Miwa Lock DWMS-VDCR01 ALVH Desktop Card Reader User Manual MIWA
Miwa Lock Co., Ltd ALVH Desktop Card Reader MIWA
MIWA user manual
Confidential User Manual User Manual Product Name ALVH Desktop Card Reader Model DWMS-VDCR01 Version 3.0 March 5,2008 Miwa Lock Co., Ltd. Miwa Lock Co.,Ltd. 1/8 Confidential User Manual 1. Introduction This document describe the supply specifications for the ALVH Desktop Card Reader (VDCR). The VDCR is a desktop Mifare card reader/writer installed in the hotel and connects to a PC server via RS-232C port. PC server can write necessary data to the Mifare card which is placed on the VDCR. The KB/SSDW-05 is a keyboard which also can write the data in the card when installed between the VDCR and the computer. RS-232C RS-232C RUN STOP Mifare card MIWA VDCR KB/SSDW-05 Fig.1.1: Host connection Miwa Lock Co.,Ltd. 2/8 PC server Confidential User Manual 2. Hardware specifications Items General specifications Power source Mounting board Table 2.1: Hardware specifications Description Weight Power consumption Temperature/ Humidity 225g (Only main unit ) 13W Running temperature AC power adapter 230g :+0∼+40°C / 25∼85% (without condensation) Storage temperature : −15∼+50°C / 25∼85% (without condensation) Environment Room (without excessive dust) Model: 3A-161DA05(MAP ELECTRONICS) Input: 100Vac~240Vac Output: 5Vdc,2.6A AC power adapter Safety standard: UL Electrical standard: CE Performs Mifare card reading/writing MPU: R8C/Tiny series R5F21258SNFP (Renesas Technology) Running frequency :20 MHz Control board Built in FROM :64kbyte+2kbyte (including antenna Built in RAM :3kbyte board) Built in I/F :2 channels Communication with card: By exclusive chip(RC531) Supply voltage : 3Vdc Perform convertion of signal between Control board and external serial interface. Communication board Signal level conversion : RS232C ⇔ TTL Voltage conversion : 5Vdc⇒3Vdc LED for power source (RUN indication) LED board Color : Green Supply voltage : 5Vdc LED for plane surface illumination (3 colors) and LED for card detection status indication. Lighting Panel : 6 (3 for upper side of the panel, 3 for lower side of the panel) Panel LED board Illuminated colors :Red / Green / Orange (software control) Status display : 1 (STS display) Illuminated colors :Red / Green / Orange (software control) Supply used :5Vdc Miwa Lock Co.,Ltd. 3/8 Confidential User Manual 3. Composition outline 3.1. Outline of system composition The VDCR composed of the following units. 1. VDCR main unit 2. AC adapter Fig. 3.1 shows the top view of the VDCR main unit, and Fig. 3.2 shows arrangement of external interface of the VDCR main unit. Status LED Power source LED Lighting panel for card communication Fig. 3.1 Top view of VDCR main unit DC jack Serial interface(RS-232C) DC 5.0V Fig. 3.2 Arrangement of interface panel of VDCR main unit Miwa Lock Co.,Ltd. 4/8 Confidential User Manual 4. Connection to external devices 4.1. VDCR main unit External unit are connected by proper cables to each connector arranged to the posterior interface panel. 1. RS-232C 2. 5Vdc : Upper unit (PC server) : AC adapter Upper unit AC adapter Ferrite core (three turns) Ferrite core (two turns) RS232C cross cable RS-232C 5Vdc Fig.4.1: External unit connection of VDCR main unit RS232C cross cable Ferrite core The cable is turned once and gose through the Ferrite core twice Fig.4.2: Ferrite core Miwa Lock Co.,Ltd. 5/8 Confidential User Manual 5. VDCR external interface 5.1. VDCR main unit external interface 5.1.1. Serial interface (IOIO) Fig. 5.1: Serial interface Pin No. Name Table 5.1:IOIO connector specifications Description N.C. - RX Received data TX Sent data DTR Data terminal ready GND Ground DSR Data set ready RTS Send request(Non-connection) CTS Send enable(Non-connection) N.C. - Connector used Model name: EJEY-9P-1F3F-113 Manufacturer: J.S.T Mfg Co., Ltd. Note 1: #4 pin (DTR) and #6 pin (DSR) are shorted on the control board. I/O Note 1 Note 1 5.1.2. Power supply interface Fig. 5.2: Power supply interface (DC jack) Inner diameter #1 1.7 Table 5.2: Specification of AC power adapter plug Outer diameter Length #2 4.0 #3 5Vdc 2.6A #3 9.5 Unit mm #1 GND #2 Fig. 6.3 :Specification of AC power adapter Miwa Lock Co.,Ltd. 6/8 5Vdc - - - Confidential User Manual 5.2. Condition of Mifare card communication The Mifare card can communicate up to 12mm from lighting panel surface, under the following conditions: Condition1 Condition2 Condition3 Condition4 Condition5 When the applied card is a MARS compatible card, and a single card is held up. Center of the applied card surface is less than 5mm in horizontal direction from the center of the lighting panel surface. The lighting panel surface and applied card surface are parallel to each other. There are no obstruction to electromagnetic waves (13.56MHz) between the lighting panel surface and the applied card. There are no obstruction to electromagnetic waves (13.56MHz) within 12mm of the VDCR main unit. Fig. 5.4 Shows the communication range of the Mifare card. IC Card 5mm 5mm MIFARE 5mm 12mm Electromagnetic obstacle prohibited area Fig. 5.4: Card communication range Miwa Lock Co.,Ltd. 7/8 Confidential User Manual 6. Regulatory Compliance 6-1. USA-Federal Communications Commission (FCC) This unit has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This unit generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this unit does cause harmful interference to radio or television reception, which can be determined by turning the unit off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the unit and receiver. - Connect the unit into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This unit complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This unit may not cause harmful interference, and (2) This unit must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications not expressly approved by the party responsible for product compliance could void the user's authority to operate the unit. Labelling MIWA LOCK ALVH Desktop Card Reader is labelled as below. FCC ID: VBU –DWMS-VDCR01 FCC Portion Federal Communication Commission Declaraton of Conformity (Doc)Statement Model No: DWMS-VDCR01 Trade Name ALVH Desktop Card Reader Responsible Party MIWA LOCK CO.,LTD. Address 3-1-12,Shiba, Minato-ku,Tokyo 105-8510,Japan Telephon No +81-3-3452-1465 Miwa Lock Co.,Ltd. 8/8
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Page Count : 8 Producer : AFPL Ghostscript 8.13 Create Date : 2008:03:05 18:33:14 Modify Date : 2008:03:05 18:33:14 Title : Microsoft Word - DWMS-VDCR01-User Manual Ver3.0.doc Creator : PrimoPDF http://www.primopdf.com Author : hyanagisawaEXIF Metadata provided by EXIF.tools