Shintom Co T3017 Mobile Cellular Telephone User Manual Inst Guide Cover

Shintom Co Ltd Mobile Cellular Telephone Inst Guide Cover

EXHIBIT 6 Revised portion of Installation Manual

INSTALLATION GUIDE FORCELLULAR CAR TELEPHONE555 Wireless Blvd., Hauppauge, NY 11788 288E9930
1ImportantThere are some basic rules that apply to most hardware installation proceduresand need to be observed to prevent damage or injury.1. Always make sure that any power is disconnected to the vehicle before handling anyelectrical components like wiring, fuseboxes, connectors, etc.2. Never force any connection between components, electrical connectors or the like.3. Always use the proper tools for the task at hand. Using improper tools may causedamage to yourself, your vehicle, or your cellular telephone system.4. Think through all the necessary steps of installation before actually beginning theprocedure and equip yourself for all steps to be performed.5. Always make sure your workspace and your tools are clean and tidy. Theintroduction of dirt or grease may hinder the performance of your cellular telephoneand related components.Installation Procedure1. Before we beginYou will need the following items in order to properly install the cellular telephone in thetrunk of an automobile.• Your CMT9300 kit includes the following parts:1. Cradle (CR93)2. Mount Bracket (MT93)3. Power Cable (EPC91)4. Extension Cable (EIC91)5. Clamshell (CM5)6. Screw kit (SK93)7. HF Microphone (MIC40)8. Installation Manual (IMCMT9300)• Your CMT9300 kit does not include the following parts:9. Stand for Cradle10. Screw (M5 × 25)Inst.Guide_body 02.4.3, 11:38 AMPage 1 Adobe PageMaker 6.5J/PPC
22. Mount the Transceiver unitTo install the cellular telephone with the transceiver unit located in the trunk-space of theautomobile follow the steps outlined below.a. Place the mounting bracket so that thefour bracket holes line up with the trans-ceiver holes.b. Replace the four screws (supplied M4 8mm) in the screw kit so that the mount-ing bracket is secured to the transceiverunit.c. Place the unit top-side up (bracket feetdown), utilizing the included flatwashers,insert the four self-tapping screws (M5X25mm is recommended) and tighten themdown.OrangeExtension CablePower Cablefuse 3Afuse 1A RedBlack3. Wiringa. Connect the cables to the mounted transceiver unit using the supplied trunk mountextension cable as illustrated.Car BatteryGround (Black)Back up (Red)Ignition (Orange)Extension cordHands-Free MicCradleHand SetTransceiver unitAntennaAntenna TerminalPower Cable SocketMicrophone Unit JackCurly CordSocketInst.Guide_body 02.4.3, 11:38 AMPage 2 Adobe PageMaker 6.5J/PPC
34. Mount the Cradle and Handseta. Using a pedestal mount. The cradle unitcan be mounted as displayed. Be sureto use only supplied M4 x 8mm screws.Using improper screws will damage thecradle unit.b. Plug in the handset and Hands-FreeMic.c. Check to make sure ALL signal andpower leads are in place and properlyconnected.Hands-Free MicInst.Guide_body 02.4.3, 11:38 AMPage 3 Adobe PageMaker 6.5J/PPC
45. AntennaThe following are recommended antenna and cable installation instruction for Trans-ceiver unit. These instructions must be followed in order to comply with the FCC RFexposure requirements.• Standard type 1Antenna type : Glass mount type (“thru–glass” antenna) - ColinearMount location : Rear window of a vehicleAntenna cable : RG-58/U 8 feet (2.44m) or longerInstall the antenna on the upper position of the rear window and centered as shownin the diagram below.• Standard type 2Antenna type : Roof top mount type-1/4l Mono PoleMount location : Roof top of a vehicleAntenna cable : SUMITOMO 2.4DS-FXL (or 2.4DS-GXLA) 10 feet (3.05m) orlongerInstall the antenna near the roof top rear and centered as shown in the diagrambelow.Rear windowTransceiver unitAntennaCoaxial cableRG-58/U8 feet or longerRear windowAntennaTransceiver unitRoof Top AntennaCoaxial cableAntennaInst.Guide_body 02.4.3, 1:34 PMPage 4 Adobe PageMaker 6.5J/PPC
5• Standard type 3Antenna type : ColinearMount location : On the right of trunk lidAntenna cable : SUMITOMO 2.5DS-GXCA 8.85 feet (2.7m) or equivalentInstall the antenna on the right position of the trunk lid as shown in the diagrambelow.• Standard type 4Antenna type : Roof top mount type-1/4l Mono PoleMount location : Roof top of a vehicleAntenna cable : SUMITOMO 2.5DS-GXCA 14.76 feet (4.5m) or equivalentInstall the antenna on the left position of the roof top as shown in the diagrambelow.AntennaRooftopTransceiver unitAntennaCoaxial cableAntennaRooftopTransceiver unitAntennaCoaxial cableRear windowInst.Guide_body 02.4.8, 10:38 AMPage 5 Adobe PageMaker 6.5J/PPC

Navigation menu