ProtoCom_ProtoCom Lon User Manual V.1.02 Proto Com And BACnet Works Protocol Gateway For Shark Nexus Meters E204701
User Manual: Pdf BACnet or LonWorks Converter for Electro Industries Power Meters
Open the PDF directly: View PDF
Page Count: 104 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Customer Service and Support
- Product Warranty
- Use Of Product for Protection
- Disclaimer
- Safety Symbols
- UL Compliance
- About Electro Industries/GaugeTech (EIG)
- Revision History
- Table of Contents
- 1: Introduction to the ProtoCom/ ProtoCom-Lon
- 1.1: Overview of the ProtoCom/ProtoCom-Lon Gateway
- 1.2: EIG Devices and Available Point Count
- 1.3: Specifications
- 1.4: ProtoCom/ProtoCom-Lon Dimensions
- 1.5: Electrical Connections
- 1.6: Use of DIP Switches
- 1.7: Removing the Top Cover from the ProtoCom/ProtoCom-Lon (ONLY if Necessary)
- 1.7.1: Replacing the Top Cover
- 1.8: Graphical User Interface (GUI) Configurator
- 1.9: ProtoCom/ProtoCom-Lon Installation
- 1.9.1: Mounting on a DIN Rail
- 1.9.2: Mounting on a Panel
- 1.10: Navigating This Manual
- 2: Using the ProtoCom/ProtoCom-Lon
- 2.1: Step One - Configure Modbus Communication Settings
- 2.2: Step Two - Select the Desired Field BAS Protocol (ProtoCom only)
- 2.3: Step Three - Enable Auto-discovery
- 2.4: Step Four - Set MAC Address/Device Instance/Node-ID (Proto- Com only)
- 2.4.1: Set MAC Address - for BACnet MS/TP Protocol Only
- 2.4.2: Set the Device Instance - for BACnet MS/TP and BACnet/IP Protocols
- 2.4.2.1 : Change Node_Offset Value
- 2.4.3 : Device Node-ID for Metasys N2, Modbus/TCP, and DF1 Protocols
- 2.5 : Step 5: Set the Baud Rate for BACnet MS/TP and DF1 Protocols
- 2.6: Step 6 - Connect the ProtoCom/ProtoCom-Lon to the Meter
- 2.6.1: Biasing the Modbus RS485 Network (only if necessary)
- 2.6.2: Set End of Line Termination Switch for the Modbus RS485 Port (only if necessary)
- 2.7: Step 7 - Connect to the RS485/LonWorks Network (BACnet MS/TP, Metasys N2, DF1, or LonWorks)
- 2.8: Step 8 - Connect Power to the ProtoCom/ProtoCom-Lon
- 2.9: Step 9 - Turn Off Auto-discovery After Completion to Save Configuration
- 2.10: Step 10: Additional Configuration
- 2.10.1: Use the Web GUI to Configure IP Address for BACnet IP and EtherNet/IP
- 2.10.2: Set Up a Password
- 2.10.3: Configure the ProtoCom-Lon
- 2.11: Step 11 - Use the CAS BACnet Explorer to Validate the ProtoCom in the Field (BACnet MS/TP or BACnet/IP)
- 2.11.1: CAS BACnet Setup
- 3: Device Communication
- A: Protocol Data Points for EIG Meters
- B: MAC Address DIP Switch Settings