Rosslare DRU955BT Desktop Reader & Programmer for UHF/MIFARE/BLE User Manual A4 1 page

Rosslare Enterprises Ltd Desktop Reader & Programmer for UHF/MIFARE/BLE A4 1 page

User Manual

Download: Rosslare DRU955BT Desktop Reader & Programmer for UHF/MIFARE/BLE User Manual A4 1 page
Mirror Download [FCC.gov]Rosslare DRU955BT Desktop Reader & Programmer for UHF/MIFARE/BLE User Manual A4 1 page
Document ID4127308
Application IDrCj60nvBVh4rxfO/oQOyAA==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize26.44kB (330518 bits)
Date Submitted2019-01-02 00:00:00
Date Available2019-01-02 00:00:00
Creation Date2018-12-03 09:38:41
Producing SoftwareAdobe PDF Library 10.0
Document Lastmod2019-01-02 10:34:40
Document TitleA4 1-page
Document CreatorAcrobat PDFMaker 10.0 for Word
Document Author: Sam Goldberg

DR-U955BT
SMART
Multi-format Desktop Reader
User Manual
1. Introduction
The DR-U955BT is an advanced desktop reader for MIFARE Classic®
EV1, MIFARE® DESFire® EV1, UHF, and BLE. It reads the ID data of
the credential, and transmits the relevant ID data to any connected
access control software, such as Rosslare’s AxTraxNG™.
Figure 1: DR-U955BT
It has a slim and attractive design and is built for convenience and
portability. With its USB computer interface, it is quick and easy to
install and runs without any additional power source.
Using the BLE-Admin or BLE-ID apps, the reader can function like
other Rosslare BLE readers and can transmit the BLE ID to the
reader.
The Hardware Configuration Tool (HCT) can be used to configure
the reader’s specifications, such as the Wiegand format used.
The reader reads the CSN ID of each credential (MIFARE, UHF, BLE)
and transmits it to the software with the bit length pre-configured by
the user.
2. Technical Specifications
2.1
Electrical Characteristics
2.2
Environmental Characteristics
Operating Voltage Range
5 VDC (USB powered)
Standby Current
250 mA
Max. Operation Current
300 mA
Supported Transponders
MIFARE, UHF, BLE
Read Card Distance
UHF and MIFARE: Up to 5 cm (2 in.)
BLE: Up to 6 m (19.7 ft)
Operation Frequency
•
RFID: 13.56 MHz
Weight
130 g (4.6 oz)
•
DR-U955BT US: 902–928 MHz
(America) RFID
Dimensions (L x W x H)
123 x 70 x 16.2 mm (4.9 x 2.8 x 0.6 in.)
•
DR-U955BT EU: 865–868 MHz
(Europe) RFID
•
Bluetooth: 2.402-2.480 GHz
Output Formats
Operating Environment
Operating Temperature Range
Storage Temperature Range
-20°C to 63°C (-4°F to 145°F)
Relative Humidity Range
0 to 95% (non-condensing)
2.3
Supports Wiegand 26-Bit to 64-Bit
3. Operation
The DR-U955BT appears as a COM port device when plugged in to a
PC and can be used for any application. When a card is presented to
the reader, the reader outputs the Wiegand ID data on the COM port
only once until a new card is presented.
You must use the AxTraxNG software to enroll cards. Please refer to
the relevant appendix in the AxTraxNG™ Software Installation and
User Manual.
For the enrollment reader to function in AxTraxNG, you must know
the COM port being used. The COM port can be found in Microsoft
Device Management’s driver details under ‘Ports (COM & LPT)’. The
port being used appears as “USB serial Port (COMx)”, where x is the
number of the port used.
Indoor use
-20°C to 63°C (-4°F to 145°F)
Physical Characteristics
Declaration of Conformity


This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for
help.
FCC Radiation Exposure Statement:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment .
This transmitter must not be co-located or operating in conjunction with
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
any other antenna or transmitter.
This equipment should be installed and operate d with minimum distance
20cm between the radiator &you body.
Limited Warranty
The full ROSSLARE Limited Warranty Statement is available in the
Quick Links section on the ROSSLARE website at
www.rosslaresecurity.com.
Rosslare considers any use of this product as agreement to the
Warranty Terms even if you do not review them.
Contact Information
United States and Canada
Rosslare Security Products, Inc.
Southlake, TX, USA
Toll Free: +1-866-632-1101
Local:
+1-817-305-0006
Fax:
+1-817-305-0069
support.na@rosslaresecurity.com
Europe
Rosslare Israel Ltd.
22 Ha'Melacha St., P.O.B. 11407
Rosh HaAyin, Israel
Tel: +972-3-938-6838
Fax: +972-3-938-6830
support.eu@rosslaresecurity.com
Latin America
Rosslare Latin America
Buenos Aires, Argentina
support.la@rosslaresecurity.com
China
Rosslare Electronics (Shenzhen) Ltd.
Shenzhen, China
Tel: +86-755-8610-6842
Fax: +86-755-8610-6101
support.cn@rosslaresecurity.com
Asia Pacific, Middle East, Africa
Rosslare Enterprises Ltd.
Kowloon Bay, Hong Kong
Tel: +852-2795-5630
Fax: +852-2795-1508
support.apac@rosslaresecurity.com
India
Rosslare Electronics India Pvt Ltd.
Tel/Fax: +91-20-40147830
Mobile: +91-9975768824
sales.in@rosslaresecurity.com
CERT
ISO 9001
ISO 14001
0706-0960664+00

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Author                          : Sam Goldberg
Company                         : SYO
Create Date                     : 2018:12:03 09:38:41+02:00
Modify Date                     : 2019:01:02 10:34:40-08:00
Product Name                    : Product Name
Source Modified                 : D:20181101134653
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Metadata Date                   : 2019:01:02 10:34:40-08:00
Creator Tool                    : Acrobat PDFMaker 10.0 for Word
Document ID                     : uuid:74a11fe3-643b-46ab-a573-3ccb7c17460c
Instance ID                     : uuid:824391b0-2ff4-48c1-bae5-32793f53abcd
Subject                         : 48
Format                          : application/pdf
Title                           : A4 1-page
Creator                         : Sam Goldberg
Producer                        : Adobe PDF Library 10.0
Product 0020 Name               : Product Name
Page Layout                     : OneColumn
Page Count                      : 2
EXIF Metadata provided by EXIF.tools
FCC ID Filing: GCD-DRU955BT

Navigation menu