Panasonic of North America 9TGCF-281 Optional Wireless LAN for Notebook PC User Manual Revised Manual and Statement

Download:
Mirror Download [FCC.gov]
Document ID	232726
Application ID	kIsEES3qz97x66slWWsBXg==
Document Description	Revised Manual and Statement
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	2.87kB (35824 bits)
Date Submitted	2002-03-22 00:00:00
Date Available	2002-03-22 00:00:00
Creation Date	2002-03-18 15:05:08
Producing Software	Acrobat Distiller 4.0 for Windows
Document Lastmod	2002-03-22 13:01:31
Document Title	Revised Manual and Statement

Addendum
This Addendum contains supplementary instructions regarding the use of the computer. It explains the cases where the operation of
the computer differs from that in the OPERATING INSTRUCTIONS and Supplementary Instructions.
For U.S.A.
Federal Communications Commission Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the Panasonic Service Center or an experienced radio/TV technician for help.
Warning
To assure continued compliance, use only shielded interface
cables when connecting to a computer or peripheral. Also, any
changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Responsible Party: Matsushita Electric Corporation of America
One Panasonic Way
Secaucus, NJ 07094
Tel No:1-800-LAPTOP-5
(1-800-527-8675)
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum
distance 20cm between the radiator and your body (excluding
extremities: hands, wrists, and feet) and must not be co-located
or operated with any antenna or transmitter.
FCC Regulation Notice for modem
This equipment contains a FCC approved modem.
Manufacturer of modem: Aztech Labs, Inc.
Model No. MP3930V-W
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
1.This equipment complies with Part 68 of the FCC rules. On the
computer is a label that contains, among other information, the
FCC registration number and ringer equivalence number (REN)
for this equipment. If required, this information must be provided
to the telephone company.
2.An FCC compliant modular plug is provided with this equipment.
This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack which
is Part 68 compliant. See Installation Instructions for details.
3.The REN is used to determine the quantity of devices which may
be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an
incoming call. In most, but not all area, the sum of RENs should
not exceed five (5.0). To be certain of the number of devices that
may be connected to a line, as determined by the total RENs, contact the local telephone company.
4.If your telephone equipment cause harm to the telephone network,
the telephone company will notify you in advice that temporary
discontinuance of service may be required. But if advice notice
isn’t practical, the telephone company will notify the customer as
soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
5.The telephone company may take changes in it’s facilities, equipment, operations or procedures that could affect the operation of
the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.
6.If trouble is experienced with this equipment, for repair or warranty information, please contact Matsushita Electric
Corporation of America, toll free at 1-800-LAPTOP5 (1-800-5278675). If the equipment is causing harm to the telephone network,
the telephone company may request that you disconnect the equipment until the problem is resolved.
7.There are no user serviceable parts contained in this equipment.
8.This equipment may not be used on coin service provided by the
telephone company. Connection to party lines is subject to state
tariffs.
9.The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device to
send any message via a telephone fax machine unless such message clearly contains in a margin at the top or bottom of each
transmitted page or on the first page of the transmission, the date
and time it is sent and an identification of the business or other
entry, or other individual sending the message and the telephone
number of the sending machine or such business, other entity, or
individual. In order to program this information into your fax software, you should refer to the manual of the Fax software being
used.
“Caution : To reduce the risk of fire, use only No.26 AWG or larger telecommunication
line cord.”
“ATTENTION : Pour réduire le risque d’incendie, utiliser uniquement des conducteurs
de télécommunications 26 AWG ou de section supérieure.”
Using Antenna
The following function has been added.
H.O.T. Antenna
Antenna
External Antenna
Connector
Your computer is equipped with a H.O.T. Antenna (High-gain, Omni-directional, Telescopic).
The antenna is retractable into the LCD assembly, and data can be sent and received when
the antenna is extended.
(There is no Wireless LAN antenna in the right side of the computer. This differs from the
illustration in the Supplementary Instructions.)
External Antenna Connector
Your computer is equipped with an external antenna connector. An external antenna (i.e.
mounted on a vehicle) may be connected to provide higher signal strength in fringe or low
signal areas to maximize effective coverage.
CAUTION
Do not apply excessive force to the H.O.T. antenna or external antenna connector. Doing so
could weaken the signal reception strength or damage the antenna or computer.
This device has been designed to operate with an antenna having a maximum gain of 2.14 dBi.
Antenna having a higher gain is strictly prohibited per FCC regulations.
The antenna should be installed by profession or the person under the professional's guidance to
assure proper installation.
FJ0302-0 DFQX1406ZA
Printed in Japan

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Create Date                     : 2002:03:18 15:05:08Z
Modify Date                     : 2002:03:22 13:01:31-07:00
Page Count                      : 2
Creation Date                   : 2002:03:18 15:05:08Z
Producer                        : Acrobat Distiller 4.0 for Windows
Mod Date                        : 2002:03:22 13:01:31-07:00
Metadata Date                   : 2002:03:22 13:01:31-07:00

EXIF Metadata provided by EXIF.tools