Sonicwall 069 Access Point 802.11 a/b/g/n User Manual SonicPoint N GSG

Sonicwall, Inc. Access Point 802.11 a/b/g/n SonicPoint N GSG

Contents

revised user manual

Page 47 FCC Part 15 Class B Notice for the SonicWALL SonicPoint Wireless Appliance FCC Part 15 Class B Notice for the SonicWALL SonicPoint Wireless ApplianceNOTE: This equipment was tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. And, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference using one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment into an outlet on a circuit different from the receiver connection.• Consult SonicWALL for assistance.Complies with EN55022 Class B and CISPR22 Class B.*Refer to the label on the bottom of the unit for device information including Class A or Class B FCC information.FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.This device is restricted to indoor use only. Regardless of channelsetting, transmission on 5600 MHz to 5650 MHz is blocked. FCC and IC RF Radiation Exposure StatementThis equipment complies with FCC and IC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters (7.9 inches) between the radiator (antenna) and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. For more information regarding the above statement, please contact SonicWALL, Inc. at:1143 Borregas AvenueSunnyvale, CA, 94089-13061-408-745-9600North American Authorized ChannelsSonicWALL declares that the APL21-069 (FCC ID: QWU-069) (IC: 4408A-069) when sold in US or Canada is limited to CH1~CH11 by specified firmware controlled in the USA.Canadian Radio Frequency Emissions StatementThis Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.Industry Canada StatementThis device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:FCC and IC(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Caution:The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite systems. This device has been designed to operate with an antenna having a maximum gain of 4 dBm. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.SonicPoint_N_GSG.book Page 47 Friday, February 6, 2009 12:10 PM

Navigation menu