or similar unit, and remain a well
ventilation conditions at open site. The ventilation should
not be impeded by covering the ventilation openings with
items such as newspaper, table-cloths, curtains etc.
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions - All the safety and operating
instructions should be read before this product is
operated.
2. Keep these instructions -The safety and operating
instructions should be retained for future reference.
3. Heed all warnings - All warnings on the appliance and
in the operating instructions should be adhered to.
4. Follow all instructions - All operating and use
instructions should be followed.
5. Do not use this apparatus near water - The appliance
should not be used near water or moisture - for
example, in a wet basement or near a swimming pool,
and the like.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacture ’ s instructions.
17. WARNING˖Please refer the information on exterior bottom
enclosure for electrical and safety information before installing
or operating the apparatus.
-1-
18. WARNING˖To reduce the risk of fire or electric
shock, do not expose this apparatus to rain or
moisture. The apparatus shall not be exposed to
dripping or splashing and that objects filled with
liquids, such as vases, shall not be placed on
apparatus.
19. WARNING: The battery (battery or batteries or
battery pack) shall not be exposed to excessive
heat such as sunshine, fire or the like.
20. WARNING: The mains plug is used as disconnect
device, the disconnect device shall remain readily
operable.
21. No naked flame sources, such as lighted candles,
should be placed on the apparatus.
22. Attention should be drawn to environmental
aspects of battery disposal.
23. Use of the apparatus in moderate climates.
COMPLIANCE WITH FCC REGULATIONS
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE : This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
CAUTION: Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
-2-
5
MODE
(search forward/backwards)
(power supply only for charging)
LED-PRESET
10
VOL-
VOL+
10 LED PRESET(ON/OFF the pilot lamp)
-３-
battery. For proper
Insert the power plug into a convenient Ac wall outlet
Insert 2pcs UM-4/AAA type batteries. Pay attention to
the correct polarity (see bottom of battery compartment)!
-4-
Connect 3.5 mm stereo adio cable (included) to an
external audio source. If required, use a suitable
adapter (not included).
10
This USB port can supply power 5V/2.1A
Listening to FM Radio
Setting up the Antenna
Unstrap and extend the wire antenna fully for best
reception. Do not strip, alter or attach to other antennas.
MW-1239
Radio Tuning
1. Press MODE Button until “ FM ” icon shown on the display
to enter the Radio mode.
2. Press the “ ” or “ ” button to automatically search for
stations with strong signals, the tuner will stop on the first
strong station signal it finds.
3. Press ST./MO. button on the remote control to select the
stereo (St ON)/monaural (St OFF) mode.
Notes:
-Manual tune to select weaker stations that might be by
skipped during automatic tuning
- If the automatic tuning does not stop on the exact frequency
of the station, for example, it stops on 100.8MHz instead of
100.6MHz.
Radio Preset Stations
The unit allows you to store up to 50 FM stations to recall
at any time.
Preset Stations
Press and hold the “ ” button until the frequency digits
on display begins to scan then release the button, the unit
will auto search from low-end frequency toward high-end
frequency and automatically save up all the stations with
strong signals in sequence. It will automatically play the
No. 1 station saved once the auto searching is finished.
Recalling the Preset Stations
Press the button to select the preset station in sequence
-5-
MW-1239
120V~60Hz
Power of Remote control
FM Frequency Range
35W
3V( 2x 1.5V “AAA”UM-4) Batteries
87.5-108MHz
0-35℃
Temperature range for use
10
Mute operation Press the Mute button to
is on
release mute
Poor sound
quality from a
Bluetooth®
device
Radio interference.
Bluetooth device Move your Bluetooth device
is almost out of closer to the MW-1239
range of the
MW-1239
Too close to a
radio tower.
Move your speakers to see if
the interference goes away.
You man be able to purchase
a shielded cable at your Iocal
electronics store.
Remote control is
not functioning
properly.
Low battery.
Replace the battery with
correct type AAA or UM-4.
Remote Control Point the Remote Control to
is not pointed ward the unit IR window,use
to ward the IR with in 10 feet of the unit.
window
-7-

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : Yes
XMP Toolkit                     : 3.1-702
Creation Date--Text             : 
Producer                        : Corel PDF Engine Version 3.0.0.739
Mod Date--Text                  : 
Format                          : application/pdf
Creator                         : meigong
Title                           : J081--1239认证说明书 ETL.cdr
Creator Tool                    : CorelDRAW
Modify Date                     : 2012:08:02 16:23:30+08:00
Metadata Date                   : 2012:08:02 16:23:30+08:00
Document ID                     : uuid:567b5c21-cc53-4091-9fc4-c94566de0729
Instance ID                     : uuid:68c699d5-5b15-4247-a377-255d906e2120
Page Count                      : 7
Create Date                     : D:20120730085921
Author                          : meigong

EXIF Metadata provided by EXIF.tools