ST Engineering Telematics Wireless TX5003 Remote Control Unit, Model Tx-5003 User Manual 5 pages

Telematics Wireless Ltd. Remote Control Unit, Model Tx-5003 5 pages

5 pages

tTadiran Telematics proprietary 1Tadiran Telematics Ltd., 26 Hashoftim St., P.O.B. 267, Holon 58102, Israel Tel.: (972-3) 557-5750 Fax.: (972-3) 557-5753D:\Ready_To_Convert\Doc\123343.DOCTX - 5003RCU - Remote Control UnitOPERATING INSTRUCTIONSAugust 2000 DRAFTTX5003 FCC ID: NTATX5003Manufacturer: Tadiran Telematics Ltd.This device complies with Part 15 of FCC Rules.Operation is subjected to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including Interference that may cause undesired operation.
tTadiran Telematics proprietary 2Tadiran Telematics Ltd., 26 Hashoftim St., P.O.B. 267, Holon 58102, Israel Tel.: (972-3) 557-5750 Fax.: (972-3) 557-5753D:\Ready_To_Convert\Doc\123343.DOCTable of ContentsPage1. Description 32. Controls 33. Indicator 34. Arming the system 35. Disarming the system 46. Battery replacement 4
tTadiran Telematics proprietary 3Tadiran Telematics Ltd., 26 Hashoftim St., P.O.B. 267, Holon 58102, Israel Tel.: (972-3) 557-5750 Fax.: (972-3) 557-5753D:\Ready_To_Convert\Doc\123343.DOC1. DescriptionTX - 5003 is a transmitter for short - range wireless data application.It is used to transfer the operator (driver) commands to the alarm unit installed in thecar.2. ControlsOne button with a “LOCK” iconFour numeric buttons “1”,”2”,”3”,”4”3. IndicatorOne RED LED indicator4. Arming the SystemPress the “LOCK” buttonThe “RED LED” on the RCU will blink to indicate transmissionThe alarm system will respond with two beeps of the siren, and by flashing the carlights twice.LEDBUTTONS
tTadiran Telematics proprietary 4Tadiran Telematics Ltd., 26 Hashoftim St., P.O.B. 267, Holon 58102, Israel Tel.: (972-3) 557-5750 Fax.: (972-3) 557-5753D:\Ready_To_Convert\Doc\123343.DOC5. Disarming the SystemPress the “LOCK” button followed by your “PESONAL DISARM CODE”The “RED LED” on the RCU will blink to indicate transmissionThe alarm system will respond with one beep of the siren, and by flashing the carlights.In case of a mistake start the procedure again by pressing the “LOCK” button.6. Battery ReplacementFor the replacement of the battery, proceed as follows:- Open the RCU by inserting a coin to the slot at the bottom left side ofthe RCU- Remove the rear cover- Remove the old battery by pushing it out- Insert a new battery with the (-) sign facing the board and the (+) sign pointing towards the spring. Make sure to use the right battery type 3v 190Mah Lithium Battery CR-2032

Navigation menu