SDI Technologies IBT372 Waterproof & Shockproof Wireless Stereo Speaker User Manual iBT373 QSG
SDI Technologies Inc. Waterproof & Shockproof Wireless Stereo Speaker iBT373 QSG
Contents
- 1. User Manual-1
- 2. User Manual-2
User Manual-2
iBT373 QSG Size: 280W x 160H (mm) Folded size: 140W x 160H material: 260gsm2 art card, 2C + 1C Date: Jan 10, 2016 PMS7469C FRONT Color Changing Rechargeable Bluetooth Speaker with Speakerphone Color Changing Rechargeable Bluetooth Speaker with Speakerphone Model: iBT373 Model: iBT373 Speakerphone In the Box » The speaker must be on and connected with a paired Bluetooth device to recieve calls » When a call is received, playing music is muted to hear the ring tone. Press the Bluetooth/Speakerphone Button to answer call. For call waiting function, use phone controls on your device. » Press the » To play aux audio, connect a standard audio cable (not included) to the headphone jack of your audio device and connect the other end to the aux-in jack on iBT373. Power Button for 2 seconds on the unit to turn it on. » Power on the aux audio device and use the controls on the device to play or pause audio, and to navigate tracks. Make sure to pause any connected Bluetooth device to hear aux audio. or Color Mode Button to cycle through these modes: Slow Fade Fast Change Favorite Color Pulse to Music USB AC adaptor (not included) Charging Status indicator Solid red = charging Red LED off = fully charged Flashing red = low battery Bluetooth: Pairing & Playing » Make your device “discoverable” by turning on Bluetooth mode » Press and hold the Power Button for 2 seconds to power on iBT373 Preset Pulsing Off Waterproof Operation » For proper waterproof operation, make sure the waterproof cover on the right side of the unit is completely flush with the unit by pressing along the entire edge of the cover until it is completely and securely in place. Manual Pairing Pairing the First Time » The first time the unit is powered on it will enter auto-pairing mode » Press and hold the Power Button for 2 seconds to power on iBT373 » Carry Strap device to charge. buttons to adjust the system volume. You can also adjust volume on your device. Color Changing Modes » Press the » USB charging cable » Connect USB cable to USB port and the other end to your Aux-In » Press the » iBT373 speaker » Connect the micro-USB plug on the included charging cable to the USB Charging jack on the speaker. Bluetooth/Speakerphone Button again to end call and resume previous function. » Press and hold the CHARGE UNIT BEFORE USE - ABOUT 5 HOURS QUICK START GUIDE QUICK START GUIDE -OR- » Power on speaker » Press and hold the Bluetooth/ Speakerphone Button for 2 seconds » Select “iHome iBT372” on your device’s Bluetooth menu to complete pairing » Press the Play/Pause Button to play and pause audio from your Bluetooth device. Navigate tracks from your device. » Use the and iHome iBT373 buttons to control iBT373 volume Voice Commands water tight not water tight » NOTE: The unit must be powered on and linked to a Bluetooth phone to use voice commands. » Press and hold the Play/Pause/Voice Command Button to access the voice command protocol associated with your device’s operating system (Siri for iOS devices, “OK, Google” for Android devices, etc.) For full waranty and full instructions visit: www.ihome.com/support Contact Us: 1 •800 •288 •2792 Contact Us: 1• 800• 288• 2792 For full waranty and full instructions visit: www.ihome.com/support BACK FCC Information FCC Radiation Exposure Statement iBT373 FCC ID: EMOIBT372 IC: 986B-IBT372 The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. • NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. CAN ICES-3 (B)/NMB-3(B) Canada Statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage; (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. le dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf. l'appareil peut être utilisé dans des conditions d'exposition portatif sans restriction. iBT373-170105-A (EN) Printed in China Internal Rechargeable Lithium-ion Battery This