Skytech II TS-R-1 Digital Thermostat Transmitter User Manual SS

Skytech II, Inc. Digital Thermostat Transmitter SS

User Manual

SKYTECH II, INC9230 Conservation Way, Fort Wayne, FCC ID: K9LTS-R-1In 46809, USATel: 260-459-1703Fax: 260-459-1592SKY TS/R-1 Digital Thermostat USER MANUAL1) Rear Case- press ON/OFF(ON-the back left button, OFF- the back right button)at the same time to change C or F2) Front Case- move rod to OFF then send 3 times OFF signal to receiver3) Front Case- move rod to ON then send 3 times ON signal to receiver4) Front Case- move rod between OFF & ON for adjusting desire temperature.When temperature below adjusted temperature then it will turn on receiver with flame icon after 2 minutes. When temperature higher than adjusted temperaturethen it will disable the flame icon then turn off the receiver. It will have SET icon when rod was moved between ON & OFF scale.The action of SKY TS/R-1 Use component RT-103AT to sense the temperature and compare with ROD SETTING temperaturewhich setting by users. When setting temperature below the room temperature then transmitter will send 3 timessignals to turn on the receivers. If SETTING temperature is higher than room temperature then transmitter willsend 3 times signals to turn off the receiver (fire place). Caution: The changes or modifications not expressly approved by the party responsible forcompliance could void the user’s authority to operate the equipment. “Operation is subject to the following two conditions: (1) this device may not causeinterference, and (2) this device must accept any interference, including interferencethat may cause undesired operation of the device.”

Navigation menu