Panasonic of North America RM433V2 RFID Gateway User Manual User Guide

Omni-ID USA Inc. RFID Gateway User Guide

User Guide

433 MHz Radio Module User Guide Omni-ID office locations: US | UK | China | India | Southeast Asia
DO000720-A 433 MHz Radio Module Use Guide -1- CONTENTS 1. Introduction ........................................................................................................................................................................ 2 Module Block diagram............................................................................................................................................................. 2 Regulatory Approvals .............................................................................................................................................................. 3 2. Specifications ...................................................................................................................................................................... 4 RM433V2 Specifications .......................................................................................................................................................... 4 3. Pin configurations ............................................................................................................................................................... 5 pin assignments ....................................................................................................................................................................... 5 pin descriptions ....................................................................................................................................................................... 6 4. electrical characteristics ...................................................................................................................................................... 7 Maximum ratings .................................................................................................................................................................... 7 operating conditions ............................................................................................................................................................... 7 5. Appendix A Additional information .................................................................................................................................... 8 Module drawing ...................................................................................................................................................................... 8 Federal communications commision interference statement ................................................................................................ 9 antennas approved by fcc for use with RM433V2 module ..................................................................................................... 9 fcc end product labelling ......................................................................................................................................................... 9 industry canada statement ................................................................................................................................................... 10 industry canada end product labelling .................................................................................................................................. 10 european r&tte directive 1999/5/ec statement ................................................................................................................... 10 rohs compliance .................................................................................................................................................................... 10 disclaimers ............................................................................................................................................................................. 10 Customer Support ................................................................................................................................................................. 11
DO000720-A 433 MHz Radio Module Use Guide -2- 1. INTRODUCTION The RM433V2 radio module is a compact easy to use module to add Omni-ID proprietary RF functionality to any device. The module is targeted at development partners who need to add RF functionality to a device that will be used as part of an Omni-ID Proview system. The RM433V2 removes the need for expensive and lengthy development of custom RF board designs requiring expensive agency certifications. MODULE BLOCK DIAGRAM
DO000720-A 433 MHz Radio Module Use Guide -3- REGULATORY APPROVALS The RM433V2 has been tested against the requirements of the following European standards. • Radio EN 300 328 v1.7.1. • EMC, EN 301 489-17 v2.1.1 • Basic Safety Assessment (BSA) EN 60950-1:2006 Additionally, the module has received FCC “Modular Approval”, in compliance with CFR 47 FCC part 15 regulations and in accordance to FCC Public notice DA00-1407. Appendix XX contains details on the conditions applying to this modular approval. The module is approved for use with a range of different antennas; further details of which can be found in section Appendix YY. The modular approval notice and test reports are available on request. The RM433V2 module is also compliant with Industry Canada RSS210 (Issue 8, Annex 8) and have Industry Canada modular approval.
