ST Engineering Telematics Wireless TX5003 Remote Control Unit, Model Tx-5003 User Manual 5 pages
Telematics Wireless Ltd. Remote Control Unit, Model Tx-5003 5 pages
5 pages
t
Tadiran Telematics proprietary
1
Tadiran Telematics Ltd., 26 Hashoftim St., P.O.B. 267, Holon 58102, Israel
Tel.: (972-3) 557-5750 Fax.: (972-3) 557-5753
D:\Ready_To_Convert\Doc\123343.DOC
TX - 5003
RCU - Remote Control Unit
OPERATING INSTRUCTIONS
August 2000
DRAFT
TX5003 FCC ID: NTATX5003
Manufacturer: Tadiran Telematics Ltd.
This device complies with Part 15 of FCC Rules.
Operation is subjected to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received,
including Interference that may cause undesired operation.
t
Tadiran Telematics proprietary
2
Tadiran Telematics Ltd., 26 Hashoftim St., P.O.B. 267, Holon 58102, Israel
Tel.: (972-3) 557-5750 Fax.: (972-3) 557-5753
D:\Ready_To_Convert\Doc\123343.DOC
Table of Contents
Page
1. Description 3
2. Controls 3
3. Indicator 3
4. Arming the system 3
5. Disarming the system 4
6. Battery replacement 4
t
Tadiran Telematics proprietary
3
Tadiran Telematics Ltd., 26 Hashoftim St., P.O.B. 267, Holon 58102, Israel
Tel.: (972-3) 557-5750 Fax.: (972-3) 557-5753
D:\Ready_To_Convert\Doc\123343.DOC
1. Description
TX - 5003 is a transmitter for short - range wireless data application.
It is used to transfer the operator (driver) commands to the alarm unit installed in the
car.
2. Controls
One button with a “LOCK” icon
Four numeric buttons “1”,”2”,”3”,”4”
3. Indicator
One RED LED indicator
4. Arming the System
Press the “LOCK” button
The “RED LED” on the RCU will blink to indicate transmission
The alarm system will respond with two beeps of the siren, and by flashing the car
lights twice.
LED
BUTTONS
t
Tadiran Telematics proprietary
4
Tadiran Telematics Ltd., 26 Hashoftim St., P.O.B. 267, Holon 58102, Israel
Tel.: (972-3) 557-5750 Fax.: (972-3) 557-5753
D:\Ready_To_Convert\Doc\123343.DOC
5. Disarming the System
Press the “LOCK” button followed by your “PESONAL DISARM CODE”
The “RED LED” on the RCU will blink to indicate transmission
The alarm system will respond with one beep of the siren, and by flashing the car
lights.
In case of a mistake start the procedure again by pressing the “LOCK” button.
6. Battery Replacement
For the replacement of the battery, proceed as follows:
- Open the RCU by inserting a coin to the slot at the bottom left side of
the RCU
- Remove the rear cover
- Remove the old battery by pushing it out
- Insert a new battery with the (-) sign facing the board and the (+) sign
pointing towards the spring.
Make sure to use the right battery type
3v 190Mah Lithium Battery CR-2032