ProSoft Technology IHW Mini PCI WLAN Transmitter Module User Manual RLX IHW OEM updated manual
ProSoft Technology, Inc Mini PCI WLAN Transmitter Module RLX IHW OEM updated manual
Users Manual
RLX-IHW-OEM Industrial Hotspot 802.11a, b, g User Guide September 06, 2007 Contents RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot Compliance Statement The following statements must be included in the product documentation for the end device in which the radio module is embedded: *This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. CAUTION: Changes or modifications to this radio module not expressly approved by its manufacturer may void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Product Labeling This radio module is labeled with an FCC ID number and a Canadian Certification Number. If this label is not visible when installed in an end-device, the outside of the device MUST also display a label referring to the enclosed radio module. Use wording on the label similar to the following: "Transmitter Module FCC ID: OQ7IHW, Canada 3656AIHW". OR "This device contains Transmitter Module FCC ID: OQ7IHW, Canada 3656AIHW" Radio Frequency Interference Requirements For the channels in the frequency band 5.15 to 5.25 GHz operation is limited to indoor use only due to FCC and Canada requirements. Antenna spacing requirements for user safety ProSoft Technology, Inc. September 6, 2007 Page 2 of 6 Contents RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot It is important to keep the radio’s antenna a safe distance from the user. To meet the requirements of FCC part 2.1091 for radio frequency radiation exposure, the following information must be provided to the end user: “In order too comply with FCC RF exposure requirements, this device must be operated in such a way that a minimum 20cm separation distance is maintained between the antenna, and all persons, during normal operation.” The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF fields in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for successful communication. Approved Antennas Two antenna port connections (for diversity) are provided. The radio uses SMT Ultra Miniature Coax Connector, Hirose, CL331-0471-0-10 (U.FL-R-SMT). An adaptor cable or interface board is used to connect to the approved antennas. The following antennas are approved for use with this module: Frequency Bands Type Omni Omni Omni Omni Omni Omni Omni Omni Omni Omni Omni Omni Omni Omni Omni Omni Patch Patch Parabolic Gain 6,8 8,9 29 ProSoft Technology, Inc. September 6, 2007 Connector SMA-RP F-RP RP-SMA RP-SMA RP-SMA RP-SMA RP-SMA RP-SMA Freq 2.4,5.2,5.8 2.4,5.2,5.8 2.4 2.4 2.4 2.4 2.4 2.4 2.4 2.4 2.4 2.4 2.4 2.4 5.8 2.4,5.8 2.4 2.4,5.8 5.8 Part# A2505S-OA A2402S-OA A2402S-OS A2402S-OSLP A2403NJ-OCD A2404NBHB-O A2404NBHW-O A2404NJ-OC A2405S-OA A2405S-OM A2405S-OS A2406NJ-OC A2406NJ-OCD A5006NJ-OC A2506NJ-OC A2408NJ-DP A2508NJ-DP A5829NJ-DB Page 3 of 6 Contents RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot Installation The Radiolinx IHW-OEM module fits into a MiniPCI connector. The diagram below shows the dimensions of a MiniPCI TypeIIIA card. The diagram below shows inseration and removal of the Mini-PCI card. Digital connection is through Mini PCI type III defined by the Mini PCI Specification document published by the PCI Special Interest Group. As a recommendation, the Molex 67315-0011 can be