Resolution RE101X Security Transmitter, 319.5MHz User Manual RE101 GE Compat DWS Instructions

Resolution Products, Inc. Security Transmitter, 319.5MHz RE101 GE Compat DWS Instructions

User Manual

RE101_GE-Compat_DWS_Instructions.doc Page 1 of 3 29-Jun-11 www.ResolutionProducts.com Wireless Security Solutions RE101 GE-Compatible Standard Door / Window Features • For sensing things that open or separate. • Magnet and Internal reed switch operation. • 2 supplemental hardwire zones. o GE-compatible version reports 2nd zone to 2nd ID. • Cover tamper. • Strong, reliable RF signal. • 10-15 year battery life on CR123A battery. • Low Battery indication. Key Instructions • Battery “+” faces towards spring. • No end-of-line resistors on hardwire zones. • Panels assume hardwire zone alarm is state in which contact was enrolled. • Center hardwire terminal is common. • Reed switch and terminal closest to (outer) it are 1st ID • Inner terminal is 2nd ID. • Enrolling:  1st ID: Reed switch and outer terminal zone are enrolled by tamper switch.  2nd ID: Inner terminal zone is enrolled by holding down tamper while installing battery. Operation • Magnetic and 1st (outer) hardwire zone (1st ID) Alarm, when… … magnet is pulled away from reed switch. … contact changes to alarm. Tamper, when cover is opened. Supervisories, every hour. • 2nd (inner) hardwire zone (2nd ID) Alarm: when contact changes to alarm condition. Tamper: none. Supervisory: every hour. RE101_GE-Compat_DWS_Instructions.doc Page 2 of 3 29-Jun-11 www.ResolutionProducts.com Specifications Magnet trip distance: 1 inch nominal Mounting hardware: # 4 or #6 screws Replacement Battery: CR123A 1550mAH Temperature Range: 0F to 120F Housing dimensions: 3.3x1.4x1.1 inches Specifications subject to change without notice. Internal Picture Outer Terminal Zone Center Common Terminal Inner Terminal Zone 2nd ID Magnetic Reed Switch 1st ID
RE101_GE-Compat_DWS_Instructions.doc Page 3 of 3 29-Jun-11 www.ResolutionProducts.com Notices “GE”, “Honeywell”, and “DSC” are trademarks owned by General Electric Company, Honeywell International Inc., and Tyco Safety Products Canada LTD, respectively. Resolution Products, Inc. products will function with one of either GE, DSC or Honeywell systems. However, no Resolution product is produced by, endorsed by, nor is officially associated with GE, Honeywell or DSC. Resolution recommends verifying proper enrollment and operation, per control panel installation instructions, at installation. Warranty Resolution Products, Inc. will replace products that are defective in their first year. FCC Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference that may be received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the Resolution Products, Inc. could void the user's authority to operate this equipment. FCC ID: U5X-RE101X IC Notice This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme avec d’Industrie Canada RSS standard exempts de licence. Son fonctionnement est soumis aux deux conditions suivantes: 1. Ce dispositif ne peut causer des interférences, et 2. Ce dispositif doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif. IC: 8310A-RE101X

Navigation menu