device uses an internal non-replaceable rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it for an extended period of time and try resetting the unit. If this fails, contact Customer Service at 1-800-288-2792. WARNING/DISPOSAL OF UNIT Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your device. To dispose of the unit, follow the instructions below: • Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances. • Always dispose of used batteries/electronics in accordance with the prevailing community regulations. • Many electronics retailers now recycle batteries and other electronic components at no charge. GENERAL BATTERY PRECAUTIONS • Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal. • Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other electrolytic substances. • Avoid charging a rechargeable battery when the temperature is not within 5°C - 35° C (41° - 95° Fahrenheit). • Never expose a battery to any liquid. • Never expose a battery to excessive heat such as direct sunlight or fire. Never use a battery pack in an unventilated vehicle where excessive internal temperatures may be encountered. • Always keep batteries out of the reach of infants and small children.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Create Date : 2017:01:10 15:48:35+08:00 Creator : Adobe Illustrator CC 2015 (Macintosh) Modify Date : 2017:01:10 16:18:02+08:00 XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Format : application/pdf Title : iBT373_QSG Metadata Date : 2017:01:10 16:18:02+08:00 Creator Tool : Adobe Illustrator CC 2015 (Macintosh) Thumbnail Width : 168 Thumbnail Height : 256 Thumbnail Format : JPEG Thumbnail Image : (Binary data 18733 bytes, use -b option to extract) Instance ID : uuid:d1cd19ad-f3f7-48ec-8a10-3f39e6da5bba Document ID : xmp.did:7e70463c-1389-4fef-844e-7a42d29a0d4d Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:85e48f7f-30fe-7d4f-bf77-e7d25ec9a272 Derived From Document ID : xmp.did:aa481f77-6fd8-41ad-85dd-e4d5286f027f Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:6d0272ac-9290-4a2e-8ba4-d44b66409012, xmp.iid:7e70463c-1389-4fef-844e-7a42d29a0d4d History When : 2016:10:31 09:12:52-04:00, 2017:01:10 15:48:27+08:00 History Software Agent : Adobe Illustrator CC 2015 (Macintosh), Adobe Illustrator CC 2015 (Macintosh) History Changed : /, / Startup Profile : Print Has Visible Overprint : True Has Visible Transparency : False N Pages : 1 Max Page Size W : 341.488889 Max Page Size H : 480.074854 Max Page Size Unit : Millimeters Font Name : Gotham-Light, Gotham-Book, Gotham-BookItalic, Gotham-Medium, Gotham-Black, MyriadPro-Regular Font Family : Gotham, Gotham, Gotham, Gotham, Gotham, Myriad Pro Font Face : Light, Book, Book Italic, Medium, Black, Regular Font Type : Open Type, Open Type, Open Type, Open Type, Open Type, Open Type Font Version : Version 2.201 Pro, Version 2.201 Pro, Version 2.201 Pro, Version 2.201 Pro, Version 2.201 Pro, OTF 1.006;PS 001.000;Core 1.0.23;hotunix 1.28 Font Composite : False, False, False, False, False, False Font File Name : Gotham-Light.otf, Gotham-Book.otf, Gotham-BookItalic.otf, Gotham-Medium.otf, Gotham-Black.otf, MyriadPro-Regular.otf Plate Names : Cyan, Magenta, Yellow, Black, WEATHER TOUGH PANTONE 7694 U, WEATHER TOUGH PANTONE 7694 C, Cut, 60% Grey.spot Swatch Groups Colorants Red : 0 Swatch Groups Colorants Green : 0 Swatch Groups Colorants Blue : 0 Swatch Groups Colorants L : 25.882353 Swatch Groups Colorants A : -6 Swatch Groups Colorants B : -30 Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : Brights Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 60.000000 Swatch Groups Colorants Magenta : 90.000000 Swatch Groups Colorants Yellow : 0.003100 Swatch Groups Colorants Black : 0.003100 Producer : Adobe PDF library 15.00 Slug Family : Gotham Slug Version : 2.201 Slug Outline File Size : 0 Slug Kerning Checksum : 0 Slug Foundry : -- Slug Font Kind : OpenType - PS Slug Checksum : 2923196107 Slug Post Script Name : Gotham-Light Slug Font Sense 12 Checksum : 2923196107 Page Count : 1EXIF Metadata provided by EXIF.tools