TOSHIBA TEC Singapore S-0501 Printer User Manual Quick Start en
TOSHIBA TEC Singapore Pte Ltd Printer Quick Start en
Contents
- 1. User Manual 1
- 2. User Manual 2
User Manual 2
Operating the printer Quick start guide The bulge of the opened passbook should be as flat as possible to avoid malfunctions when the passbook is drawn into the printer. Place the passbook on the right-hand side of the document support with the page to be printed facing up. Press the fold down while you push the passbook into the document chute towards the stop. Keep pushing it in until it is automatically pulled into the correct print position. If the automatic document alignment cannot properly grasp stiff or bent passbooks, you should place the passbook manually at the stop at the right-hand side of the document support and insert it. 12 Quick start guide Operating the printer STOP Do not use passbooks that do not correspond to the specifications listed in the section “Paper specifications”. Otherwise the passbooks and the print head may be damaged. When the passbook is printed, it is automatically transported out of the printer and released for removal. If the passbook will not be transported automatically out of the printer you can eject it by pressing the EJECT key. The message ONLINE NO PAPER appears on the LCD again. 13 ENGLISH When the passbook is inserted, the message ONLINE PAPER is displayed on the LCD. Service and Maintenance Quick start guide Service and Maintenance ` Replacing the ribbon cassette Make sure that the printer is switched off before replacing the ribbon cassette. STOP The print head may be hot if the printer has been printing for a long time. Wait until it cools down and you are no longer in danger of being burnt. Open the cover by grasping it at the right and left-hand side and swing it upward until it clicks into position. Press the green release lever for the printing mechanism. This swings the printing mechanism backwards. 14 Service and Maintenance Remove the colored ribbon guide from the print head by pulling it downwards. ENGLISH Quick start guide Raise the front end of the ribbon cassette on both sides. Take the ribbon cassette out of the printer. 15 Service and Maintenance Quick start guide Take the new ribbon cassette from the packaging and lift the ribbon guide from the cassette. Remove the transportation lock which fixes the ribbon guide to the cassette. Insert the new ribbon cassette by hooking it into the rear slots of its mountings first. Push the front of the cassette into its mounting so that it clicks into position. Please do not press the center of the ribbon cassette as this will deform the ribbon cassette and will cause operation problem. 16 Service and Maintenance Pull the ribbon guide under the print head. Tighten the ribbon by turning the tension gear in the direction of the arrow. ENGLISH Quick start guide Press the ribbon guide onto the print head from underneath until you hear it click into place. Check if the ribbon is transported correctly by turning the tension gear in the direction of the arrow. 17 Service and Maintenance Quick start guide Close the main frame by pressing the colored section in the middle of the frame as shown and ensure both left and right hand sides of the frames are fully latched. Close the cover. The printer is now ready to operate and to be switched on again. We recommend to check the printer's operation after replacing the ribbon cassette by performing a printout of the parameter settings (see section “Printing the Status Page” on page 19”). 18 Quick start guide The printer has a function that allows you to printout the current parameter settings. Power the printer off. Press and hold the EJECT key while switching on the printer. The LCD displays Print StatusPage Load Paper. Release the EJECT key. Insert the paper in the printer. The LCD displays Print StatusPage Printing and the printout of the status page is carried out. The paper will be ejected once printing is complete. 19 ENGLISH ` Printing the Status Page Service and Maintenance Service and Maintenance Quick start guide While printing, you can use the STOP key to pause the printing and LCD will display Print StatusPage Stop. You can resume the printing by pressing the STOP key again. If EJECT key is pressed in the Pause state, paper will be ejected and a reset will be performed. When the test printout is aborted or completed, LCD will display Print StatusPage Completed. The Print setting mode will be ended automatically and a Power ON reset will be performed. 20 Quick start guide Technical data Technical data Printing method 24-pin Dot matrix impact printer Character pitch 10; 12; 15; 17; 20; 24 characters/inch and proportional type (emulation-dependent) Line spacing Optional in microsteps n/60 inches n = 0 to 127 n/180 inches n = 0 to 255 n/360 inches n = 0 to 255 Print width 194 characters/line at 10 cpi 112 characters/line at 12 cpi 141 characters/line at 15 cpi Print speed LQ: 133 cps; DQ: 400 cps Interface serial (RS232C), parallel (compatible Mode, ECP), USB 2.0 (Full speed) Nominal voltage 120V ± 10%, 230V ± 10% Line frequency 50/60Hz ± 3% Network form For use in power distribution systems with neutral and protective earth conductors (TN) Rated current intake Operation (maximum): US: 1.30 A; EU: 0.59 A Standby US: 0.11 A; EU: 0.072 A Apparent power consumption