Secure Wireless GB319 Wireless Glass Break User Manual

Secure Wireless, Inc Wireless Glass Break

User manual

SW-NAP-GB Glass Break NAPCO COMPATIBLE INSTALLATION MANUAL TECHNICAL SUPPORT Secure Wireless 866-908-Tech www.mysecurewireless.com GLASS BREAK ENROLLMENT PROGRAMMING For a detail programming guide, the instruction manual should be consulted for that panel. The below guide should only be used as a reference and not as a replacement for using the programming instructions. 1. ENTER Panel Programming 2. SELECT Zone # 3. ENTER 6 Digit Id Number ( located on back of unit) 4. ENTER Check sum (0-9 ; A-F) (located on back on unit. Digit that follows “:” on the Serial ID 5. ENTER Point “3” – for Glass Break 6. Push On/Off to Save Alpha Chart A - *0 C - *2 E - *4 B - *1 D- * 3 F - * 5 Glass Type and Thickness Plate 1/8 in to ¼ in Tempered 1/8 in to ¼ in Sealed Insulating 1/8 to ¼ in REPLACING THE BATTERY Remove the detector from the base by turning counterclockwise. Replace with 2 CR123A batteries. Observe the polarity when replacing the batteries FCC Compliance This device complies with Part 15 FCC Rules. Operation complies with the following 2 conditions (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. MODEL SW-NAP-GB FCC ID QNP-GB319 FREQUENCY 319.5 MHz WARRANTY Limited Life Time BATTERY (2) CR123A Panasonic MANUAL PART # 200-10008 Rev C MOUNTING INSTRUCTIONS 1. Place the Glass Break Detector base on the opposite wall or adjacent wall to the window being protected (Distance 15 Ft maximum) 2. Attach to the wall using the supplied screws. The test button should be facing the floor 3. When attaching the detector to the base, match up to the alignment mark and turn clockwise FUNCTIONAL TEST: Push the test button for 2 seconds and then release. The red LED will light while the button is pressed. The green LED will blink once to indicate that the unit is in auto test mode for 90 seconds. 1. Use a glass break simulator to test the unit. LED will flash green first then will flash LED to indicate the glass breaking. WIRELESS RANGE TEST: Push and hold the test button for 5 seconds and release, The LED will flash while the button is pressed. The green LED will blink twice to indicate that the unit is in RF test mode for 90 seconds.

Navigation menu