SHARPVISION DW639 Digital Wireless Video System User Manual
SHARPVISION CO.,LTD. Digital Wireless Video System
Manual
1.CAMERA SPECIFICATION Image Device 1/3” SHARP CCD PAL NTSC TV System 512×582pixels 512×492 pixels Effective Pixels 4.9mm×3.7mm Sensing Area 2:1 Interlace Scanning System Internal Sync. System 420TV Lines Resolution 15.625 kHz 15.734 kHz Horizontal Sync Frequency 50 Hz 60 Hz Vertical Sync Frequency 1.0Vp-p, 75Ohm Video Output 0.45 Gamma Consumption Auto AGC Better than 48dB S/N Ratio Auto White Balance 1/60(NTSC)/1/50(PAL)~1/100,000 Seconds Electronic Shutter Auto BLC Operation Frequency: 2400-2483.5MHZ Line of Sight Range: 120M Receiving Sensitivity: -78dBm Video Codec: MPEG4 RF Band Width: 5MHZ Frame Rate: PAL: 25f/s NTSC: 30f/s Spread SPECTRUM: FHSS/16QAM Delay: 200ms RF Bit Rate: 12Mbps –40℃ ~ 80℃, RH95%MAX. Storage Temperature –20℃~70℃, RH95%MAX Operating Temperature □ 0 Lux ■ 0.1 Lux □ 0.5 Lux Minimum Illumination ■DC12V □ DC24V □ DC12V~DC24V Power Supply ■3~5m □8~10m □12~15m Night vision distance ■ IP69K □ IP67 □ NONWATERPROOF Waterproof rating ■ Mirror □ Normal □ Mirror/Normal image switch Image mode □ Yes ■ No Heater ■ Yes □ No Audio ■ 120° □ 92° □ 69° □ 45° □ 25° Viewing Angle 2.SYSTEM OPERATION 3.PRECAUTIONS FCC Statement: This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept an Note: Modifications to this product will void the user's authority to operate this equipment.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : 3.1-701 Producer : Acrobat Distiller 7.0 (Windows) Creator Tool : PScript5.dll Version 5.2 Modify Date : 2013:07:15 13:49:20+08:00 Create Date : 2013:07:15 13:49:20+08:00 Format : application/pdf Title : User manual.xls Creator : vincent Document ID : uuid:92a161f5-8ab4-4cca-a0c4-3aa7121b9c65 Instance ID : uuid:6aa399ec-f3c0-4713-ad77-049c49bae17e Page Count : 3 Author : vincentEXIF Metadata provided by EXIF.tools