PAC PAC-D-DT Low range proximity reader User Manual Users manual

PAC International Limited Low range proximity reader Users manual

Users manual

INTERNATIONAL Data SheetNovember 2000 17384 DRAFT20462, 20453 DualTech Desktop ReaderInstallation Instructions
DescriptionThe DualTech PC Desktop Reader is an accessory for use with a PAC Adminstration interface unit.This system is used for direct PC to controller communications (fig. 1).Note: This Desktop Reader will read KeyPAC and PAC ID-devices.Note: It is unlikely that you will need an Interface Kit at a PC that already has a CNC attached.CNCs have either front panel or external readers for administration purposes.WARNING: The Interface Unit contains mains voltages. This procedure should only be carried out bya suitably qualified and experienced person. If you have any doubts as to your suitabilitycontact PAC for advice. Failure to do so may result in injury or death by electric shock.WARNING: If, at any time, the interface kit or its wiring appear damaged then immediatelydisconnect it from the mains and contact PAC for advice. Failure to do so can result inelectric shock and/or further damage to equipment.
DualTech Desktop Reader 17384 DRAFTPage 3 DRAFT ©2000 PAC International Ltd.InstallationOpening the Interface UnitWARNING: This Interface Unit contains mains voltages. Before opening ensure that it isdisconnected from the mains. Failure to do so can result in injury or death by electricshock.Make sure that the Interface Unit is not connected to the mains then remove the lid by removing the4 screws recessed in the base.There are removable terminal blocks fitted to the circuit board as shown below:Connecting the Desktop readerThe Desktop reader supplied with the kit is complete with cable and terminal block. Fit the terminalblock with the screw heads facing the centre of the interface unit, and route the cable through thegrommet provided. Wiring for provided cables - for information only
DualTech Desktop Reader 17384 DRAFTPage 4 DRAFT ©2000 PAC International Ltd.Desktop Reader to Interface56 inch cable supplied.PC Interface Desktop Reader4-pole Terminal Block Desktop reader-V ———— -V GreenVCA ———— VCA YellowSIG ———— SIG White+V ———— +V BrownSpecificationDimensions 5.12in x 3.54in x 1.25inVoltage 10.5v DC to 20v DC (Supplied by Administration Interface Unit)Current Less than 85mATemperature Operating: -10°C to +55°C (14°F to 130°F)Storage: -30°C to +80°C (-20°F to 175°F)Humidity Operating: 0-90% RH at 30°C ±2°C (85°F±5°F) for 24 hoursReading Range KeyPAC: Up to 4 inchesPAC: Up to 2 inchesLead Length 56 inchesThis device complies with part 15 of the FCC rules. Operation is subject to the following twoconditions (1) this device may not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesired operation.FCC ID OQL-PAC-D-DT

Navigation menu