Secure Wireless EV-F319 Wireless Remote Control Transmitter User Manual 6658 SW Evol Manual

Secure Wireless, Inc Wireless Remote Control Transmitter 6658 SW Evol Manual

User Manual

LOW BATTERY INDICATIONLED will flash to indicate that Low Battery Supervisionhas been sent and the battery should be replaced.WARRANTYSecure Wireless offers a Lifetime Warranty on thisproduct. Secure Wireless agrees to repair or replace thisproduct at no cost to the user. For return authorizationplease contact: Secure Wireless1185 Park Center Drive, Suite A/B Vista, CA 92083(760) 727-0601This device complies with part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation.4 Button Wireless TransmitterFor use with Part #s: EV-F319/EV- F345/EV-F433USER MANUALButton 1Button 3Button 2Button 46658-SW-Evol Manual 10/7/02 10:05 PM Page 1Caution: Any changes or modifications not expresslyapproved by Secure Wireless could void user's authorityto operate the equipment.
I . Programming the Remote into the Alarm SystemRefer to the programming guide that came with youralarm system for programming a wireless device (KEYFOB) into the security system.II. Changing Panic Operation to Delay Mode or Instant ModeNote: To use this feature you must have programmedbutton 4 into the alarm panel as “PANIC”. The 3 seconddelay is the factory default.SETTING PANIC BUTTON FOR DELAY TRANSMISSION MODE(By selecting this feature, the user must hold down panicbutton for 3 seconds before transmission is sent.)1. Press all 4 button at the same time until the LED begins to flash. (This will take approximately 3 seconds before LED flashes.)2. Release all 4 buttons 3. Press Button 2 (TOP RIGHT BUTTON)4. LED should stop flashingSETTING PANIC BUTTON INTO INSTANCE TRANSMISSION MODE1. Press all 4 button at the same time until the LED begins to flash. (This will take approximately 3 seconds before LED flashes.)2. Release all 4 buttons 3. Press Button 1 (TOP LEFT BUTTON)4. LED should stop flashing6658-SW-Evol Manual 10/7/02 10:05 PM Page 2

Navigation menu