Samsung Electronics Co SGHI307 Wireless Module with Multi-Band WCDMA/LTE User Manual

Download:
Mirror Download [FCC.gov]
Document ID	1737376
Application ID	/G9HK3EMxcSevYTu9ORD/Q==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	88.25kB (1103082 bits)
Date Submitted	2012-07-05 00:00:00
Date Available	2013-01-01 00:00:00
Creation Date	2017-10-31 01:05:50
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-10-31 01:05:50
Document Title	Microsoft PowerPoint - 8 SGH-I307_Install Guide_20120702.pptx
Document Creator	PScript5.dll Version 5.2.2
Document Author:	ducksu05.kim

SGH-I307 Installation Guide and User manual
SGH-I307
Installation Guide
And User Manual
2
SGH-I307 Installation Guide and User manual
1. Introduction
The SGH-I307 Module is a module on board(MOB) that provides LTE and HSPA+ connectivity
for devices over several radio frequency bands
bands.
The SGH-I307 will be AT&T-certified, and Windows 8 Mobile Broadband Interface Model(MBIM) compliant.
Supported RF bands
The modem, based on Qualcomm’s MDM9200 baseband processor,
Supports data operation on LTE and HSPA+ networks.
Table. Supported RF bands
Technology
Bands
Notes
LTE
Band
d 4 (AWS)(1700/2100MH
(AWS)(1700/2100MHz))
• B
• Band 17 (700MHz)
MISO support
HSPA+
• Band 1 (2100MHz)
• Band 2 (1900MHz)
• Band 5 (850MHz)
Diversity support
GNSS
• GPS (1575.42MHz)
• GLONASS (1602MHz)
3
SGH-I307 Installation Guide and User manual
Physical features
• SGH-I307 : 50mm X 30mm X 2.7mm
• Operating temperature range : -20 to 60 Celsius temperature
Modem features
4
SGH-I307 Installation Guide and User manual
5
SGH-I307 Installation Guide and User manual
LTE features
• Basic cell selection and system acquisition
- PSS/SSS/MIB d
decode
- SIB1-SIB8, SIB10, SIB11 decoding
• NAS/AS security procedures
- Snow 3G/AES security
• CQI/RI/PMI reporting
• Paging procedures
- Paging in idle and Connected mode
• Dedicated bearer
- Network-initiated dedicated bearer
- UE
UE-initiated
initiated dedicated bearer
• Connected mode intra-LTE mobility
• iRAT between LTE/3G for idle and connection release with redirection
• Detach procedure
- Network-initiated detach with reattach required
- Network-initiated
Network initiated detach followed by connection release
6
SGH-I307 Installation Guide and User manual
Position location (GNSS)
•
•
•
•
Concurrent standalone GPS and GLONASS
Assisted GPS ( A-GPS) SUPL1.0
Assisted GNSS ( A-GPS) SUPL2.0
gpsOneXTRA2.0 with GPS + GLONASS support
Standards Compliance
The SGH-I307 Module complies
with the mandatoryy requirements
described in the following
g standards.
The exact set of requirements supported is carrier-dependent.
7
SGH-I307 Installation Guide and User manual
2. PCB guide
RF Connector
Diversity+GPS
Connector
to Main PCB
Main
8
SGH-I307 Installation Guide and User manual
RF Connector
① Housing
② Contact
③ Ground Contact
9
SGH-I307 Installation Guide and User manual
3. Applicable Device
SGH-I307 is a just RF module.
It is
i not ffor specified
ifi d d
device.
It can b
be applicable
li bl to electronic
i d
devices
which
hi h use USB
S iinterface.
But the manufacturer has to make sw for control MDM9200, main modem.
Technology
Bands
Notes
LTE
• Band 4 (AWS)(1700/2100MHz)
• Band 17 (700MHz)
MISO support
HSPA+
• Band 1 (2100MHz)
• Band 2 (1900MHz)
• Band 5 (850MHz)
Diversity support
GNSS
• GPS (1575.42MHz)
• GLONASS (1602MHz)
10
SGH-I307 Installation Guide and User manual
4. Block diagram
10
11
SGH-I307 Installation Guide and User manual
5. SGH-I307 Interface
70pin connector to main PCB
Main PCB
11
I307
module
12
SGH-I307 Installation Guide and User manual
Connector pin assignment
12
13
13
SGH-I307 Installation Guide and User manual
14
14
SGH-I307 Installation Guide and User manual
15
15
SGH-I307 Installation Guide and User manual
16
SGH-I307 Installation Guide and User manual
USB interface
The USB interface is the path for communication between the host and module.
with the Universal Bus Specification,
Rev2.0, and the host device must be
The interface complies
Designed to the same standard.
(When designing the host device, careful PCB layout practices must be followed)
USB interface
16
17
SGH-I307 Installation Guide and User manual
SIM interface
The module supports one SIM(Subscriber Identity Module)(1.8V or 3V).
The SIM holds account information, allowing users to use their account on multiple devices.
The SIM pins provide the connections necessary to interface to a SIM socket located on the host device.
Voltage levels over this interface comply with 3GPP standards.
SIM interface signal
17
18
SGH-I307 Installation Guide and User manual
Critical Installation Requirements
This device is approved for use as a mobile installation meaning that it will only be used in products
That are capable of maintaining a minimum separation distance of 20cm from the antenna(s) of this
Device and end user.
When installed in a final configuration the antenna must be installed such that a minimum separation
Of 20cm(8 inches) between the wireless device and the body of the user(this does not include extremities)
must be maintained during use and while the wireless device is on and transmitting.
This distance must be ensured for all operating modes and conditions.
conditions
This transmitter must not be collocated or operate in conjunction with any other antenna or transmitter.
Installations in which the device is collocated with other transmitters or the minimum separation distance
B t
Between
th
the body
b d and
d antenna(s)
( ) can nott be
b maintained
i t i d require
i a separate
t FCC authorization.
th i ti
Such installations may require additional testing for RF Exposure(i.e. SAR) and a Class II Permissive Change
Filling for FCC approval. Please contact Samsung Electronics, Ltd. Regarding such installations.
A label must be affixed to the outside of the end product into which the Module is installed,
with a statement similar to the following:· This device contains FCC ID: A3LSGHI307
Antenna Requirements
To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition must not
exceed 1.4dBi in WCDMA Band2/5, LTE Band 4 and LTE Band 17.
18
19
SGH-I307 Installation Guide and User manual
Note
If this module is intended for use in a portable device, you are responsible for separate approval
to satisfy the SAR requirements of FCC Part 2.1093.
19

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Author                          : ducksu05.kim
Create Date                     : 2012:07:02 13:16:50+09:00
Modify Date                     : 2012:07:02 12:38:29-04:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Creator Tool                    : PScript5.dll Version 5.2.2
Metadata Date                   : 2012:07:02 12:38:29-04:00
Producer                        : Acrobat Distiller 9.5.0 (Windows)
Format                          : application/pdf
Title                           : Microsoft PowerPoint - 8  SGH-I307_Install Guide_20120702.pptx
Creator                         : ducksu05.kim
Document ID                     : uuid:c6af1435-bda6-44a8-9e14-8c91b2be3870
Instance ID                     : uuid:8dcc9e8d-9fbb-4f98-bb1b-96a6b3a139c9
Page Count                      : 19

EXIF Metadata provided by EXIF.tools