Skytech II TS-R-1 Digital Thermostat Transmitter User Manual SS

User Manual

SKYTECH II, INC

9230 Conservation Way, Fort Wayne, FCC ID: K9LTS-R-1

In 46809, USA

Tel: 260-459-1703

Fax: 260-459-1592

SKY TS/R-1 Digital Thermostat USER MANUAL

1) Rear Case- press ON/OFF(ON-the back left button, OFF- the back right button)

at the same time to change C or F

2) Front Case- move rod to OFF then send 3 times OFF signal to receiver

3) Front Case- move rod to ON then send 3 times ON signal to receiver

4) Front Case- move rod between OFF & ON for adjusting desire temperature.

When temperature below adjusted temperature then it will turn on receiver with

flame icon after 2 minutes. When temperature higher than adjusted temperature

then it will disable the flame icon then turn off the receiver. It will have SET icon

when rod was moved between ON & OFF scale.

The action of SKY TS/R-1

Use component RT-103AT to sense the temperature and compare with ROD SETTING temperature

which setting by users. When setting temperature below the room temperature then transmitter will send 3 times

signals to turn on the receivers. If SETTING temperature is higher than room temperature then transmitter will

send 3 times signals to turn off the receiver (fire place).

Caution:

The changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

“Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.”