Radia Technology 1001 Pet Training System User Manual Users Guide with FCC Statement
Radia Technology Limited Pet Training System Users Guide with FCC Statement
Users Guide with FCC Statement
1
PET TRAINING SYSTEM – OPERATORS GUIDE
1. THE PRODUCT
This is a radio frequency based remote control design around radio
frequency IC from RF Micro Device. The two IC of choice is RF2917 and
RF2512. The devices are designed for compliance to regulatory
requirements as intended transmitter in following standards:
! US FCC Part 15.249 (900MHz version)
! Canadian TRS RSS210 (900MHz version)
The specification of the device is as follow:
SPECIFICATION: 912MHZ TRANSMITTER
FEATURE VALUE NOTES
Frequency 912.03MHz +/-25ppm
RF Power +9dBm Comply with US FCC Part
15.249 and Canadian TRS
RSS210 with 50 OHM antenna
Modulation FSK
Derivation +/-50kHZ
Data rate 20kbits/s
TX sequence ! Preamble
! Address
! Key Code
Code will be repeated for about
600ms to reach a wakeup time
slot of the receiver (500ms)
Buttons 3 Synapses on bottom layer
Battery 6 volts
Transmission
distance with RX >100m
Current drainActive 40 mA
Standby <10uA
SPECIFICATION: 912MHZ RECEIVER
FEATURES VALUE NOTES
Frequency 912.03MHz +/-25 ppm
Input sensitivity -103dBm 50Ohms, for detecting the
control sequence
2
RX Scheme ! Wakes up every 500ms & tries
to detect a signal for about 2
ms. If no sinal, standby.
! If signal occurs, it tries to
detect a preamble.
! If no preamble, standby.
! If preamble occurs, it tries
to receive an address and a
control sequence (tries two
times and compares).
Battery 6 volts Internal : 3 volts
Current drain
Active 14mA
Standby 30uA
Average 40uA No input signal
Spray 110mA
Buzzer 40mA
2. USE OF THE TRANSMITTER
There’s altogether three buttons on the transmitter. The one close to
the battery is Button 3, the middle on is Button 2, the third button is
Button 1.
Button 1 – When pressed, it will send a signal and address code out.
The right receiver with right address will recognize the transmission
and turn on the buzzer in the Receiver for a short pattern.
Button 2 – When pressed, it will send a signal and address code out.
The right receiver with right address will recognize the transmission
and turn on a solenoid in the Receiver for a short while.
Button 3 – When pressed, it will send a signal and address code out.
The right receiver with right address will recognize the transmission
and turn on the solenoid in the Receiver for a slightly long pattern
compared with when Button 2 is pressed.
The whole Transmitter only function for a short while and have
electricity pass through when one of its button is pressed. However,
even when any of those buttons is pressed accidentally, the
Transmitter will not continuously on to send continuously signal.
3
3. PRODUCT COMPLIANCE
WITH FCC AND INDUSTRY CANADA.
This device complies with Part 15 of the FCC
Rules and with RSS-210 of Industry Canada
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received,
including interference that may
cause undesired operation.
Warning
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.