PAC PAC-D-DT Low range proximity reader User Manual Users manual
PAC International Limited Low range proximity reader Users manual
PAC >
Users manual
INTERNATIONAL November 2000 Data Sheet 17384 DRAFT 20462, 20453 DualTech Desktop Reader Installation Instructions Description The DualTech PC Desktop Reader is an accessory for use with a PAC Adminstration interface unit. This system is used for direct PC to controller communications (fig. 1). Note: This Desktop Reader will read KeyPAC and PAC ID-devices. Note: It is unlikely that you will need an Interface Kit at a PC that already has a CNC attached. CNCs have either front panel or external readers for administration purposes. WARNING: The Interface Unit contains mains voltages. This procedure should only be carried out by a suitably qualified and experienced person. If you have any doubts as to your suitability contact PAC for advice. Failure to do so may result in injury or death by electric shock. WARNING: If, at any time, the interface kit or its wiring appear damaged then immediately disconnect it from the mains and contact PAC for advice. Failure to do so can result in electric shock and/or further damage to equipment. DualTech Desktop Reader 17384 DRAFT Installation Opening the Interface Unit WARNING: This Interface Unit contains mains voltages. Before opening ensure that it is disconnected from the mains. Failure to do so can result in injury or death by electric shock. Make sure that the Interface Unit is not connected to the mains then remove the lid by removing the 4 screws recessed in the base. There are removable terminal blocks fitted to the circuit board as shown below: Connecting the Desktop reader The Desktop reader supplied with the kit is complete with cable and terminal block. Fit the terminal block with the screw heads facing the centre of the interface unit, and route the cable through the grommet provided. Wiring for provided cables - for information only Page 3 DRAFT ©2000 PAC International Ltd. DualTech Desktop Reader 17384 DRAFT Desktop Reader to Interface 56 inch cable supplied. PC Interface Desktop Reader 4-pole Terminal Block -V VCA SIG +V Desktop reader ———— ———— ———— ———— -V VCA SIG +V Green Yellow White Brown Specification Dimensions 5.12in x 3.54in x 1.25in Voltage 10.5v DC to 20v DC (Supplied by Administration Interface Unit) Current Less than 85mA Temperature Operating: -10°C to +55°C (14°F to 130°F) Storage: -30°C to +80°C (-20°F to 175°F) Humidity Operating: 0-90% RH at 30°C ±2°C (85°F±5°F) for 24 hours Reading Range KeyPAC: Up to 4 inches PAC: Up to 2 inches Lead Length 56 inches This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID OQL-PAC-D-DT Page 4 DRAFT ©2000 PAC International Ltd.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : Yes Create Date : 2000:12:14 12:57:59 Producer : Acrobat Distiller 4.0 for Windows Modify Date : 2000:12:14 12:58:00-05:00 Page Count : 4EXIF Metadata provided by EXIF.tools