Shintom Co T3017 Mobile Cellular Telephone User Manual Inst Guide Cover

Download:
Mirror Download [FCC.gov]
Document ID	240124
Application ID	QD/Y7r4AOoRjN9pwRsyn7A==
Document Description	EXHIBIT 6 Revised portion of Installation Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	22.2kB (277459 bits)
Date Submitted	2002-05-01 00:00:00
Date Available	2002-09-17 00:00:00
Creation Date	2002-03-13 13:59:42
Producing Software	Acrobat Distiller 4.05 for Macintosh
Document Lastmod	2002-04-30 18:26:49
Document Title	Inst.Guide_Cover
Document Creator	PageMaker 6.5J
Document Author:	n-satake

INSTALLATION GUIDE FOR
CELLULAR CAR TELEPHONE
555 Wireless Blvd., Hauppauge, NY 11788
288E9930
Important
There are some basic rules that apply to most hardware installation procedures
and need to be observed to prevent damage or injury.
1.
Always make sure that any power is disconnected to the vehicle before handling any
electrical components like wiring, fuseboxes, connectors, etc.
2.
Never force any connection between components, electrical connectors or the like.
3.
Always use the proper tools for the task at hand. Using improper tools may cause
damage to yourself, your vehicle, or your cellular telephone system.
4.
Think through all the necessary steps of installation before actually beginning the
procedure and equip yourself for all steps to be performed.
5.
Always make sure your workspace and your tools are clean and tidy. The
introduction of dirt or grease may hinder the performance of your cellular telephone
and related components.
Installation Procedure
1. Before we begin
You will need the following items in order to properly install the cellular telephone in the
trunk of an automobile.
• Your CMT9300 kit includes the following parts:
1. Cradle
(CR93)
2. Mount Bracket
(MT93)
3. Power Cable
(EPC91)
4. Extension Cable
(EIC91)
5. Clamshell
(CM5)
6. Screw kit
(SK93)
7. HF Microphone
(MIC40)
8. Installation Manual
(IMCMT9300)
• Your CMT9300 kit does not include the following parts:
9. Stand for Cradle
10. Screw (M5 × 25)
Inst.Guide_body
Page 1
02.4.3, 11:38 AM
Adobe PageMaker 6.5J/PPC
2. Mount the Transceiver unit
To install the cellular telephone with the transceiver unit located in the trunk-space of the
automobile follow the steps outlined below.
a. Place the mounting bracket so that the
four bracket holes line up with the transceiver holes.
b. Replace the four screws (supplied M4
8mm) in the screw kit so that the mounting bracket is secured to the transceiver
unit.
c. Place the unit top-side up (bracket feet
down), utilizing the included flatwashers,
insert the four self-tapping screws (M5X
25mm is recommended) and tighten them
down.
3. Wiring
a. Connect the cables to the mounted transceiver unit using the supplied trunk mount
extension cable as illustrated.
Car Battery
Antenna Terminal
Ground (Black)
Back up (Red)
Ignition (Orange)
Curly Cord
Socket
Microphone Unit Jack
Power Cable Socket
Hand Set
Cradle
Extension Cable
Hands-Free Mic
fuse 3A
Power Cable
fuse 1A
Extension cord
Red
Antenna
Orange
Black
Transceiver unit
Inst.Guide_body
Page 2
02.4.3, 11:38 AM
Adobe PageMaker 6.5J/PPC
4. Mount the Cradle and Handset
a. Using a pedestal mount. The cradle unit
can be mounted as displayed. Be sure
to use only supplied M4 x 8mm screws.
Using improper screws will damage the
cradle unit.
b. Plug in the handset and Hands-Free
Mic.
Hands-Free Mic
c. Check to make sure ALL signal and
power leads are in place and properly
connected.
Inst.Guide_body
Page 3
02.4.3, 11:38 AM
Adobe PageMaker 6.5J/PPC
5. Antenna
The following are recommended antenna and cable installation instruction for Transceiver unit. These instructions must be followed in order to comply with the FCC RF
exposure requirements.
• Standard type 1
Antenna type :
Mount location :
Antenna cable :
Glass mount type (“thru–glass” antenna) - Colinear
Rear window of a vehicle
RG-58/U 8 feet (2.44m) or longer
Install the antenna on the upper position of the rear window and centered as shown
in the diagram below.
Antenna
Antenna
Rear window
Rear window
Transceiver unit
Coaxial cable
RG-58/U
8 feet or longer
• Standard type 2
Antenna type :
Mount location :
Antenna cable :
Roof top mount type-1/4l Mono Pole
Roof top of a vehicle
SUMITOMO 2.4DS-FXL (or 2.4DS-GXLA) 10 feet (3.05m) or
longer
Install the antenna near the roof top rear and centered as shown in the diagram
below.
Roof Top
Antenna
Antenna
Transceiver unit
Coaxial cable
Inst.Guide_body
Page 4
02.4.3, 1:34 PM
Adobe PageMaker 6.5J/PPC
• Standard type 3
Antenna type :
Mount location :
Antenna cable :
Colinear
On the right of trunk lid
SUMITOMO 2.5DS-GXCA 8.85 feet (2.7m) or equivalent
Install the antenna on the right position of the trunk lid as shown in the diagram
below.
Rooftop
Rear window
Antenna
Antenna
Coaxial cable
Transceiver unit
• Standard type 4
Antenna type :
Mount location :
Antenna cable :
Roof top mount type-1/4l Mono Pole
Roof top of a vehicle
SUMITOMO 2.5DS-GXCA 14.76 feet (4.5m) or equivalent
Install the antenna on the left position of the roof top as shown in the diagram
below.
Antenna
Rooftop
Antenna
Transceiver unit
Coaxial cable
Inst.Guide_body
Page 5
02.4.8, 10:38 AM
Adobe PageMaker 6.5J/PPC

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Create Date                     : 2002:03:13 13:59:42
Producer                        : Acrobat Distiller 4.05 for Macintosh
Author                          : n-satake
Creator                         : PageMaker 6.5J
Title                           : Inst.Guide_Cover
Modify Date                     : 2002:04:30 18:26:49+09:00
Page Count                      : 6

EXIF Metadata provided by EXIF.tools