Sonicwall 069 Access Point 802.11 a/b/g/n User Manual SonicPoint N GSG

Sonicwall, Inc. Access Point 802.11 a/b/g/n SonicPoint N GSG

Contents

revised user manual

Download: Sonicwall 069 Access Point 802.11 a/b/g/n User Manual SonicPoint N GSG
Mirror Download [FCC.gov]Sonicwall 069 Access Point 802.11 a/b/g/n User Manual SonicPoint N GSG
Document ID1200398
Application IDtPTVSanuWzAoa7f8OA1HgA==
Document Descriptionrevised user manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize13.33kB (166614 bits)
Date Submitted2009-11-16 00:00:00
Date Available2010-03-31 00:00:00
Creation Date2009-11-05 17:31:12
Producing SoftwareAcrobat Distiller 7.0.5 (Windows)
Document Lastmod2009-11-17 10:56:47
Document TitleSonicPoint_N_GSG.book
Document CreatorFrameMaker 7.1
Document Author: pmlydon

SonicPoint_N_GSG.book Page 47 Friday, February 6, 2009 12:10 PM
FCC Part 15 Class B Notice for the
SonicWALL SonicPoint Wireless
Appliance
NOTE: This equipment was tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. And, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If the
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try and correct the interference using one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from the
receiver connection.
•
Consult SonicWALL for assistance.
Complies with EN55022 Class B and CISPR22 Class B.
*Refer to the label on the bottom of the unit for device information
including Class A or Class B FCC information.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
This device is restricted to indoor use only. Regardless of channel
setting, transmission on 5600 MHz to 5650 MHz is blocked.
FCC and IC RF Radiation Exposure Statement
This equipment complies with FCC and IC RF radiation exposure limits
set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20 centimeters (7.9
inches) between the radiator (antenna) and your body. This transmitter
must not be co-located or operating in conjunction with any other
antenna or transmitter.
Page 47 FCC Part 15 Class B Notice for the SonicWALL SonicPoint Wireless Appliance
For more information regarding the above statement, please contact
SonicWALL, Inc. at:
1143 Borregas Avenue
Sunnyvale, CA, 94089-1306
1-408-745-9600
North American Authorized Channels
SonicWALL declares that the APL21-069 (FCC ID: QWU-069)
(IC: 4408A-069) when sold in US or Canada is limited to CH1~CH11 by
specified firmware controlled in the USA.
Canadian Radio Frequency Emissions Statement
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB003 du Canada.
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules.
Operation is subject to the following two conditions:
FCC and IC
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Caution:
The device for the band 5150-5250 MHz is only for indoor usage to
reduce potential for harmful interference to co-channel mobile satellite
systems.
This device has been designed to operate with an antenna having a
maximum gain of 4 dBm. Antenna having a higher gain is strictly
prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Copy, Extract, Print high-res
XMP Toolkit                     : 3.1-701
Modify Date                     : 2009:11:17 10:56:47+08:00
Create Date                     : 2009:11:05 17:31:12-07:00
Metadata Date                   : 2009:11:17 10:56:47+08:00
Creator Tool                    : FrameMaker 7.1
Format                          : application/pdf
Title                           : SonicPoint_N_GSG.book
Creator                         : pmlydon
Document ID                     : uuid:2648d3e0-0773-4cb9-924e-807cbb3a833a
Instance ID                     : uuid:1cd927ef-0506-4c0e-a31a-4c4622243394
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Has XFA                         : No
Page Count                      : 1
Author                          : pmlydon
EXIF Metadata provided by EXIF.tools
FCC ID Filing: QWU-069

Navigation menu