Paradox Security Systems NV75MR Indoor Wireless PIR detector with Anti Mask and Pet Immunity User Manual NV75MR EI00

Paradox Security Systems Indoor Wireless PIR detector with Anti Mask and Pet Immunity NV75MR EI00

Users Manual

NV75MR-EI00/c 12/2016paradox.comNV75MRInstallation Manual V1.0Wireless16 Meter Indoor Dual Mironel Optics, Anti-Mask, Pet Immunity Dual DetectorGeneral DescriptionThe NV75MR is an indoor industry-leading wireless detector providing superior 16 meter detection with rock solid stability thanks to the revolutionary dual Mironel Mirror/Fresnel PIR optics. Combined with Paradox true Pet Immunity and best-in-the industry active Anti-Mask technology (EN Grade 3). The NV75MR provides an unmatched high security solution for any indoor installation. Please ReadInstalling the NV75MR (Step 1)Installation Height:Pet Immune ON - 2.0m/6.6ft to 2.4m/7.8ftPet Immune OFF - 2.0m/6.6ft to 2.8m/9ft (lever down)**For installations higher than 2.6m, when needed, tilt the detector down a few degrees for best detection results; use of a bracket is recommended.Power Up (30 sec.):Powering up the detector takes about 30 seconds, indicated with green/red flashing; indicates PIR stabilizing.Anti-Mask Calibration: Once detector is stabilized, as mentioned above, open and close the tamper to initiate. Anti-Mask calibration may take up to 60 seconds. Keep away from the detector, at least 2 meters / 6 feet during calibration, indicated by flashing green/red LED. Once completed, the detector is ready.Note: Do not block the detector’s field of view.Table 1Step 3Wall MountBracket Mount Note: Use of a bracket reduces the detector’s security grade to 1.Creep Zone/Pet SelectionRemove detector assembly as described in Step 1. When selector is UP, Pet Mode; when DOWN, Creep Zone is active and there is no Pet Immunity. Above 2.4m Pet Immune should be OFF (lever down Pet OFF, see installation height note*.12 3 4ONCover TamperStep 1DIP Switch(Table 1)PIR SENSITIVITYBattery Tab11m16m13m7m9mStep 2OFF ON1 - LED OFF ON2 - EDGE DUAL SINGLE3 - PET IMM. OFF ON4 - MHz 868 MHz 433 MHzWall Mount x6Bracket Adjustment Screw OpeningCorner Mount x4Tamp e r S c rew Wall/Corner 12345UP - Pet DOWN - Creep
NV75MR-EI00/c 12/2016paradox.comLED DisplayBeam PatternsTop View Side View Technical SpecificationsFeature LED Status IndicatorTamper open Green: ON for 0.3 seconds every 30 seconds PIR sensitivity level settingGreen: Flashes 1-5 times according to the selected levelAlarm detection Red: ON for 3 secondsBooting/Tamper closeGreen/Red alternating flashesfor 45 secondsAnti-mask detection Flashes orange rapidly (pre-alarm state) and then flashes when in alarm.10m 16m(52 ft)90˚2m2m 4m4m 6m6m 8m8m 12m 14m14m 10m12m16m(52 ft) 1.5mCreep Zone1.5mCreep Zone0m60 cm10m5.5m3m1.5mCreep Zone16m(52 ft)60cm 12mDetector 1 Detector 2Both Detectors2.1mOptimal 2.8m 2.4mPet Immune ON Pet Immune OFF3m1.5mCreepZonep60cmDetector Both Detectors2.1mOptimal 2.8m 2.4m2.1m 2.8m 2.4m2.1mOptimal 2.8m 2.4m* Read installation height note*Specification DescriptionIR Movement Detection2 detectors, 2 dual element sensors, 2 Mironel OpticsOptics Two Mironel Mirror/W Fresnel optics with mechanical Pet / Creep ZoneCoverage 16 meters/52 feet; 90° - complies with EN50131-2-2 Grade 3Anti-Masking Active IR with Dual detectors, blocking items up to 30cm and lens applied materials including clear lacquer; meets and exceeds EN50131-2-2 Grade 3Pet Immunity Pet up to 50cm will not be detectedSingle/Dual EdgeInfrared detection requires entry or exit in single-mode; in Dual-edge, entry and exit is required for both detectorsCreep Zone Mechanically selectable Creep Zone detection 1.5m/4ft. (cancels Pet Immunity when active)Power Input 2 x 1.5 AA Alkaline batteries, up to 3 years for normal use with Active Anti-Mask detectionCurrent ConsumptionStandby: 158uA, Max.: 18.3mA Low Battery 2.2VFrequency 433 or 868 MHz, internally selectableOperating Temperature -35º to 50º C (-31º to 122º F)Relative humidity95% non-condensingTamper Dual - Cover and WallDimensions 128 x 62 x 54 mm/ 5.1 x 2.4 x2.1 inWeight 120 gr/ 0.3 lb160 gr / 0.4 lb (with batteries)Certifications CE, EN50131-2-2 Grade 2, Class II, EN 50131-6 Type CWarrantyFor complete warranty information on this product, please refer to the Limited Warranty Statement is found on the website: www.paradox.com/terms or contact your local distributor. Specifications may change without prior notice.PatentsUS, Canadian and international patents may apply. Paradox is a trademark or registered trademark of Paradox Security Systems
NV75MR-EI00/c 12/2016paradox.comFCC and Industry Canada Compliance StatementThis device complies with FCC Rules Part 15 and with Industry Canada license exempt RSS standard(s). Operation is subject to two conditions:1.This device may not cause harmful interference2.This device must accept any interference that may be received or that may cause undesired operation.Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditionssuivantes :1.l'appareil ne doit pas produire de brouillage, et2.l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement.FCC ID: KDYNV75MRIC: 2438A-NV75MRFCC WARNINGThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interferenceto radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment into an outlet different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.Changes or modifications to this equipment not expressly approved by the party responsible for compliance (Paradox Security Systems Ltd.) could void the user'sauthority to operate the equipment.

Navigation menu