SOAIY TECHNOLOGY X3 Bluetooth Speaker User Manual NTS5
SHENZHEN SOAIY TECHNOLOGY CO.,LTD Bluetooth Speaker NTS5
User manual
Bluetooth Speaker User Guide X3 Power ON/OFF Operation Charging the speaker before first use is recommended. Hold power button down for (3) seconds to turn on / off the device. There will be sound effects when you turn on / off the speaker. The speaker powers off after 5 minutes of inactivity. Bluetooth Connection Operation X3 Open and enable Bluetooth on your device. (phone, tablet...) Look for "X3" and select it on your phone / tablet screen. Wait for Bluetooth to connect and listen to the successful pairing prompt. Bluetooth will auto connect when turned on if previous established connection was not overridden by a different device. Keys Function Operation Button Operation: Quick Press: It refers to a quick depress of the button, do not hold. Holding: Hold the button down for specified amount of time. Pause/ Play Quick Press to pause and play music. Press and hold it to disconnect Bluetooth Connection. When a call comes in: 1 .Quick Press to answer call. 2 .Quick Press again to end call. 3 .Quick Press twice to reject call. Quick Press twice to redial last phone number. Keys Function Operation Quick Press to switch to next track.(Available only in Bluetooth) Press and hold it to turn up the volume. Keys Function Operation Press to switch to previous track or beginning of the track. (Available only in Bluetooth) Press and hold it to turn down the volume. LED Indicator Light: RED RED BLUE/RED BLUE (Flashing): (Solid): (Flashing): (Solid): Charging Fully Charged Ready to Pair / Pairing Bluetooth / AUX mode Microphone Hole 30c For better sound quality, please keep the device no more than 30cm away from you. Calling from the same room may cause interference in sound quality. Side Interface Diagram AUX audio input Reset switch Micro-USB charge port AUX IN Connect the device to an audio source via audio cable. There will be a sound when connected successfully. The device will play the music from the audio source. Reset Switch Press the reset switch with the help of a paper clip to reset the device. 10 USB Interface The device can be charged when it is connected with DC-5V 1A charger via USB cable. Charging is possible through: Computer, Power Bank, Car Charger, Wall plug. Charging through PC's USB port is generally the slowest method. 11 Package Contents X3 3.5mm Audio Cable User Guide Micro-USB to USB Charge Cable 12 Technical Data Bluetooth Version 2.1+EDR Frequency response 80Hz to 18KHz Output power 4.5W Maximum SPL Impedance 4Ω Netweight 195g Dimension L86*W34.5*H86mm Battery Li-ion battery 3.7V 1200mAh 86dB Charging time 2~3hours Playtime 7 hours (default volume) 13 ! ● Important Safety Instructions Study this user guide carefully before using this speaker ● Keep speaker away from high temperatures. Do not leave it in the sun (Heat degrades battery life span) Keep away from open flames ● Do not expose speaker to liquids or moisture ● Refrain from destroying, modifying, dropping, or throwing speaker ● Always check for power compatibility before charging ● Loud music may impact hearing loss ● Disassembling the speaker will void warranty for speaker At the end of the speaker's lifecycle and warranty period, properly discard speaker according to state law ● ● Do not store speaker for over a month without usage. We suggest charging the battery from low power to full once a month to preserve battery life 14 FCC Caution: This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. Th e device can be used in portable exposure condition without restriction. FCC ID: 2AECY-X3 Supervised by GuangzhouSoaiy Digital Technology Co.,Ltd Manufactured by Shenzhen Soaiy Technology Co.,Ltd ADD:2&4/F,Bldg D,Fuxinlin Industrial park,Hangcheng Industrial Zone,Xixiang Street,Bao’an District,Shenzhen,China Website:www.soaiyaudio.com Email:sales@soaiyaudio.com
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.7 Linearized : No Has XFA : No XMP Toolkit : Adobe XMP Core 5.6-c015 81.157285, 2014/12/12-00:43:15 Format : application/pdf Creator : Administrator Title : NTS5 英文说明书.cdr Create Date : 2016:07:20 18:04:22+08:00 Creator Tool : CorelDRAW X7 Modify Date : 2016:08:19 10:13:30+08:30 Metadata Date : 2016:08:19 10:13:30+08:30 Producer : Corel PDF Engine Version 17.4.0.887 Document ID : uuid:fc597ce6-977b-4ea3-8310-bf2ba81e176c Instance ID : uuid:4f743291-320a-40d2-9998-9abc6f91979d Profile CMM Type : Lino Profile Version : 2.1.0 Profile Class : Display Device Profile Color Space Data : RGB Profile Connection Space : XYZ Profile Date Time : 1998:02:09 06:49:00 Profile File Signature : acsp Primary Platform : Microsoft Corporation CMM Flags : Not Embedded, Independent Device Manufacturer : IEC Device Model : sRGB Device Attributes : Reflective, Glossy, Positive, Color Rendering Intent : Perceptual Connection Space Illuminant : 0.9642 1 0.82491 Profile Creator : HP Profile ID : 0 Profile Copyright : Copyright (c) 1998 Hewlett-Packard Company Profile Description : sRGB IEC61966-2.1 Media White Point : 0.95045 1 1.08905 Media Black Point : 0 0 0 Red Matrix Column : 0.43607 0.22249 0.01392 Green Matrix Column : 0.38515 0.71687 0.09708 Blue Matrix Column : 0.14307 0.06061 0.7141 Device Mfg Desc : IEC http://www.iec.ch Device Model Desc : IEC 61966-2.1 Default RGB colour space - sRGB Viewing Cond Desc : Reference Viewing Condition in IEC61966-2.1 Viewing Cond Illuminant : 19.6445 20.3718 16.8089 Viewing Cond Surround : 3.92889 4.07439 3.36179 Viewing Cond Illuminant Type : D50 Luminance : 76.03647 80 87.12462 Measurement Observer : CIE 1931 Measurement Backing : 0 0 0 Measurement Geometry : Unknown Measurement Flare : 0.999% Measurement Illuminant : D65 Technology : Cathode Ray Tube Display Red Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Green Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Blue Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Page Count : 16 Author : AdministratorEXIF Metadata provided by EXIF.tools