SQT Electronics SM314CAG 2.4GHz Wireless Mouse User Manual SM 314CAG H383 V108 manual

Download:
Mirror Download [FCC.gov]
Document ID	4154213
Application ID	SG5ElpbHzcfnOyEhqg9rcw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	26.49kB (331141 bits)
Date Submitted	2019-01-30 00:00:00
Date Available	2019-01-31 00:00:00
Creation Date	2017-12-20 11:10:13
Producing Software	Corel PDF Engine Version 14.0.0.701
Document Lastmod	2019-01-25 12:39:31
Document Title	SM-314CAG（H383+V108)manual
Document Creator	CorelDRAW
Document Author:	yanfawenyuan

Recharging wireless mouse by charging cable
Parts Number
(1).Battery interface
(2).Power Switch
(3).Left click Button
(4).Right click Button
(5).Scroll whee
(6).DPI Button
take out the charing cable,plug into the charging
cable into computer's USB port ,and plug the mini
USB pole into the USB port in the front of mouse
in the next step
The mouse use one 400mAH built-in lithium battery.
Charging instructions
1.The RED LED indictor will be ON while charging. After fully charged,
the LED will turn off.
2.Charging time:2.5hours
Using time: 12days for one charging
Your optical 3 button mouse is provide 800/1200/1600 dpi switch.
Insert the nano receiver to USB port immediately,or by a
extra USB cable.
DPI Switch
Nano Rreceiver
USB port
1.If you want to use the mouse,pls take out the receiver (shown in picture
connect it to computer;
1.Connect the USB plug to USB port of your computer
2.If you want to stop using the mouse, pls store the receiver onto the mouse
(shown in picture
);
Nano receiver
Model:SM-314CAG
lf the mouse doesn’t work, pls
1.replace new batteries timely if the batteries have run out;
2.disconnect and re-connect the nano receiver to the USB port to establish new
connection for the mouse;
3.move the mouse more closer to the receiver if the device is out
of the optimum range;
State of standby and wake up the mouse
Without any clicks or scroll movement for 8 minutes, the mouse will go
into standby mode. Click any button or scroll the wheel to wake up the mouse.
Under this economize mode, the optical Red LED will turn of automatically and
the mouse won’t respond by moving it.
1.Without using the mouse for 1 minute, the mouse will go into sleep mode
level1.You can move it to wake up the mouse. The Red LED is still on.
2. Without using the mouse for 1-8 minutes, the mouse will go into sleep
mode level 2. You can move it to wake up the mouse. The Red LED keep
flashing.
3.Without using the mouse for more than 8 minutes, the mouse will go
into deep sleep mode. The LED turn off automatically.
) and
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Author                          : yanfawenyuan
Create Date                     : 2017:12:20 11:10:13+08:00
Modify Date                     : 2019:01:25 12:39:31+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Format                          : application/pdf
Creator                         : yanfawenyuan
Title                           : SM-314CAG（H383+V108)manual
Creator Tool                    : CorelDRAW
Metadata Date                   : 2019:01:25 12:39:31+08:00
Producer                        : Corel PDF Engine Version 14.0.0.701
Document ID                     : uuid:e8738007-3c8a-46dd-9352-d9b5bab65acf
Instance ID                     : uuid:003ff740-b62d-43b1-9581-f4a808e98297
Page Count                      : 2

EXIF Metadata provided by EXIF.tools