SUNLUX IOT TECHNOLOGY XL9530 Barcode Scanner User Manual
SUNLUX IOT TECHNOLOGY(GUANGDONG) INC. Barcode Scanner
User Manual
The user is cautioned that changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
CAUTION
NOTE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference
that may cause undesired operation.
Installation
Installation procedure:
1. Make sure that the scanner has the correct table for your
system.
2. Turn off the power of the system (or PC).
3. Connect the Rj45 port of the cable to the tail of the
receiver.
4. Connect the R232/USB/PS2 port of the cable to the tail
of the system (or PC).
5. Turn on the power of the system (or PC).
6. Make sure the host device have communication before
transmitting data.
Introduction
The scanner read the 1D/2D barcode by capturing its
image. it provides users with three scan modes, including
Manual Mode, Sense Mode and Continuous Mode, tailored
to different scanning needs. And the scanner decoded data
transmitted to the receiver by wireless communication. The
receiver transmit the data to the system(or PC) through the
cable (RS232/USB /Ps2).
The device wireless inductive charge without cable, just
place the scanner on the receiver, it can charge.
Trigger Mode: A trigger pull activates a decode session.
The decode session continues until the barcode is
decoded or you release the trigger or decode session
timeout expires.
Sense Mode: The scanner waits for the image stabilization
timeout to expire before activating a decode session every
time it detects a change in ambient illumination. Decode
session continues until the barcode is decoded or the
decode session timeout expires.
Continuous Mode: If the Continuous mode is enabled, the
scanner automatically starts one decode session after
another. To suspend/resume barcode reading, simply press
the trigger.
The ID card close to the the top of the scanner, the RFID
reading module that in the scanner can read the ID card,
and transfer the data to the receiver in 433MHz, and the
receiver transfer data to the system (or PC) with
RS232/USB/KB cable.
Part three: RFID Module
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help.