SHARPVISION DW639 Digital Wireless Video System User Manual

SHARPVISION CO.,LTD. Digital Wireless Video System

Manual

Image DeviceTV System PAL NTSCEffective Pixels 512×582pixels 512×492 pixelsSensing AreaScanning SystemSync. SystemResolutionHorizontal Sync Frequency 15.625 kHz 15.734 kHzVertical Sync Frequency 50 Hz 60 HzVideo OutputGamma ConsumptionAGCS/N RatioWhite BalanceElectronic ShutterBLCOperation Frequency: Line of Sight Range:Receiving Sensitivity:Video Codec: RF Band Width:Frame Rate:Spread SPECTRUM:Delay:RF Bit Rate:Storage TemperatureOperating TemperatureMinimum IlluminationPower SupplyNight vision distanceWaterproof ratingImage modeHeater AudioViewing Angle200msPAL: 25f/s NTSC: 30f/s2400-2483.5MHZ0.451/60(NTSC)/1/50(PAL)～1/100,000 SecondsAuto–40℃ ~ 80℃, RH95%MAX. ■ 120° □ 92° □ 69° □ 45° □ 25° ■ Mirror □ Normal □ Mirror/Normal image switch □ Yes ■ No ■ Yes □ No1.CAMERA SPECIFICATION2.SYSTEM OPERATIONAuto □ 0 Lux ■ 0.1 Lux □ 0.5 Lux-78dBm –20℃~70℃, RH95%MAX1/3” SHARP CCDAuto420TV Lines1.0Vp-p, 75OhmFHSS/16QAMBetter than 48dB120M4.9mm×3.7mm2:1 InterlaceInternal ■ IP69K □ IP67 □ NONWATERPROOF ■3~5m □8~10m □12~15m ■DC12V □ DC24V □ DC12V~DC24V12MbpsMPEG45MHZ
3.PRECAUTIONS
FCC Statement:This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules.These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, may cause harmful interferenceto radio communications.However, there is no guarantee that interference will not occur in a particular installation. If thisequipment doescause harmful interference to radio or television reception, which can be determined by turningthe equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:· Reorient or relocate the receiving antenna.· Increase the separation between the equipment and receiver.· Connect the equipment to an outlet on a circuit different from that to which the receiver isconnected.This device complies with part 15 of the FCC rules. Operation is subject to the following twoconditions: (1) This device may not cause harmful interference, and (2) this device must accept anNote: Modifications to this product will void the user's authority to operate this equipment.

Navigation menu