Robert Bosch Tool IDX01 GCY Idefix User Manual Briefbogen

Robert Bosch Tool Corporation GCY Idefix Briefbogen

Contents

InstallationInstruction

     Registered Office: Stuttgart, Registration Court: Amtsgericht Stuttgart, HRB 14000;  Chairman of the Supervisory Board: Franz Fehrenbach; Managing Directors: Dr. Volkmar Denner,    Dr. Stefan Asenkerschbaumer, Dr. Rolf Bulander, Dr. Stefan Hartung, Dr. Markus Heyn, Dr. Dirk Hoheisel,  Christoph Kübel, Uwe Raschke, Dr. Werner Struth, Peter Tyroller         Robert Bosch GmbH  Postfach 10 01 56 70745 Leinfelden-Echterdingen  Visitors: Max-Lang-Straße 40-46 70771 Leinfelden  Tel 0711 758-0   www.bosch.com         Power Tools                  To whom it may concern   Applicant / Manufacturer Hardware Robert Bosch GmbH 70745 Leinfelden-Echterdingen Germany  01 July 2016   Content   Instruction manual for   Device name:      GCY Idefix Manufacturer part number:  1600A00H6H   FCC ID:      TXTIDX01 IC:        909H-IDX01   Instructions for physical implementation   The described transmitter is intended to be fixated with a screw in the screw hole (black, see figure below):    To ensure an adequate performance of the antenna, the following exclusion areas (red/green) for the components and screw hole need to be adhered to, when implementing the described transmitter into a host device,
     Power Tools                   01 July 2016 Page 2 of 3  see figure below:    Additionally, to ensure an adequate performance of the antenna, no metal parts are allowed in the exclusion areas defined in green. No plastic is allowed in the orange exclusion areas and no plastic or metal is allowed in the black exclusion areas, see figure below:    Device Power Supply The transmitter described in this document is intended to be supplied by an external voltage supply:   Either directly with nominal 3V by a CR2032 coin cell via the corresponding and/or with nominal 3.3V ± 2% indirectly by a host device with pins.
     Power Tools                   01 July 2016 Page 3 of 3  The connection for both external power supplies is realized by a PicoBlade™ (wire to board connector) which prevents unintended connection of standard power supplies (such as micro-USB).    Feel free to contact us if additional guidance is required.  Yours sincerely  Robert Bosch GmbH

Navigation menu