Secure Wireless SDW319 Door Window Sensor User Manual Manual

Secure Wireless, Inc Door Window Sensor Manual

Manual

SW-NAP-SDW Slim Door Window Sensor NAPCO COMPATIBLE INSTALLATION MANUAL TECHNICAL SUPPORT Secure Wireless 866-908-Tech www.mysecurewireless.com SLIM DOOR WINDOW SENSOR ENROLLMENT / PROGRAMMING The SW-NAP-SDW Door Window is equipped with an internal reed switch as well as the ability to use as external magnet . For a detail programming guide, the instruction manual should be consulted for that panel. The below guide should only be used as a reference and not as a replacement for using the programming instructions. 1. Pull Battery Tab 2. ENTER PANEL PROGRAMMING 3. ENTER Zone 4. ENTER Serial ID ( Auto-learn or Manual) To Auto-Learn Hit “Bypass” Fault and Restore the device or the tamper switch can be used. To Manual Learn Enter serial Id listed on back) Enter Checksum ( digit after the “:” on Serial ID) 5. ENTER POINT (1 for Internal Reed or 2 for External ) 6. Push ON/OFF to Save REPLACING THE BATTERIES Pop open the case using a coin. Replace with new batteries. ( + ) or positive polarity should be facing up Replace Cover FCC Compliance This device complies with Part 15 FCC Rules. Operation complies with the following 2 conditions (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation ODEL SW-NAP-SDW FCC ID QNP-SDW319 FREQUENCY 319.5 MHz WARRANTY Limited Life time BATTERY (2) CR2032 Replace with Panasonic MANUAL PART # 200-10003 Rev A Alpha Chart A - *0 B - *1 C -*2 D - *3 E - *4 F - *5 DOOR WINDOW MOUTING / USAGE The SW-NAP-SDW Door Window is equipped with an internal reed switch as well as the ability to use an external magnet. Mounting Double Sided Tape is included for easy installation. Reed Switch (Use Point 1 when Programming ) Align the Arrow on magnet with the 3 lines on the side of the sensor case Mount the magnet no more than ¼ in from the sensor. External (Use Point 2 when programming Wire run to the External Magnet can be no longer than 12 Ft in length.

Navigation menu