used. Pin Signal Pin Signal Pin Signal Pin Signal ProSoft Technology, Inc. September 6, 2007 Page 4 of 6 Contents 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 45 47 49 51 53 55 RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot TIP Key 8PMJ-33, 4 8PMJ-63, 4 8PMJ-73, 4 8PMJ-83, 4 LED1_GRNP LED1_GRNN CHSGND INTB# 3.3V RESERVED GROUND CLK GROUND REQ# 3.3V AD[31] AD[29] GROUND AD[27] AD[25] RESERVED C/BE[3]# AD[23] GROUND AD[21] AD[19] GROUND 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 46 48 50 52 54 56 RING Key 8PMJ-13, 4 8PMJ-23, 4 8PMJ-43, 4 8PMJ-53, 4 LED2_YELP LED2_YELN RESERVED 5V INTA# RESERVED 3.3VAUX RST# 3.3V GNT# GROUND PME# RESERVED AD[30] 3.3V AD[28] AD[26] AD[24] IDSEL GROUND AD[22] AD[20] PAR 63 3.3V 64 FRAME# 65 67 69 71 73 75 77 79 81 83 85 87 89 91 93 95 97 99 101 103 105 107 109 111 113 115 117 CLKRUN# 66 TRDY# SERR# 68 STOP# GROUND 70 3.3V PERR# 72 DEVSEL# C/BE[1]# 74 GROUND AD[14] 76 AD[15] GROUND 78 AD[13] AD[12] 80 AD[11] AD[10] 82 GROUND GROUND 84 AD[09] AD[08] 86 C/BE[0]# AD[07] 88 3.3V 3.3V 90 AD[06] AD[05] 92 AD[04] RESERVED 94 AD[02] AD[03] 96 AD[00] 5V 98 RESERVED_WIP5 AD[01] 100 RESERVED_WIP5 GROUND 102 GROUND AC_SYNC 104 M66EN AC_SDATA_IN 106 AC_SDATA_OUT AC_BIT_CLK 108 AC_CODEC_ID0# AC_CODEC_ID1# 110 AC_RESET# MOD_AUDIO_MON 112 RESERVED AUDIO_GND 114 GROUND SYS_AUDIO_OUT 116 SYS_AUDIO_IN SYS_AUDIO_OUT 118 SYS_AUDIO_IN GND GND 57 AD[17] 58 AD[18] 119 AUDIO_GND 120 AUDIO_GND 59 C/BE[2]# 60 AD[16] 121 RESERVED 122 MPCIACT# 61 IRDY# 62 GROUND 123 VCC5VA 124 3.3VAUX The signal CHSGND is a chassis ground contact and is connected on the Mini PCI Card via a spring contact clip. Technical Specifications Radio Technology Operating Frequency Modulation Schemes IEEE 802.11 a\b\g Turbo (DSSS and OFDM) 2412-2484 MHz and 4900-5900 MHz OFDM with BPSK, QPSK, 16QAM, 64QAM DSSS: DBPSK, DQPSK, CCK RF Channel Availability United States: 11 channels (2412 to 2462 MHz) Europe: 13 channels (2412 to 2472 MHz) Japan:13 channels (2412 to 2472 MHz); channel 14 (2484 MHz) United States: 12 channels (5180 to 5805 MHz) ProSoft Technology, Inc. September 6, 2007 Page 5 of 6 Contents Data Rate Media Access Protocol Transmitter RF Output Power Operating Voltage Interface Device Driver RLX-IHW-OEM ? 802.11a, b, g Industrial Hotspot Europe: 12 channels (5180 to 5805 MHz) Japan:11 channels (4920 to 5230 MHz) OFDM: 54,36,24,18,12,9 and 6 Mbps CCK: 11 and 5.5 Mbps QPSK: 2 Mbps BPSK: 1 Mbps CSMA/CA with ACK <20 dBm EIRP (typical) including antenna gain 3.3 Vdc (mini PCI slot of host computer) PC Card mini PCI Microsoft Windows 98SE/ME/NT/2000/XP Copyright Copyright © ProSoft Technology, Inc. 2000 - 2007. All Rights Reserved. RLX-IHW-OEM User Guide September 06, 2007 ProSoft Technology, Inc. September 6, 2007 Page 6 of 6
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Encryption : Standard V2.3 (128-bit) User Access : Print, Extract XMP Toolkit : 3.1-702 Create Date : 2007:09:11 11:27:51Z Creator Tool : RLX_IHW_OEM_updated manual - Microsoft Word Modify Date : 2008:01:29 11:17:01-05:00 Metadata Date : 2008:01:29 11:17:01-05:00 Format : application/pdf Creator : courtenay Title : RLX_IHW_OEM_updated manual.doc Producer : Acrobat PDFWriter 5.0 for Windows NT Document ID : uuid:87f6f5ab-95ba-42d1-b90f-d9c5db15d27c Instance ID : uuid:dd216111-2b6e-4606-94bc-71e5fee5d7f2 Page Count : 6 Author : courtenayEXIF Metadata provided by EXIF.tools