ZedBoard_HW_Users_Guide Zed Board User's Guide

• 1 Introduction
  • 1.1 Zynq Bank Pin Assignments
• 2 Functional Description
  • 2.1 All Programmable SoC
  • 2.2 Memory
    • 2.2.1 DDR3
    • 2.2.2 SPI Flash
    • 2.2.3 SD Card Interface
  • 2.3 USB
    • 2.3.1 USB OTG
    • 2.3.2 USB-to-UART Bridge
    • 2.3.3 USB-JTAG
    • 2.3.4 USB circuit protection
  • 2.4 Display and Audio
    • 2.4.1 HDMI Output
    • 2.4.2 VGA Connector
    • 2.4.3 I2S Audio Codec
    • 2.4.4 OLED
  • 2.5 Clock sources
  • 2.6 Reset Sources
    • 2.6.1 Power‐on Reset (PS_POR_B)
    • 2.6.2 Program Push Button Switch
    • 2.6.3 Processor Subsystem Reset
  • 2.7 User I/O
    • 2.7.1 User Push Buttons
    • 2.7.2 User DIP Switches
    • 2.7.3 User LEDs
  • 2.8 10/100/1000 Ethernet PHY
  • 2.9 Expansion Headers
    • 2.9.1 LPC FMC Connector
    • 2.9.2 Digilent Pmod™ Compatible Headers (2x6)
    • 2.9.3 Agile Mixed Signaling (AMS) Connector, J2
  • 2.10 Configuration Modes
    • 2.10.1 JTAG
  • 2.11 Power
    • 2.11.1 Primary Power Input
    • 2.11.2 On/Off Switch
    • 2.11.3 Regulators
    • 2.11.4 Sequencing
    • 2.11.5 Power Good LED
    • 2.11.6 Power Estimation
    • 2.11.7 Testing
    • 2.11.8 Probes
• 3 Zynq-7000 AP SoC Banks
  • 3.1 Zynq-7000 AP SoC Bank Voltages
• 4 Jumper Settings
• 5 Mechanical
• 6 Revision History