ProSoft Technology IHW Mini PCI WLAN Transmitter Module User Manual RLX IHW OEM updated manual

ProSoft Technology, Inc Mini PCI WLAN Transmitter Module RLX IHW OEM updated manual

Users Manual

RLX-IHW-OEM Industrial Hotspot 802.11a, b, g User Guide September 06, 2007
Contents RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot ProSoft Technology, Inc. Page 2 of 6 September 6, 2007 Compliance Statement The following statements must be included in the product documentation for the end device in which the radio module is embedded: *This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. CAUTION: Changes or modifications to this radio module not expressly approved by its manufacturer may void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Product Labeling This radio module is labeled with an FCC ID number and a Canadian Certification Number. If this label is not visible when installed in an end-device, the outside of the device MUST also display a label referring to the enclosed radio module. Use wording on the label similar to the following: "Transmitter Module FCC ID: OQ7IHW, Canada 3656AIHW". OR "This device contains Transmitter Module FCC ID: OQ7IHW, Canada 3656AIHW" Radio Frequency Interference Requirements For the channels in the frequency band 5.15 to 5.25 GHz operation is limited to indoor use only due to FCC and Canada requirements. Antenna spacing requirements for user safety
Contents RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot ProSoft Technology, Inc. Page 3 of 6 September 6, 2007 It is important to keep the radio’s antenna a safe distance from the user. To meet the requirements of FCC part 2.1091 for radio frequency radiation exposure, the following information must be provided to the end user: “In order too comply with FCC RF exposure requirements, this device must be operated in such a way that a minimum 20cm separation distance is maintained between the antenna, and all persons, during normal operation.” The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF fields in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for successful communication. Approved Antennas Two antenna port connections (for diversity) are provided. The radio uses SMT Ultra Miniature Coax Connector, Hirose, CL331-0471-0-10 (U.FL-R-SMT). An adaptor cable or interface board is used to connect to the approved antennas. The following antennas are approved for use with this module: Frequency Bands Type Gain Connector Freq Part# Omni 2 SMA-RP 2.4,5.2,5.8 A2505S-OA Omni 2 F-RP 2.4,5.2,5.8 - Omni 2 RP-SMA 2.4 A2402S-OA Omni 2 RP-SMA 2.4 A2402S-OS Omni 2 RP-SMA 2.4 A2402S-OSLP Omni 3 N 2.4 A2403NJ-OCD Omni 4 N 2.4 A2404NBHB-O Omni 4 N 2.4 A2404NBHW-O Omni 4 N 2.4 A2404NJ-OC Omni 5 RP-SMA 2.4 A2405S-OA Omni 5 RP-SMA 2.4 A2405S-OM Omni 5 RP-SMA 2.4 A2405S-OS Omni 6 N 2.4 A2406NJ-OC Omni 6 N 2.4 A2406NJ-OCD Omni 6 N 5.8 A5006NJ-OC Omni 6,8 N 2.4,5.8 A2506NJ-OC Patch 8 N 2.4 A2408NJ-DP Patch 8,9 N 2.4,5.8 A2508NJ-DP Parabolic 29 N 5.8 A5829NJ-DB
