Resolution RE101X Security Transmitter, 319.5MHz User Manual RE101 GE Compat DWS Instructions
Resolution Products, Inc. Security Transmitter, 319.5MHz RE101 GE Compat DWS Instructions
User Manual
RE101_GE-Compat_DWS_Instructions.doc Page 1 of 3 29-Jun-11
www.ResolutionProducts.com
Wireless
Security
Solutions
RE101 GE-Compatible Standard Door / Window
Features
• For sensing things that open or separate.
• Magnet and Internal reed switch operation.
• 2 supplemental hardwire zones.
o GE-compatible version reports 2
nd
zone to 2
nd
ID.
• Cover tamper.
• Strong, reliable RF signal.
• 10-15 year battery life on CR123A battery.
• Low Battery indication.
Key Instructions
• Battery “+” faces towards spring.
• No end-of-line resistors on hardwire zones.
• Panels assume hardwire zone alarm is state in which contact was enrolled.
• Center hardwire terminal is common.
• Reed switch and terminal closest to (outer) it are 1
st
ID
• Inner terminal is 2
nd
ID.
• Enrolling:
1
st
ID: Reed switch and outer terminal zone are enrolled by
tamper switch.
2
nd
ID: Inner terminal zone is enrolled by holding down
tamper while installing battery.
Operation
• Magnetic and 1
st
(outer) hardwire zone (1
st
ID)
Alarm, when…
… magnet is pulled away from reed switch.
… contact changes to alarm.
Tamper, when cover is opened.
Supervisories, every hour.
• 2
nd
(inner) hardwire zone (2
nd
ID)
Alarm: when contact changes to alarm condition.
Tamper: none.
Supervisory: every hour.
RE101_GE-Compat_DWS_Instructions.doc Page 2 of 3 29-Jun-11
www.ResolutionProducts.com
Specifications
Magnet trip distance: 1 inch nominal
Mounting hardware: # 4 or #6 screws
Replacement Battery: CR123A 1550mAH
Temperature Range: 0F to 120F
Housing dimensions: 3.3x1.4x1.1 inches
Specifications subject to change without notice.
Internal Picture
Outer Terminal Zone
Center Common Terminal
Inner Terminal Zone
2
nd
ID
Magnetic Reed Switch
1
st
ID
RE101_GE-Compat_DWS_Instructions.doc Page 3 of 3 29-Jun-11
www.ResolutionProducts.com
Notices
“GE”, “Honeywell”, and “DSC” are trademarks owned by General Electric Company, Honeywell
International Inc., and Tyco Safety Products Canada LTD, respectively.
Resolution Products, Inc. products will function with one of either GE, DSC or Honeywell
systems. However, no Resolution product is produced by, endorsed by, nor is officially
associated with GE, Honeywell or DSC. Resolution recommends verifying proper enrollment
and operation, per control panel installation instructions, at installation.
Warranty
Resolution Products, Inc. will replace products that are defective in their first year.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference.
This device must accept any interference that may be received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could
void the user's authority to operate this equipment.
FCC ID: U5X-RE101X
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
Cet appareil est conforme avec d’Industrie Canada RSS standard exempts de licence.
Son fonctionnement est soumis aux deux conditions suivantes:
1. Ce dispositif ne peut causer des interférences, et
2. Ce dispositif doit accepter toute interférence, y compris les interférences
qui peuvent causer un mauvais fonctionnement du dispositif.
IC: 8310A-RE101X