Panasonic of North America 9TGWW11A TD-CDMA PCI Express Mini Module User Manual Module Integration guide
Panasonic Corporation of North America TD-CDMA PCI Express Mini Module Module Integration guide
Contents
- 1. User manual - host
- 2. Module Integration guide
- 3. Host User Manual
- 4. Users Manual
Module Integration guide
OEM PCI Express Mini Module Integration OEM PCI Express Mini Module Integration Guide V01.02 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 1 of 10 OEM PCI Express Mini Module Integration Contents General ................................................................................................................ 3 1.1 Approvals and Dates ............................................................................................................... 3 1.2 Change Record ....................................................................................................................... 3 1.3 Acronyms ................................................................................................................................ 4 1.4 External References................................................................................................................ 4 Introduction .......................................................................................................... 5 2.1 Scope of Document................................................................................................................. 5 2.2 Overview of Module ................................................................................................................ 5 Module Connections ............................................................................................ 6 3.1 3.1.1 Universal Serial Bus ........................................................................................................ 6 3.1.2 SIM Interface ................................................................................................................... 6 3.2 Media Independent Interface (J4) ........................................................................................... 6 3.3 RF Connections ...................................................................................................................... 7 3.4 DC Power ................................................................................................................................ 7 Mechanical .......................................................................................................... 8 4.1 PCI Express Mini Interface (J1) .............................................................................................. 6 Thermal Management ............................................................................................................. 8 Regulatory Information ........................................................................................ 9 5.1 Compliance with FCC Rules and Regulations ........................................................................ 9 5.2 Exposure to Radio Frequency Signals.................................................................................... 9 Annex 1: PCI Express Mini Edge Connector Pinout .......................................... 10 Figures Figure 1: MII Interface J4 ........................................................................................................................ 6 Figure 2: RF Connections ....................................................................................................................... 7 Figure 3: PEM Module ............................................................................................................................ 8 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 2 of 10 OEM PCI Express Mini Module Integration 1.1 General Approvals and Dates Approval Date W. J. Jones 1.2 Change Record Date Version Author 20/08/2008 01.00 PFW New Document. 23/10/2008 01.01 PFW Additional details added. 04/03/2009 01.02 PFW Updated PEM Mechanical drawing. 4th March 2009 Reason For Change Issue IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 3 of 10 OEM PCI Express Mini Module Integration 1.3 Acronyms Term Definition MPE Maximum Permissible Exposure OEM Original Equipment Manufacturer PCIe PCI Express PCI SIG PCI Special Interest Group PEM PCI Express Mini SIM Subscriber Identity Module TDD Time Division Duplex UMTS Universal Mobile Telephone System USB Universal Serial Bus 1.4 External References Ref () Number Title FCC Part 27 Miscellaneous Wireless Communications Service PCI SIG PCI Express Base Specification Revision 2.0 PCI SIG Card Electromechanical Specification Revision 2.0 PEM + Adapter Thermal Specification Revision 1.0 Note: Where a reference is undated, the latest version applies unless a specific revision is defined. 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 4 of 10 OEM PCI Express Mini Module Integration Introduction This document describes the method of integrating the IPWireless PCI Express Mini module into an OEM product. 2.1 Scope of Document This document applies to the IPWireless PCI Express Mini module only. 2.2 Overview of Module The IPWireless PCI Express Mini module provides a complete UMTS TDD wireless modem solution and only requires to be inserted in a PCI Express Mini compliant interface and connection of external antennas. The module is designed to minimise the time and resource required to integrate. 