Schindler elevators PORT312VER1 Access Control User Manual

Schindler elevators Ltd Access Control

User manual

Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.0 1/2011 1/13PORT 3.1User and maintenance Manual v.1.0
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 2/13Safety Instructions Always read the safety instructions carefully Keep this User’s Manual for future reference Keep this equipment away from humidity If any of the following situation arises, get the equipment checked by a service technician: • The equipment has been exposed to moisture. • The equipment has been dropped and damaged. • The equipment has obvious sign of breakage. • The equipment has not been working well or you cannot get it work according to User’s Manual. Copyright Statement No part of this publication may be reproduced in any form by any means without the prior written permission. Other trademarks or brand names mentioned herein are trademarks or registered trademarks of their respective companies. Disclaimer Information in this document is subject to change without notice. The manufacturer does not make any represen-tations or warranties (implied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit or any commercial damage, including but not limited to special, inci-dental, consequential, or other damage. Maintenance and troubleshooting Software update and troubleshooting has to be executed only by Schindler qualified operators.No manipulation of the Terminal are allowed by no qualified Schindler operator.
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 3/13Index:1 Introduction ..................................................................................................................................................41.1 Application...........................................................................................................................................41.2 Features...............................................................................................................................................41.3 Functionalities......................................................................................................................................41.4 Package contents.................................................................................................................................42 Installation and cabling.................................................................................................................................52.1 Cabling: ...............................................................................................................................................83 Characteristics:.............................................................................................................................................93.1 Port 3.1 characteristics:........................................................................................................................94 Power Supply, Communication connection:..................................................................................................95 Operating conditions:....................................................................................................................................96 Mechanics and construction:.......................................................................................................................107 Regulatory Compliance ..............................................................................................................................117.1 EMC and safety compliance...............................................................................................................117.2 CE .....................................................................................................................................................11European mark according to UE directives, Expert Opinion issued by: .......................................................11Italian Institute IMQ SpA.............................................................................................................................117.3 CSA ...................................................................................................................................................117.4 FCC ...................................................................................................................................................127.5 WEEE Information.............................................................................................................................127.6 RoHS Information ..............................................................................................................................128 Support and trouble shooting......................................................................................................................13
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 4/131 IntroductionThis document is a general description of the PORT device; type PORT 3.1.(PORT: Personal Occupant Requirement Terminal)The version called PORT 3.2 differs from PORT 3.1 only by the absence of keypad.1.1 ApplicationWhen you are committed to providing continuous service to a building's occupants as they go about their busi-ness, it is essential to have a consistent method of communicating with them. The extraordinary new PORT system can provide a whole range of command and communication functions from a wide variety of locations. Functions that utilize a standard hardware design which is as reliable as it is elegant. PORT 3.1 represents one such interface device with a specific application to allow entry.1.2 FeaturesThe PORT 3.1 features an elegant combination of card reader, keypad and LED indication which may be used to control access.The version called PORT 3.2 differs from PORT 3.1 only by the absence of keypad.1.3 FunctionalitiesThe PORT 3.1 device is used to control access through a door system utilizing either a proximity card, a pre-programmed pin code or a combination of both.The system is used to get access to the building. Any kind of Building can be considered for example Office, Hotel or Apartment.PORT 3.1 is a fully integrated component of The PORT Technology.1.4 Package contents1 x PORT 3.1 Card Reader Terminal1 x Damping Pad 1 x Signal + Supply cable1 x Wall mounted fastening material1 x Small user and maintenance manual (this manual)1 x Lock Tool (partly)
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 5/132 Installation and cabling
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 6/13
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 7/13
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 8/132.1 Cabling:Standard Cable length 10 m.Note: The AUXILIARY 24VDC input should not be used. If used a cable of MAXIMUM 3 m length is allowed.
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 9/133 Characteristics:3.1 Port 3.1 characteristics:Picture CharacteristicsName PORT 3.1Power Supply 24 DVC +/- 10%Energy Consumption max. 2 WAmbient LED RGB ColoursCPU ATMEL ATMEGA64 /Operating system -Standby modus yes (if no card present or no button pushed)Card Reader Frequency 13,56 MHz (RFID)Card Reader Protocols ISO14443A, ISO14443B-2B, ISO144443B-3B, ISO15693Standard Card Types Mifare Classic, Mifare Ultra Light, Mifare 1K, Mifare 4K, Mi-fare DESFire (all other cards have to be pre-qualified by out test service center before use!)Beeper confirmation/alarmNetwork Serial UART connection4 Power Supply, Communication connection:Power supply Power supply Input Communication ETH24 VDC +/- 10%< 2 W connector 24VDC INPin1 +Pin 2, Pin 3 -connector ETH-Aconnector ETH-B5 Operating conditions:Humidity: max 90 %, protection rating IP53Operating Temperature -10 to 60°C (14 to 140 °F)Storage temperature -40 – 85 °CDamage danger: Do not exceed these limits. Operating failure could occur!
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 10/136 Mechanics and construction:PORT 3.1 mechanical drawing:
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 11/137 Regulatory Compliance 7.1 EMC and safety complianceThis equipment has been tested and found to comply with the above rules. Important! Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment. Use an approved phone set. 7.2 CE0051European mark according to UE directives, Expert Opinion issued by:Italian Institute IMQ SpAA valid CE Marking affixed to a product indicates that it complies with the relevant European 'New Approach' product safety Directives.7.3 CSAC USSafety mark according to United States and Canadian standards issued by CSA InternationalCSA can test and certify products you are selling at home or exporting to the U.S.A. and Canada, eliminating the need for duplicate testing - saving you time and money. We test products to Canadian and U.S. standards and issue the CSA Mark for qualified products. CSA International can also test products to European and other na-tional standards.
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 12/137.4 FCCLabel printed on product, refer to FCC Grantee Code:FCC ID: XFIPORT312VER1This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.7.5 WEEE Information For EU (European Union) member users: According to the WEEE (Waste electrical and electronic equipment) Directive, do not dispose of this product as household waste or commercial waste. Waste electrical and elec-tronic equipment should be appropriately collected and recycled as required by practices established for your country. For information on recycling of this product, please contact your local authorities, your household waste disposal service or the shop where you purchased the product.7.6 RoHS Information RoHS, also known as Lead-Free, stands for Restriction of Hazardous Substances. RoHS Directive 2002/95/EC restricts the use of six hazardous materials found in electrical and electronic products. All applicable products in the EU market after July 1, 2006 must pass RoHS compliance. RoHS impacts the entire electronics industry.
Schindler Elevators Ltd.NT-NBvia della Pace 22CH-6600 Locarnowww.schindler.comPORT 3.1Basic user and maintenace ManualVersion 1.1 5/2010 13/138 Support and trouble shootingHotline Locarno:Schindler Elevators Ltdvia della Pace 22CH-6600 Locarnoemail: hotline_locarno@ch.schindler.comTel: +4191 756 97 85FAX: +4191 756 97 54Compliance testing and certification of the product have been carried out and coordi-nated by Tecnolab del Lago Maggiore Srl, located in Verbania (ITALY).

Navigation menu