Radia Technology 1001 Pet Training System User Manual Users Guide with FCC Statement

Radia Technology Limited Pet Training System Users Guide with FCC Statement

Users Guide with FCC Statement

1PET TRAINING SYSTEM – OPERATORS GUIDE1. THE PRODUCTThis is a radio frequency based remote control design around radiofrequency IC from RF Micro Device. The two IC of choice is RF2917 andRF2512. The devices are designed for compliance to regulatoryrequirements as intended transmitter in following standards:! US FCC Part 15.249 (900MHz version)! Canadian TRS RSS210 (900MHz version)The specification of the device is as follow:SPECIFICATION: 912MHZ TRANSMITTERFEATURE VALUE NOTESFrequency 912.03MHz +/-25ppmRF Power +9dBm Comply with US FCC Part15.249 and Canadian TRSRSS210 with 50 OHM antennaModulation FSKDerivation +/-50kHZData rate 20kbits/sTX sequence ! Preamble! Address! Key CodeCode will be repeated for about600ms to reach a wakeup timeslot of the receiver (500ms)Buttons 3 Synapses on bottom layerBattery 6 voltsTransmissiondistance with RX >100mCurrent drainActive 40 mAStandby <10uASPECIFICATION: 912MHZ RECEIVERFEATURES VALUE NOTESFrequency 912.03MHz +/-25 ppmInput sensitivity -103dBm 50Ohms, for detecting thecontrol sequence
2RX Scheme ! Wakes up every 500ms & triesto detect a signal for about 2ms. If no sinal, standby.! If signal occurs, it tries todetect a preamble.! If no preamble, standby.! If preamble occurs, it triesto receive an address and acontrol sequence (tries twotimes and compares).Battery 6 volts Internal : 3 voltsCurrent drainActive 14mAStandby 30uAAverage 40uA No input signalSpray 110mABuzzer 40mA2. USE OF THE TRANSMITTERThere’s altogether three buttons on the transmitter. The one close tothe battery is Button 3, the middle on is Button 2, the third button isButton 1.Button 1 – When pressed, it will send a signal and address code out.The right receiver with right address will recognize the transmissionand turn on the buzzer in the Receiver for a short pattern.Button 2 – When pressed, it will send a signal and address code out.The right receiver with right address will recognize the transmissionand turn on a solenoid in the Receiver for a short while.Button 3 – When pressed, it will send a signal and address code out.The right receiver with right address will recognize the transmissionand turn on the solenoid in the Receiver for a slightly long patterncompared with when Button 2 is pressed.The whole Transmitter only function for a short while and haveelectricity pass through when one of its button is pressed. However,even when any of those buttons is pressed accidentally, theTransmitter will not continuously on to send continuously signal.
33. PRODUCT COMPLIANCEWITH FCC AND INDUSTRY CANADA.This device complies with Part 15 of the FCCRules and with RSS-210 of Industry CanadaOperation is subject to the following twoconditions:1. This device may not cause harmfulinterference, and2. This device must accept any interferencereceived, including interference that maycause undesired operation.WarningChanges or modifications not expresslyapproved by the party responsible forcompliance could void the user’s authority tooperate the equipment.

Navigation menu