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 5 of 10 OEM PCI Express Mini Module Integration Module Connections 3.1 PCI Express Mini Interface (J1) The IPWireless PCI Express Mini module is provided with a 52 pin edge connector for connection to the external application. This connection supports the following interface types and these are described below. The pinout is shown in Annex 1. 3.1.1 Universal Serial Bus The PCI Express edge connector provides a USB 2.0 interface, this interface supports low speed (1.5Mbps), full speed (12Mbps) and High speed (480Mbps) operation. 3.1.2 SIM Interface The PCI Express edge connector provides a 4 line SIM interface to allow use with Subscriber Identity Modules if required, this interface supports both 1.8V and 3.0V SIM’s. The SIM interface does not provide ESD protection and this should be provided by the host device. 3.2 Media Independent Interface (J4) The IPWireless PCI Express Mini module also provides a Media Independent Interface, this is a separate interface and is used only with the IPWireless PEM Adapter Board. Figure 1: MII Interface J4 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 6 of 10 OEM PCI Express Mini Module Integration 3.3 RF Connections The IPWireless PCI Express Mini module provides two RF connections for external antennas. The main port must be connected, the diversity port may or may not be connected depending upon application. The connector type is the Hirose U.FL series. Figure 2: RF Connections 3.4 DC Power The module requires a DC supply of between 3.0V to 3.6VDC with the nominal voltage being 3.3VDC, maximum input current is 950mA at 3.3VDC. DC power is applied to the module via the PCI Express Mini edge connector. 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 7 of 10 OEM PCI Express Mini Module Integration Mechanical The IPWireless PCI Express Mini module is designed to be installed in a PCI Express compliant slot capable of holding an F1 full size mini card. Figure 3: PEM Module 4.1 Thermal Management The PCI Express Mini module integration shall be in accordance with the PCISIG thermal requirements. 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 8 of 10 OEM PCI Express Mini Module Integration 5.1 Regulatory Information Compliance with FCC Rules and Regulations The IPWireless PCI Express Mini module is certified against FCC Part 27 for operation in the 24962690MHz frequency allocation. The module is certified under FCC ID: PKTPEMAAU1 and is only certified for use with external antennas, the maximum antenna gain allowed is defined on the FCC Grant of Certification. If the FCC ID label is not visible from outside of the host device, then an additional label is required on the outside of the host device stating ‘Contains FCC ID: PKTPEMAAU1’ IMPORTANT: Manufacturers of devices containing the IPWireless PCI Express Mini module are advised to. 1. Clarify any regulatory questions, particularly if the host device contains other radio transceivers. 2. Have their final product tested and approved for FCC compliance. 3. Include instructions with the final product regarding meeting RF Exposure requirements of the FCC rules. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not covered in this document must be approved in writing by the IPWireless. Changes or modifications made without written approval may void the user’s authority to operate this equipment. 5.2 Exposure to Radio Frequency Signals To comply with the FCC RF exposure rules, the UE PCI Express Mini module has been evaluated against the Maximum Permissible Exposure (MPE) limits defined in Section 1.1310 of the FCC rules for the uncontrolled environment. During normal operation, all persons should maintain a distance of at least 20cm from the antenna to ensure compliance with the MPE limits. If after module integration, the user will be less than 20cm from the antennas additional RF exposure assessment will be required. 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 9 of 10 OEM PCI Express Mini Module Integration Annex 1: PCI Express Mini Edge Connector Pinout Pin Name Pin Name 51 Reserved 52 +3.3Vaux 49 Reserved 50 GND 47 Reserved 48 +1.5V 45 Reserved 46 LED_WPAN# 43 GND 44 LED_WLAN# 41 +3.3Vaux 42 LED_WWAN# 39 +3.3Vaux 40 GND 37 GND 38 USB_D+ 35 GND 36 USB_D‐ 33 PETp0 34 GND 31 PETn0 32 SMB_DATA 29 GND 30 SMB_CLK 27 GND 28 +1.5V 25 PERp0 26 GND 23 PERn0 24 +3.3Vaux 21 GND 22 PERST# 19 Reserved 20 W_DISABLE# 17 Reserved 18 GND Mechanical Key 15 GND 16 UIM_VPP 13 REFCLK+ 14 UIM_RESET 11 REFCLK‐ 12 UIM_CLK GND 10 UIM_DATA CLKREQ# UIM_PWR COEX2 +1.5V COEX1 GND WAKE# +3.3Vaux Key Used on PEM Unused 4th March 2009 IPWireless Proprietary and Confidential Subject to Non Disclosure Agreement Page 10 of 10
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39 Producer : Acrobat Distiller 8.1.0 (Windows) Company : IPWireless Source Modified : D:20090819074301 Create Date : 2009:08:19 11:09:14+01:00 Creator Tool : Acrobat PDFMaker 8.1 for Word Modify Date : 2009:08:19 11:09:24+01:00 Metadata Date : 2009:08:19 11:09:24+01:00 Document ID : uuid:19d79fd5-6433-4ce1-b287-52e3e7568c1f Instance ID : uuid:8254fac4-e401-4367-8889-9ad6d6d7a2cb Subject : 38 Format : application/pdf Creator : pwarburg Title : Page Count : 10 Page Layout : OneColumn Author : pwarburgEXIF Metadata provided by EXIF.tools