PHIHONG TECHNOLOGY CO RCARF Remote Controller User Manual
PHIHONG TECHNOLOGY CO LTD Remote Controller
User Manual
Phihong LED Lighting Remote Control is a RF remote for LED controls. One remote
can easily be used for multiple light fixtures and adjust individually It provides users
effortless upgrade to turn any regular lamp into a wireless controlled lamp
.
.
User s Manual'
- Six group settings for individual control of different rooms
- 5 stages of dimming function setting
.
RF Operating Frequency
Number of controllable groups
Dimension
6 groups
(Length)86.2mm*(Width)33mm*(Thickness)6.5mm
Remote Controls Keys Functions
Up to 180 steps of dimming
ID Setting
- PresetIDis1
- Step by step Setting
Step1:Power on the LED bulbs/tubes to be set up
Step2:Press Set and number key at the same time to complete setting
Step3:Setting is complete,press numbers for lighting control.
Initial use and battery change
- Remove isolation sheet by pulling
- For child safety,this design has safety lock;press and hold A to pull out button B
at the same time.
Trouble shooting
Solution
Possible Causes
Symptom
Remote is non-responsive
Remote control insensitive
Isolation sheet not removed
Batter installed incorrectly
Dead battery
Outside of effective radius
Press button contact problem
Internal circuit damage
Group setting incompatible
Operating environment has too many objects
block signal (metal closets,concrete wall...)
Remove isolation sheet
Reinstall battery (reverse)
Operate within 10 meters of radius
Please send for repair
Reset Tube / Bulb groups
Please send for repair
Replace battery
Ensure bulb / driver antenna are not blocked by metal
objects
Storage Method
- Product should be stored under normal room temperature
- Avoid direct sunlight and water
Service Location
Phihong Taiwan
No.568,Fusing 3rd Rd.,Gueishan Township Taoyuan
County 333,Taiwan,R.O.C.
Tel: 886-3-3277288
Phihong USA
Corporate Office
47800 Fremont Blvd.
Fremont,CA 94538,USA
Tel: 1-510-445-0100
www.phihong.com.tw
www.phihong.com
Product Specification
RF Module Characteristics
Note:Please remove the insulation sheet before use.
Insulation sheet
WARNINGS:
Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.