On Track Innovations 13560K915MCON VST/PST Controller User Manual VST PST Controller Manual
On Track Innovations Ltd VST/PST Controller VST PST Controller Manual
Contents
- 1. Users Manual
- 2. Correctected Page to Users Manual
- 3. Corrected Page to Users Manual
Corrected Page to Users Manual
Vst/Pst Controller Ver. A1.00
Installation Requirements
P/N 1100035 page 3-5
3.3.1 Installation Guide Lines
The VST antenna should be mounted outside window counter. The antenna should be
mounted horizontal facing down approximately 10 feet above road level.
Connect mounting brackets to VST antenna mounting bolts.
Anchor Mounting brackets to wall or ceiling using 6mm KS-Anchors. Drill and mount
the anchors through the mounting bracket holes.
3.3.2 Wiring Guidelines
The VST antenna panel is supplied with an SMA connector. RG58 coax cable should
be used. Cable length should be exactly 4 meters . The coax cables should be routed
through protected conduit and connected to the SMA connector on the VST/PST
controller box. Allow for a small downward loop in the cable before entering the wall
to prevent water seepage into the wall.
THE ANTENNA CABLE MUST NOT BE CUT! It must be used in the length
provided.
3.3.3 Grounding
The VST antenna requires separate grounding Use 10AWG wire to connect between
the antenna mounting bracket and ground.
3.4 VST/PST Controller
3.4.1 Safety
The VST/PST controller uses 120VAC power supply connected terminals in a
partitioned area marked by a yellow triangle with lightning bolt
indicating presence of hazardous voltage.
Keep hand off this area!
Warning!
Unit is supplied with 120VAC plug-in power cord.
Do not connect the main supply before installation is complete.
Disconnect power from the main supply before attempting to replace 1A fuse in AC
supply terminal.
Removal of VST/PST controller cover for inspection or maintenance is permitted for
qualified personnel only.