Contents RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot ProSoft Technology, Inc. Page 4 of 6 September 6, 2007 Installation The Radiolinx IHW-OEM module fits into a MiniPCI connector. The diagram below shows the dimensions of a MiniPCI TypeIIIA card. The diagram below shows inseration and removal of the Mini-PCI card. Digital connection is through Mini PCI type III defined by the Mini PCI Specification document published by the PCI Special Interest Group. As a recommendation, the Molex 67315-0011 can be used. Pin Signal Pin Signal Pin Signal Pin Signal
Contents RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot ProSoft Technology, Inc. Page 5 of 6 September 6, 2007 1 TIP 2 RING 63 3.3V 64 FRAME# Key Key 3 8PMJ-33, 4 4 8PMJ-13, 4 65 CLKRUN# 66 TRDY# 5 8PMJ-63, 4 6 8PMJ-23, 4 67 SERR# 68 STOP# 7 8PMJ-73, 4 8 8PMJ-43, 4 69 GROUND 70 3.3V 9 8PMJ-83, 4 10 8PMJ-53, 4 71 PERR# 72 DEVSEL# 11 LED1_GRNP 12 LED2_YELP 73 C/BE[1]# 74 GROUND 13 LED1_GRNN 14 LED2_YELN 75 AD[14] 76 AD[15] 15 CHSGND 16 RESERVED 77 GROUND 78 AD[13] 17 INTB# 18 5V 79 AD[12] 80 AD[11] 19 3.3V 20 INTA# 81 AD[10] 82 GROUND 21 RESERVED 22 RESERVED 83 GROUND 84 AD[09] 23 GROUND 24 3.3VAUX 85 AD[08] 86 C/BE[0]# 25 CLK 26 RST# 87 AD[07] 88 3.3V 27 GROUND 28 3.3V 89 3.3V 90 AD[06] 29 REQ# 30 GNT# 91 AD[05] 92 AD[04] 31 3.3V 32 GROUND 93 RESERVED 94 AD[02] 33 AD[31] 34 PME# 95 AD[03] 96 AD[00] 35 AD[29] 36 RESERVED 97 5V 98 RESERVED_WIP5 37 GROUND 38 AD[30] 99 AD[01] 100 RESERVED_WIP5 39 AD[27] 40 3.3V 101 GROUND 102 GROUND 41 AD[25] 42 AD[28] 103 AC_SYNC 104 M66EN 43 RESERVED 44 AD[26] 105 AC_SDATA_IN 106 AC_SDATA_OUT 45 C/BE[3]# 46 AD[24] 107 AC_BIT_CLK 108 AC_CODEC_ID0# 47 AD[23] 48 IDSEL 109 AC_CODEC_ID1# 110 AC_RESET# 49 GROUND 50 GROUND 111 MOD_AUDIO_MON 112 RESERVED 51 AD[21] 52 AD[22] 113 AUDIO_GND 114 GROUND 53 AD[19] 54 AD[20] 115 SYS_AUDIO_OUT 116 SYS_AUDIO_IN 55 GROUND 56 PAR 117 SYS_AUDIO_OUT GND 118 SYS_AUDIO_IN GND 57 AD[17] 58 AD[18] 119 AUDIO_GND 120 AUDIO_GND 59 C/BE[2]# 60 AD[16] 121 RESERVED 122 MPCIACT# 61 IRDY# 62 GROUND 123 VCC5VA 124 3.3VAUX The signal CHSGND is a chassis ground contact and is connected on the Mini PCI Card via a spring contact clip. Technical Specifications Radio Technology IEEE 802.11 a\b\g Turbo (DSSS and OFDM) Operating Frequency 2412-2484 MHz and 4900-5900 MHz Modulation Schemes OFDM with BPSK, QPSK, 16QAM, 64QAM DSSS: DBPSK, DQPSK, CCK RF Channel Availability United States: 11 channels (2412 to 2462 MHz) Europe: 13 channels (2412 to 2472 MHz) Japan:13 channels (2412 to 2472 MHz); channel 14 (2484 MHz) United States: 12 channels (5180 to 5805 MHz)
Contents RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot ProSoft Technology, Inc. Page 6 of 6 September 6, 2007 Europe: 12 channels (5180 to 5805 MHz) Japan:11 channels (4920 to 5230 MHz) Data Rate OFDM: 54,36,24,18,12,9 and 6 Mbps CCK: 11 and 5.5 Mbps QPSK: 2 Mbps BPSK: 1 Mbps Media Access Protocol CSMA/CA with ACK Transmitter RF Output Power <20 dBm EIRP (typical) including antenna gain Operating Voltage 3.3 Vdc (mini PCI slot of host computer) Interface PC Card mini PCI Device Driver Microsoft Windows 98SE/ME/NT/2000/XP Copyright Copyright © ProSoft Technology, Inc. 2000 - 2007. All Rights Reserved. RLX-IHW-OEM User Guide September 06, 2007

Navigation menu