DO000720-A 433 MHz Radio Module Use Guide -4- 2. SPECIFICATIONS RM433V2 SPECIFICATIONS Typical DC Characteristics Notes Radio Transmit Current 20 mA Radio Receive Current 20 mA Center Frequency Accuracy +/- 10ppm over temperature Additional +/- 3 ppm ageing Typical RF Characteristics Notes Rx Sensitivity -100 dBm Nominal for .1% BER Tx Power +5dBm 433.164 – 434.784 MHz Max. Input Signal 10 dBm RSSI Range -100 to -10 dBm RF Port Impedance 50 ohms 433.164 – 434.784 MHz Rx Spurious Emissions TBD Conducted into 50ohms Tx Spurious Emissions TBD Conducted into 50ohms VSWR (max) 2:1 433.164 – 434.784 MHz Mechanical Characteristics Notes Dimensions (mm) 41.91 x 31.75 Dimensions (in) 1.65 x 1.25
DO000720-A 433 MHz Radio Module Use Guide -5- 3. PIN CONFIGURATIONS PIN ASSIGNMENTS
DO000720-A 433 MHz Radio Module Use Guide -6- PIN DESCRIPTIONS Pin No Pin Function Signal Type Description 1 GND 0V Digital Ground 2 RFGDO1 CMOS RF Test Pin 3 RFDGO0 CMOS RF Test Pin 4 RFGDO2 CMOS RF Test Pin 5 RM MISO CMOS SPI Master In Slave Out 6 RM MOSI CMOS SPI Slave Master Out Slave In Input 7 RM SCLK CMOS SPI Master Clock Output 8 GND 0V Digital Ground 9 RXD CMOS UART RX 10 TXD CMOS UART TX 11 RM_CS CMOS SPI Module Select line 12 GND 0V Digital Ground 13 TX_IN_PROGRESS CMOS Radio transmitting a packet 14 CONFIG_MOD CMOS Enable Module Configuration mode 15 MSG_PENDING CMOS Receive Message Pending 16 RX_IN_PROGRESS CMOS Radio receiving a packet 17 GND 0V Digital Ground 18 RST CMOS Reset Input 19 TEST CMOS JTAG Test Input 20 TCK CMOS JTAG CLK Input 21 TMS CMOS JTAG Mode Select Input 22 TDI CMOS JTAG Data Input 23 TDO CMOS JTAG Data Output 24 GND 0V Digital Ground 25 PWR_OFF CMOS Module Power Enable Input 26 VIN 3.4V-5.0V Supply Voltage 27 VIN 3.4V-5.0V Supply Voltage 28 GND 0V Digital Ground 29 GND 0V Digital Ground 30 GND 0V Digital Ground
DO000720-A 433 MHz Radio Module Use Guide -7- 4. ELECTRICAL CHARACTERISTICS MAXIMUM RATINGS Exceeding these conditions will result in damage to the device. Parameter Min Max Device Supply Voltage -0.3V 5.0V All Pins -0.3V 3.3V Storage Temperature -40⁰C 85⁰C OPERATING CONDITIONS Supply Min Max VIN 3.4V 5.0V Ambient Temperature Range -40⁰C 85⁰C
DO000720-A 433 MHz Radio Module Use Guide -8- 5. APPENDIX A ADDITIONAL INFORMATION MODULE DRAWING
DO000720-A 433 MHz Radio Module Use Guide -9- FEDERAL COMMUNICATIONS COMMISION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. ANTENNAS APPROVED BY FCC FOR USE WITH RM433V2 MODULE Brand Model Number Description Gain (dBi) 1 COMTELCO BS450S-B Vertical Base Station Antenna 4.65 2 COMTELCO Y2243-B YAGI ANTENNA 9.15 3 Antenna Factor ANT-433-CW-RH Helical Whip Antenna -5.6 4 Antenna Factor ANT-433-MHW-SMA Dipole Antenna 1.2 5 Omni-ID, Inc. CP10636 Horizontal Polarized Dipole Antenna 2.15 FCC END PRODUCT LABELLING The final ‘end product’ should be labelled in a visible area with the following: “Contains TX FCC ID: N74-RM433V2”
DO000720-A 433 MHz Radio Module Use Guide -10- INDUSTRY CANADA STATEMENT This device complies with Industry Canada license- exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropic radiated power (e.i.r.p.) is not more than that permitted for successful communication. INDUSTRY CANADA END PRODUCT LABELLING For end devices that will be sold or used in Canada the following text should appear on the product label. “Contains Industry Canada ID IC: 10336A-RM433V2” EUROPEAN R&TTE DIRECTIVE 1999/5/EC STATEMENT The RM433V2 module listed in this datasheet is compliant with ETSI EN 300 328 V1.7.1 (2006-10), EMC, EN 301 489-17 v2.1.1 (2009-02) and the Basic Safety Assessment (BSA) EN 60950-1:2006 (2006-06) and is subject to a Notified Body Opinion. The modules are approved for use with the antennas listed in the following table. Brand Model Number Description Gain (dBi) 1 COMTELCO BS450S-B Vertical Base Station Antenna 4.65 2 COMTELCO Y2243-B YAGI ANTENNA 9.15 3 Antenna Factor ANT-433-CW-RH Helical Whip Antenna -5.6 4 Antenna Factor ANT-433-MHW-SMA Dipole Antenna 1.2 5 Omni-ID, Inc. CP10636 Horizontal Polarized Dipole Antenna 2.15 ROHS COMPLIANCE The RM433V2 module meets the requirements of Directive 2002/95/EC of the European Parliament and of the Council on the Restriction of Hazardous Substance (RoHS). DISCLAIMERS The contents of this document are subject to change without notice. OMNI-ID, inc. reserves the right to make changes, without notice, in the products, including circuits and/or software, described or contained therein. Information contained in this document regarding device applications and the like is intended through suggestion only and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications.
DO000720-A 433 MHz Radio Module Use Guide -11- CUSTOMER SUPPORT Information about Omni-ID’s complete line of RFID products can be found on our website: www.omni-id.com. Additional support is available by phone: +1 (585) 713-1000 or email: support@omni-id.com.

Navigation menu