SUNLUX IOT TECHNOLOGY XL9530 Barcode Scanner User Manual

SUNLUX IOT TECHNOLOGY(GUANGDONG) INC. Barcode Scanner

User Manual

The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.CAUTIONNOTEThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interferencethat may cause undesired operation.InstallationInstallation procedure:1. Make sure that the scanner has the correct table for your system.2. Turn off the power of the system (or PC).3. Connect the Rj45 port of the cable to the tail of the receiver.4. Connect the R232/USB/PS2 port of the cable to the tail of the system (or PC).5. Turn on the power of the system (or PC).6. Make sure the host device have communication before transmitting data.IntroductionThe scanner read the 1D/2D barcode by capturing its image. it provides users with three scan modes, including Manual Mode, Sense Mode and Continuous Mode, tailored to different scanning needs. And the scanner decoded data transmitted to the receiver by wireless communication. The receiver transmit the data to the system(or PC) through the cable (RS232/USB /Ps2).The device wireless inductive charge without cable, just place the scanner on the receiver, it can charge.
Trigger Mode: A trigger pull activates a decode session. The decode session continues until the barcode is decoded or you release the trigger or decode session timeout expires. Sense Mode: The scanner waits for the image stabilization timeout to expire before activating a decode session every time it detects a change in ambient illumination. Decode session continues until the barcode is decoded or the decode session timeout expires. Continuous Mode: If the Continuous mode is enabled, the scanner automatically starts one decode session after another. To suspend/resume barcode reading, simply press the trigger. The ID card close to the the top of the scanner, the RFID reading module that in the scanner can read the ID card, and transfer the data to the receiver in 433MHz, and the receiver transfer data to the system (or PC) with RS232/USB/KB cable.Part three: RFID Module NOTE: This equipment has been tested and foundto comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limitsare designed to provide reasonable protection againstharmful interference in a residential installation. Thisequipment generates, uses and can radiate radiofrequency energy and, if not installed and used inaccordance with the instructions, may cause harmfulinterference to radio communications. However, thereis no guarantee that interference will not occur in aparticular installation. If this equipment does causeharmful interference to radio or television reception,which can be determined by turning the equipment offand on, the user is encouraged to try to correct theinterference by one or more of the following measures:-Reorient or relocate the receiving antenna.-Increase the separation between the equipment andreceiver.-Connect the equipment into an outlet on a circuitdifferent from that to which the receiver is connected.-Consult the dealer or an experienced radio/TV technicianfor help.

Navigation menu