Spotwave Wireless SPOTCELL0013 DU 1900 Full Band User Manual SpotCell 11x QuickStart 14Sep04

Spotwave Wireless Ltd. DU 1900 Full Band SpotCell 11x QuickStart 14Sep04

Contents

Quick start guide

™SpotCell 111s/112s ™SpotCell 111s/112s Quick Installation GuideQuick Installation Guidewww.spotwave.comSpotwave Wireless Inc. 1 Hines Road, Ottawa ON K2K 3C7 Canada 780-0000x-01-01© 2004 Spotwave Wireless Inc. All rights reserved. Printed in Canada Spotwave and SpotCell are trademarks of Spotwave Wireless Inc. Patents pending.
If required, more detailed information on installing a SpotCell system can be found in the User Manual which is also available for downloading at www.spotwave.com/2003/support/manuals.htm.2. LocationThe DU can be mounted anywhere your cell phone works. This may be on a rooftop (typical rural set-up), on the side of a building, or inside a building (typical downtown set-up). The CU will be mounted inside the building where your cell phone does not work.(The illustration at the right depicts a typical installation.) To start the installation, place the DU and CU in the general areas where they are to be located. Do not physically mount them at this time.Maximum separation between the DU and CU, and back-to-back positioning are optimal when both are mounted indoors. For quick installation of SpotCell:For quick installation of SpotCell:For your safety beware of power lines and ensure that appropriate safety measures are maintained at all times during the installation of the SpotCell 100 equipment.Contact with high-voltage power lines could result in death or serious injury., WARNING6. Align DU - 2nd rotationAgain rotate the DU. When the LED turns green, stop the rotation. This is the direction the DU must face when mounted. 10. Final Checklist1.Properly ground the DU via the grounding bolt. 2.Ensure that there is a drip loop on the cable connectingto the DU. 3.Firmly affix the cable to the building where it runsbetween the DU and CU.7. Mount DUNow mount the DU. Typical installations are pictured below .Wall Mount Pipe Mount with Hose ClampLED4. Set Mode and AP Switch Set the switch on the bottom of the CU to “1” (install).If only one of the split bands is currently active, then set the AP switch to the active band. If both bands are active, then the AP switch can be in either position for DU alignment. Connect the power supply to the CU, and then plug the adapter into the AC outlet. 8. Set CU to ActiveMove the switch on the bottom of the CU to “2” (active).Hold the CU in the location to be mounted. The LCD on the bottom of the CU indicates coverage ( ) by the number of bars; more bars indicate better coverage. DU (outward-facing unit) CU(indoor unit)1. Parts List• Mounting kit• Donor Unit (DU)• Coverage Unit (CU)• Cable (80'/25 m)• Power supplyxxxCHISvcen er iISvcen er i5. Align DU - 1st rotationIn the location where the DU is to be mounted, rotate the unit in a complete circle. The LED on the back will turn red or green during the rotation. 9. Mount CUMount the CU from a wall or ceiling, close to the center of the area requiring coverage.Rotate 360°3. Connect CU to DUConnect the CU and DU with the cable provided.Back of DUBack of CUBack of CUModeSwitchPowerConnectorAPSwitch

Navigation menu