PEGATRON VJZ12AD11L 2x2 PCIe M.2 adapter card User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2706908
Application ID	q2AFuHfQ4V2Aqc1umFOy/w==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	7.04kB (88039 bits)
Date Submitted	2015-08-07 00:00:00
Date Available	2015-08-07 00:00:00
Creation Date	2015-08-05 17:41:43
Producing Software	Acrobat Distiller 9.0.0 (Windows)
Document Lastmod	2015-08-05 17:41:43
Document Title	Microsoft Word - F1_Change of ID _Intel 7265NGW_manual_0805
Document Creator	PScript5.dll Version 5.2.2
Document Author:	Elaine

Intel® Dual Band Wireless-AC 7265
User manual All rights reserved. Intel Corporation,
Introduction:
Intel® Dual Band Wireless‐AC 7265 (code name Stone Peak 2 or StP2) shall be the VHT‐5G Wi‐Fi 2x2 and Bluetooth combination
single chip solution. StP2 shall use Intel’s 2nd generation 802.11ac Wi‐Fi solution and shall support both 2.4 and 5.2 GHz bands.
On the 5.2 GHz band it shall operate on an 80 MHz wide channel reaching PHY rates of up to 867 Mbps. StP2 shall use a
Bluetooth core that shall support Bluetooth 4.0 standard including Bluetooth 4.0 Low Energy (BLE). StP2 shall have 2 antenna
ports: one shall be Wi‐Fi only and the second will be shared between Wi‐Fi and Bluetooth. Wi‐Fi shall support Rx antenna
diversity.
HW describe:
Form Factors
M.2 (Next Generation Form
Factor - NGFF)
Electrical interfaces
PCIe and USB 2.0
Antenna Interface
Hirose U.FL-R-SMT mates with
Connector
cable connector U.FL-LP-066
Antenna Diversity
On-board diversity
IEEE 802.11
802.11abgn, 802.11ac, 802.11d,
Networking Standards
802.11e, 802.11i, 802.11h,
802.11w
Operating
0 to +80 degrees Celsius
Temperature
Humidity
50% to 90% RH non-condensing
(at temperatures of 25 ºC to 35
ºC)
Frequency
5GHz (802.11ac/n)
2.4GHz (802.11b/g/n)
5.15GHz - 5.85GHz (dependent
2.400 - 2.4835GHz (dependent on
on country)
country)
BPSK, QPSK, 16 QAM, 64 QAM,
CCK, DQPSK, DBPSK
Modulation
Frequency band
Modulation
256 QAM
Wireless Medium
Channels
5GHz UNII: Orthogonal
2.4GHz ISM: Orthogonal Frequency
Frequency Division
Division
Multiplexing (OFDM)
Multiplexing (OFDM)
All channels as defined by the
relevant specification and
country rules.
Spatial streams
Intel® Dual Band Wireless-AC
7265: 2 X 2
Data Rates
All data rates are theoretical
maximums.
IEEE 802.11ac Data
Intel® Dual Band Wireless-AC
Rates
7265: Up to 867 Mbps
IEEE 802.11n Data
Tx/Rx (Mbps): 300, 270, 243,
Rates
240, 216.7, 195, 180, 173.3,
150, 144, 135, 130, 120, 117,
115.5, 90, 86.667, 72.2, 65, 60,
57.8, 45, 43.3, 30, 28.9, 21.7,
15, 14.4, 7.2
IEEE 802.11a Data
54, 48, 36, 24, 18, 12, 9, 6 Mbps
Rates
IEEE 802.11g Data
54, 48, 36, 24, 18, 12, 9, 6 Mbps
Rates
IEEE 802.11b Data
11, 5.5, 2, 1 Mbps
Rates
Bluetooth
Dual Mode Bluetooth* 2.1,
2.1+EDR, 3.0, 3.0+HS, 4.0 (BLE)
General
Operating Systems
Windows* 7 (32-bit and 64-bit),
Windows* 8 (32-bit and 64-bit),
Windows* 8.1 (64-bit)
Wi-Fi Alliance*
Wi-Fi CERTIFIED* for 802.11ac,
certification
a/b/g, n, WMM*, WPA*, WPA2*,
and WPS, WPS 2.0,
Protected Management Frames.
Wi-Fi Direct* for peer-to-peer
device connections.
Architecture
Infrastructure and SoftAP;
Supports simultaneous Client and
SoftAP modes
Cisco Compatible
Cisco Compatible Extensions,
Extensions
v4.0
certification
Security
Authentication
WPA and WPA2, 802.1X
(EAP-TLS, TTLS, PEAP, LEAP,
EAP-FAST), EAP-SIM, EAP-AKA
Authentication
PAP, CHAP, TLS, GTC,
Protocols
MS-CHAP*, MS-CHAPv2
Encryption
64-bit and 128-bit WEP,
AES-CCMP, TKIP
Wi-Fi Direct*
WPA2, AES-CCMP
Encryption and
Authentication
Product Safety
UL, C-UL, CB (IEC/EN 60950-1)
Install WLAN card to the host platform by factory.
SW describe:
Portions of Intel® PROSet/Wireless WiFi Connection Utility include software under the following terms:
1. Setup the Intel® PROSet for installing driver to the host platform.
2. Use the administrator to installing driver.
Portions Licensed from Devicescape Software, Inc.
Intel® PROSet/Wireless WiFi Connection Utility contains software licensed from Devicescape Software,
Inc. Copyright
(c) 2004 - 2008 Devicescape Software, Inc. All rights reserved.
Antenna Placement Within the Host Platform
To ensure RF exposure compliance the antenna(s) used with the Intel® wireless adapters must be
installed in
notebook or tablet PC host platforms to provide a minimum separation distance from all persons, in all
operating
modes and orientations of the host platform, with strict adherence to the table below. The antenna
separation
distance applies to both horizontal and vertical orientation of the antenna when installed in the host
system.
Wireless Adapter
Minimum required antenna-to-user
separation distance
Intel® Dual Band Wireless-AC 7265
8 mm
* This wireless adapter may be installed in mobile devices only
(requires > 20 cm antenna separation from the body of user).
Information To Be Supplied to the End User by the OEM or Integrator
The following regulatory and safety notices must be published in documentation supplied to the end user
of the product or system incorporating the Intel® wireless adapter, in compliance with local regulations.
Host system must be labeled with "Contains FCC ID: VUIVJZ12AD11L", FCC ID displayed on label.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
Federal Communication Commission (FCC) Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE
C95.1-1999 and had been tested in accordance with the measurement methods and procedures
specified in OET Bulletin 65 Supplement C.
IMPORTANT NOTE:
This module is intended for OEM integrator.
The OEM integrator is still responsible for the FCC compliance requirement of the end product, which integrates this
module.
Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment authorizations (e.g.
Verification , Doc) of the host device to be addressed by the integrator/manufacturer.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains TX FCC ID: VUIVJZ12AD11L ".

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : Elaine
Create Date                     : 2015:08:05 17:41:43+08:00
Modify Date                     : 2015:08:05 17:41:43+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Creator Tool                    : PScript5.dll Version 5.2.2
Producer                        : Acrobat Distiller 9.0.0 (Windows)
Format                          : application/pdf
Title                           : Microsoft Word - F1_Change of ID _Intel 7265NGW_manual_0805
Creator                         : Elaine
Document ID                     : uuid:83baf34f-e0af-4e0d-910f-d37d28b846e1
Instance ID                     : uuid:afc5b4c4-1aaf-4c2f-8221-d7161752d62b
Page Count                      : 5

EXIF Metadata provided by EXIF.tools