PHIHONG TECHNOLOGY CO RCARF Remote Controller User Manual

PHIHONG TECHNOLOGY CO LTD Remote Controller

User Manual

Phihong LED Lighting Remote Control is a RF remote for LED controls. One remotecan easily be used for multiple light fixtures and adjust individually It provides userseffortless upgrade to turn any regular lamp into a wireless controlled lamp..User s Manual'- Six group settings for individual control of different rooms- 5 stages of dimming function setting.RF Operating FrequencyNumber of controllable groupsDimension6 groups(Length)86.2mm*(Width)33mm*(Thickness)6.5mmRemote Controls Keys FunctionsUp to 180 steps of dimmingID Setting- PresetIDis1- Step by step SettingStep1:Power on the LED bulbs/tubes to be set upStep2:Press Set and number key at the same time to complete settingStep3:Setting is complete,press numbers for lighting control.Initial use and battery change- Remove isolation sheet by pulling- For child safety,this design has safety lock;press and hold A to pull out button Bat the same time.Trouble shootingSolutionPossible CausesSymptomRemote is non-responsiveRemote control insensitiveIsolation sheet not removedBatter installed incorrectlyDead batteryOutside of effective radiusPress button contact problemInternal circuit damageGroup setting incompatibleOperating environment has too many objectsblock signal (metal closets,concrete wall...)Remove isolation sheetReinstall battery (reverse)Operate within 10 meters of radiusPlease send for repairReset Tube / Bulb groupsPlease send for repairReplace batteryEnsure bulb / driver antenna are not blocked by metalobjectsStorage Method- Product should be stored under normal room temperature- Avoid direct sunlight and waterService LocationPhihong TaiwanNo.568,Fusing 3rd Rd.,Gueishan Township TaoyuanCounty 333,Taiwan,R.O.C.Tel: 886-3-3277288Phihong USACorporate Office47800 Fremont Blvd.Fremont,CA 94538,USATel: 1-510-445-0100www.phihong.com.twwww.phihong.comProduct SpecificationRF Module CharacteristicsNote:Please remove the insulation sheet before use.Insulation sheet
WARNINGS: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.

Navigation menu