PHIHONG TECHNOLOGY CO RCARF Remote Controller User Manual
PHIHONG TECHNOLOGY CO LTD Remote Controller
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 2106158 |
| Application ID | etRjiqZ8k6y0w8K0f5luKg== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 244.63kB (3057932 bits) |
| Date Submitted | 2013-10-30 00:00:00 |
| Date Available | 2014-04-28 00:00:00 |
| Creation Date | 2013-10-16 16:35:24 |
| Producing Software | iText 2.1.7 by 1T3XT |
| Document Lastmod | 2013-10-16 16:35:24 |
| Document Title | User Manual |
| Document Creator | pdfsam-console (Ver. 2.4.1e) |
User ' s Manual Remote Controls Keys Functions Trouble shooting Symptom Phihong LED Lighting Remote Control is a RF remote for LED controls. One remote can easily be used for multiple light fixtures and adjust individually . It provides users effortless upgrade to turn any regular lamp into a wireless controlled lamp . Possible Causes Remote is non-responsive Isolation sheet not removed Batter installed incorrectly Up to 180 steps of dimming Solution Remove isolation sheet Reinstall battery (reverse) Dead battery Replace battery Outside of effective radius Operate within 10 meters of radius Press button contact problem Please send for repair Internal circuit damage Please send for repair Group setting incompatible Remote control insensitive Operating environment has too many objects block signal (metal closets,concrete wall...) Reset Tube / Bulb groups Ensure bulb / driver antenna are not blocked by metal objects ID Setting - Preset ID is 1 - Step by step Setting Step1:Power on the LED bulbs/tubes to be set up Step2:Press Set and number key at the same time to complete setting Step3:Setting is complete,press numbers for lighting control. RF Module Characteristics - Six group settings for individual control of different rooms . - 5 stages of dimming function setting Initial use and battery change - Remove isolation sheet by pulling Insulation sheet Note:Please remove the insulation sheet before use. - For child safety,this design has safety lock;press and hold A to pull out button B at the same time. RF Operating Frequency Dimension Service Location Phihong Taiwan No.568,Fusing 3rd Rd.,Gueishan Township Taoyuan County 333,Taiwan,R.O.C. Tel: 886-3-3277288 www.phihong.com.tw Product Specification Number of controllable groups Storage Method - Product should be stored under normal room temperature - Avoid direct sunlight and water 6 groups (Length)86.2mm*(Width)33mm*(Thickness)6.5mm Phihong USA Corporate Office 47800 Fremont Blvd. Fremont,CA 94538,USA Tel: 1-510-445-0100 www.phihong.com WARNINGS: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Page Count : 2 Creator : pdfsam-console (Ver. 2.4.1e) Producer : iText 2.1.7 by 1T3XT Modify Date : 2013:10:16 16:35:24+08:00 Create Date : 2013:10:16 16:35:24+08:00EXIF Metadata provided by EXIF.tools