Mun Ah Plastic Electronic Toys MTM17LP RC Toy Transmitter User Manual CTX 1710 Instruction 01

Download:
Mirror Download [FCC.gov]
Document ID	1959865
Application ID	o925+AIiNziOwLqJIbW7Aw==
Document Description	Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	70.04kB (875449 bits)
Date Submitted	2013-05-08 00:00:00
Date Available	2013-05-08 00:00:00
Creation Date	2013-04-08 15:36:06
Producing Software	Adobe PDF library 8.00
Document Lastmod	2013-04-08 18:02:35
Document Title	CTX-1710_Instruction_01
Document Creator	Adobe Illustrator CS3

CTX-1710 2.4GHz Transmitter
Power ON / OFF the Transmitter
The Transmitter CTX-1710
Steering Wheel : Control direction (Left/Right) of the RC model.
Throttle Trigger : Control speed and direction
(Forward/Brake/Backward)of the driving model.
Antenna : Transmit signal to the model.
Power ON / OFF : Power ON / OFF the transmitter
SYNC & Battery Indicator : Top Green LED light indicates synchronization
status and/or adequate battery power supply.
Power Indicator : Bottom Red LED light indicates power “ON”.
Dual Rate Dial : Adjust the same maximum steering angle on
both sides when model turns Left / Right
ST. Trim Dial : Adjust the neutral position of steering servo
when model wheels are straight ahead.
TH. Trim Dial : Make sure the model stays still when releasing
the throttle trigger.
Battery Compartment Tray : Cover and hold the batteries powering the
transmitter.
* In general, user will experience under steer when making a wide turn at
high speed or over steer when making sharp turn at high speed (easy to
spin out). User should practice the throttle and steering approach for
different cornering at different speed or road surface.
Antenna
SYNC and
Battery
Level Indicator
Dual Rate Dial
Steering Trim Dial
Power
ON / OFF
ST.TRIM
TH.TRIM
Throttle Trim Dial
Power
Indicator
Steering Wheel
SYNC
SYNC
Throttle Trigger
SYNC Button
(Synchronization)
Battery
Compartment Tray
CTX-1710
Battery Installation
Supplied with 4 x 1.5V AA Batteries,
CTX-1710 can be operated a few hours.
Installation: Remove the battery
compartment cover as shown below.
Install the batteries observing
the polarity marked on battery
compartment.
Then reinstall the battery
compartment cover as the
Picture shown below.
Warning :
Never disassemble batteries or put the batteries
in fire, chemical agents, otherwise they may cause
personal injuries or property damages.
Battery Disposal :
Observe corresponding regulations about wasted
battery treatment regulations.
1. After running out of power, dispose of wasted
batteries in designated areas far away from
water supply, household areas and planted areas.
2. Submit the wasted batteries to specific recycling
stations.
Battery LED Indicator
Pre-Run Check
The Green LED indicator located on the front left side of the transmitter indicates
the power supply of batteries. The green LED will go solid on indicating that the
batteries have sufficient power. When batteries voltage drops below 4 volts, the
Green LED will flash, indicating the batteries power is low and should be replaced.
1. Steering : Adjust the steering trim
to keep the front wheels in straight
line when steering wheel remains
in NEUTRAL position.
ST.TRIM
Solid Green :
Sufficient Power supply
Green
2. Throttle : Adjust the throttle trim
to ensure the rear wheels stop
rotating when throttle trigger
remains in NEUTRAL position.
TH.TRIM
Flashing :
Time to replace batteries
Red
* Always turn on the transmitter first by sliding the switch on the left side from
bottom to top. The small red and green lights above the switch should both
light up. If not, you need to check for low or incorrectly installed batteries.
Top Control Panel
Steering Reverse Switch
Dual Rate Dial
Throttle Reverse Switch
Dual Rate Dial
Trimming
Dual Rate Dial enables to adjust the same maximum steering angle of servo on
both sides (Left and Right) when model makes steering. The Dual Rate Dial affects
the sensitivity of servo. Reducing dual rate value can lower the sensitivity of servo
and reduce the same maximum steering angle on both sides. Remember to adjust
the dual rate value within the adjustment range.
Reversing
Reversing is used to change the response direction of steering wheel and throttle
trigger. CTX-1710 Transmitter features 2 reversing functions: Steering Reverse
and Throttle Reverse.
Steering Reverse: Reverse the response direction when operating steering
wheel. Turning left steering wheel, the model turns right while turning right the
model turns left.
Throttle Reverse: Reverse the response direction when operating throttle trigger.
Pushing forward throttle trigger the model moves backward while pulling back,
the model moves forward. If necessary you can just use a small screwdriver to
adjust the orresponding switches.
ST.TRIM
TH.TRIM
CTX-1710 features two trimming
functions:
Steering Trim and Throttle Trim.
Steering Trim Dial :
Adjust the neutral position of steering
servo when the wheels are straight ahead.
Normally steering trim is adjusted until the
model can keep straight tracks.
Throttle Trim Dial :
Adjust neutral position of throttle servo.
Make sure the model stays still when
releasing the throttle trigger.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1-701
Format                          : application/pdf
Title                           : CTX-1710_Instruction_01
Creator Tool                    : Adobe Illustrator CS3
Create Date                     : 2013:04:08 15:36:06+08:00
Modify Date                     : 2013:04:08 18:02:35+08:00
Metadata Date                   : 2013:04:08 18:02:35+08:00
Thumbnail Width                 : 256
Thumbnail Height                : 124
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 9088 bytes, use -b option to extract)
Document ID                     : uuid:F373C2ACF3A1E211B497F4DF704F66B3
Instance ID                     : uuid:e091c93f-73e4-48df-a486-e8ccd77ccc16
Derived From Instance ID        : uuid:F273C2ACF3A1E211B497F4DF704F66B3
Derived From Document ID        : uuid:F173C2ACF3A1E211B497F4DF704F66B3
Startup Profile                 : Print
N Pages                         : 1
Has Visible Transparency        : False
Has Visible Overprint           : False
Max Page Size W                 : 209.999994
Max Page Size H                 : 297.000002
Max Page Size Unit              : Millimeters
Font Name                       : EurostileRegular, EurostileBold, HelveticaLTStd-BoldCond, HelveticaLTStd-Cond, Helvetica-Bold, Helvetica
Font Family                     : Eurostile, Eurostile, Helvetica LT Std, Helvetica LT Std, Helvetica, Helvetica
Font Face                       : Regular, Bold, Bold Condensed, Condensed, Bold, Regular
Font Type                       : Open Type, Open Type, Open Type, Open Type, TrueType, TrueType
Font Version                    : Version 1.51, Version 1.51, OTF 1.029;PS 003.001;Core 1.0.33;makeotf.lib1.4.1585, OTF 1.029;PS 003.001;Core 1.0.33;makeotf.lib1.4.1585, 5.0d8e2, 5.0d8e2
Font Composite                  : False, False, False, False, False, False
Font File Name                  : Eurostile, Eurostile, helveticaltstd-boldcond.otf, helveticaltstd-cond.otf, Helvetica.dfont, Helvetica.dfont
Plate Names                     : Cyan, Magenta, Yellow, Black
Swatch Groups Group Name        : Default Swatch Group
Swatch Groups Group Type        : 0
Producer                        : Adobe PDF library 8.00
Page Count                      : 3
Creator                         : Adobe Illustrator CS3

EXIF Metadata provided by EXIF.tools