Samsung Electronics Co SGHI307 Wireless Module with Multi-Band WCDMA/LTE User Manual
Samsung Electronics Co Ltd Wireless Module with Multi-Band WCDMA/LTE Users Manual
Users Manual
1SGH-I307 Installation Guide and User manual
SGH-I307
Installation Guide
Installation
Guide
And User Manual
1
2SGH-I307 Installation Guide and User manual
1. Introduction
The SGH-I307 Module is a module on board(MOB) that provides LTE and HSPA+ connectivity
for devices over several radio frequency bands
for
devices
over
several
radio
frequency
bands
.
The SGH-I307 will be AT&T-certified, and Windows 8 Mobile Broadband Interface Model(MBIM) compliant.
Supported RF bands
The modem, based on Qualcomm’s MDM9200 baseband processor,
Supports data operation on LTE and HSPA+ networks.
Technology Bands Notes
B d 4 (AWS)(1700/2100MH )
Table. Supported RF bands
LTE
•
B
an
d
4
(AWS)(1700/2100MH
z
)
•Band 17 (700MHz) MISO support
HSPA+
•Band 1 (2100MHz)
•Band 2 (1900MHz)
•
Band
5 (850MHz)
Diversity support
•
Band
5
(850MHz)
GNSS
•GPS (1575.42MHz)
•GLONASS (1602MHz)
2
3SGH-I307 Installation Guide and User manual
Physical features
•SGH-I307 : 50mm X 30mm X 2.7mm
•Operating temperature range : -20 to 60 Celsius temperature
Modem features
3
4SGH-I307 Installation Guide and User manual
4
5SGH-I307 Installation Guide and User manual
LTE features
•Basic cell selection and system acquisition
PSS/SSS/MIB d d
-
PSS/SSS/MIB
d
eco
d
e
- SIB1-SIB8, SIB10, SIB11 decoding
•NAS/AS security procedures
- Snow 3G/AES security
•CQI/RI/PMI reporting
•Paging procedures
- Paging in idle and Connected mode
•Dedicated bearer
- Network-initiated dedicated bearer
-
UE
-
initiated dedicated bearer
UE
initiated
dedicated
bearer
•Connected mode intra-LTE mobility
•iRAT between LTE/3G for idle and connection release with redirection
•Detach procedure
- Network-initiated detach with reattach required
Network
initiated detach followed by connection release
-
Network
-
initiated
detach
followed
by
connection
release
5
6SGH-I307 Installation Guide and User manual
Position location (GNSS)
•Concurrent standalone GPS and GLONASS
•Assisted GPS ( A-GPS) SUPL1.0
•Assisted GNSS ( A-GPS) SUPL2.0
•gpsOneXTRA2.0 with GPS + GLONASS support
Standards Compliance
The SGH-I307 Module com
p
lies with the mandator
y
re
q
uirements described in the followin
g
standards.
pyq g
The exact set of requirements supported is carrier-dependent.
6
7SGH-I307 Installation Guide and User manual
2. PCB guide
RF Connector
Diversity+GPS
RF
Connector
Ct
C
onnec
t
or
to Main PCB
Main
7
8SGH-I307 Installation Guide and User manual
RF Connector
RF
Connector
①
Housing
①
Housing
②Contact
③ Ground Contact
8
9SGH-I307 Installation Guide and User manual
3. Applicable Device
SGH-I307 is a just RF module.
if ifiddi blibll idihih Sif
It
i
s not
f
or spec
ifi
e
d
d
ev
i
ce. It can
b
e app
li
ca
bl
e to e
l
ectron
i
c
d
ev
i
ces w
hi
c
h
use U
S
B
i
nter
f
ace.
But the manufacturer has to make sw for control MDM9200, main modem.
Technology
Bands
Notes
Technology
Bands
Notes
LTE
•Band 4 (AWS)(1700/2100MHz)
•Band 17 (700MHz) MISO support
•Band 1 (2100MHz)
HSPA+ •Band 2 (1900MHz)
•Band 5 (850MHz)
Diversity support
GNSS
•GPS (1575.42MHz)
•GLONASS (1602MHz)
9
10 SGH-I307 Installation Guide and User manual
4. Block diagram
10
11 SGH-I307 Installation Guide and User manual
5. SGH-I307 Interface
70pin connector to main PCB
I307
module
Main PCB
11
12 SGH-I307 Installation Guide and User manual
Connector pin assignment
Connector
pin
assignment
12
13 SGH-I307 Installation Guide and User manual
13
14 SGH-I307 Installation Guide and User manual
14
15 SGH-I307 Installation Guide and User manual
15
16 SGH-I307 Installation Guide and User manual
USB interface
The USB interface is the path for communication between the host and module.
The interface com
p
lies with the Universal Bus S
p
ecification, Rev2.0, and the host device must be
pp
Designed to the same standard.
(When designing the host device, careful PCB layout practices must be followed)
USB interface
16
17 SGH-I307 Installation Guide and User manual
SIM interface
The module supports one SIM(Subscriber Identity Module)(1.8V or 3V).
The SIM holds account information, allowing users to use their account on multiple devices.
The SIM pins provide the connections necessary to interface to a SIM socket located on the host device.
Voltage levels over this interface comply with 3GPP standards.
SIM interface signal
SIM
interface
signal
17
18 SGH-I307 Installation Guide and User manual
Critical Installation Requirements
This device is approved for use as a mobile installation meaning that it will only be used in products
That are capable of maintaining a minimum separation distance of 20cm from the antenna(s) of this
Device and end user.
When installed in a final configuration the antenna must be installed such that a minimum separation
Of 20cm(8 inches) between the wireless device and the body of the user(this does not include extremities)
must be maintained during use and while the wireless device is on and transmitting.
This distance must be ensured for all operating modes and conditions
This
distance
must
be
ensured
for
all
operating
modes
and
conditions
.
This transmitter must not be collocated or operate in conjunction with any other antenna or transmitter.
Installations in which the device is collocated with other transmitters or the minimum separation distance
B t th b d d t ( ) t b i t i d i t FCC th i ti
B
e
t
ween
th
e
b
o
d
y an
d
an
t
enna
(
s
)
can no
t
b
e ma
i
n
t
a
i
ne
d
requ
i
re a separa
t
e
FCC
au
th
or
i
za
ti
on.
Such installations may require additional testing for RF Exposure(i.e. SAR) and a Class II Permissive Change
Filling for FCC approval. Please contact Samsung Electronics, Ltd. Regarding such installations.
A label must be affixed to the outside of the end product into which the Module is installed,
with a statement similar to the following:· This device contains FCC ID: A3LSGHI307
Antenna Requirements
To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition must not
exceed 1.4dBi in WCDMA Band2/5, LTE Band 4 and LTE Band 17.
18
19 SGH-I307 Installation Guide and User manual
Note
If this module is intended for use in a portable device, you are responsible for separate approval
to satisfy the SAR requirements of FCC Part 2.1093.
19