Operation (maximum): US: 89.7 VA; EU: 93.6 VA Standby US: 88.8 VA; EU: 11.4 VA True output Operation (maximum): US: 70.0 W; EU: 73.0 W Standby US: 76.9 W; EU: 78.9 W Sound output level LWAd 7.1 dB in operation ENGLISH ` Printer specifications Sound pressure level LpAm 55 dB in operation Dimensions Height: 168 mm, Width: 378 mm, Depth: 280 mm Weight Standard = 9,10 kg, MSR-H = 9,95 kg Approvals DIN EN 60 950 / VDE 0805, TUV (EN 60950) / Certified CE Mark, UL 60950 3rd Edition / C-UL (CSA C22.2 No 60950-00) new reversion, IEC 60950-1, EN 55022 :1998 (Class B), EN 55024 :1998, FCC PT 15B : 2000 (Class B), EN61000-3-2 :2000, EN61000-3-3 :1995, Energy Star For more information on printer specifications as well as interface specifications, refer to the User guide on the Online CD-ROM. 21 Technical data ` Paper specifications Quick start guide Only use paper that corresponds to the paper specifications and test new sorts of paper before use. Paper specifications for passbooks Paper specifications for single and multicopy sheets Paper width Open Book 105 to 235 mm (Horizontal passbook) 105 to 235 mm (Vertical passbook) Paper length Open Book 140 to 210 mm (Horizontal passbook) 125 to 210 mm (Vertical passbook) Passbook thickness 2.0 mm Max. (One cover + inner page) Thickness difference 1.4 mm Max. Paper weight 75 to 120 g/m2 Book condition Recommend to be flattened carefully before insertion. Paper width 70 to 240 mm Paper length 70 to 500 mm Paper weight Single sheet: 60 to 160 g/m2 Multi sheet: 80 to 260 g/m2 Paper Thickness Single sheet: 0.08 to 0.5 mm Multi sheet: 0.08 to 0.5 mm Number of Copies Original + 4 copies (Copy mode) Recycled paper is permitted on principle. Paper specification for cheques for the magnetic ink reader The magnetic ink reader (MICR) processes cheques that have a printing zone with magnetizable ink. Document width 76 mm to 102 mm Document length 152 mm to 210 mm For more information on general paper specifications, refer to the User guide on the Online CD-ROM. 22 Quick start guide Only use ribbon cassettes from the manufacturer as products from other manufacturers may damage the print head or the ribbon drive. ENGLISH ` Accessories Technical data Only use print heads that are approved to prevent damage to your printer. Accessory Order no. Fabric ribbon in recyclable cassettes, color: black 043 393 Print head 24 needles 400 805 23 “All rights reserved. Translations, reprinting or copying by any means of this manual complete or in part or in any different form requires our explicit approval. We reserve the right to make changes to this manual without notice. All care has been taken to ensure accuracy of information contained in this manual. However, we cannot accept responsibility for any errors or damages resulting from errors or inaccuracies of information herein.” «Tous droits réservés. Toute reproduction ou traduction de ce manuel, qu'elle soit complète, partielle ou sous une forme différente est interdite sans notre accord formel. Nous nous réservons le droit de modifier ce manuel sans préavis. Toutes les précautions ont été prises afin d'assurer l'exactitude des informations contenues dans ce manuel. Cependant, nous déclinons toute responsabilité pour les fautes ou dégats provenant d'erreurs ou d'inexactitudes qui seraient restées dans ce manuel.» TRADEMARK ACKNOWLEDGEMENTS • Centronics is a trademark of Centronics Data Computer Corporation. • PCL and PCL6 are trademarks of Hewlett-Packard Company. • IBM and IBM PC are trademarks of International Business Machines Corporation. • Apple, AppleTalk, TrueType, Laser Writer and Macintosh are trade-marks of Apple Computer, Inc. • Microsoft, Windows, Windows 9x, Windows 2000, Windows NT and MSDOS are registered trademarks of Microsoft Corporation. • PostScript is a trademark of Adobe Systems Inc. • All other brand or product names are trademarks of their respective companies or organizations. MARQUES DÉPOSÉES • Centronics est une marque déposée de Centronics Data Computer Corporation. • PCL et PCL6 sont des marques déposées de Hewlett-Packard Company. • IBM et IBM PC sont des marques déposées d’International Business Machines Corporation. • Apple, AppleTalk, TrueType, LaserWriter et Macintosh sont des mar-ques déposées d’Apple Computer Inc. • Microsoft, Windows, Windows 9x, Windows 2000, Windows NT et MSDOS sont des marques déposées de Microsoft Corporation. • PostScript est une marque déposée d’Adobe Systems Inc. • Toutes les autres marques ou noms de produit sont des marques déposées de leur détenteur respectif. TALLYGENICOM REPRESENTATIVES U.S.A. TallyGenicom 4500 Daly Drive, Suite 100 Chantilly, VA 20151 U.S.A. Phone: +1 703 633 8700 Fax: +1 703 222 7629 http://www.tallygenicom.com GERMANY TallyGenicom Computerdrucker GmbH Postfach 2969 D-89019 Ulm Deutschland Tel.: +49 731 2075 0 Fax: +49 731 2075 100 http://www.tallygenicom.de UNITED KINGDOM TallyGenicom Limited Rutherford Road Basingstoke, Hampshire RG24 8PD England, U.K. Phone: +44 870 872 2888 Fax: +44 870 872 2889 http://www.tallygenicom.co.uk ITALY TallyGenicom S.R.L. Via Borsini 6 I-20094 Corsico (MI) Italia Tel.: +39 02 48608 1 Fax: +39 02 48601 141 http://www.tallygenicom.it SPAIN TallyGenicom SRL Joaquin Lorenzo 4, Local 28033 Madrid España Phone: +34 902 196 183 Fax: +34 913 739 943 http://www.tallygenicom.es CANADA TallyGenicom 125 Traders Boulevard, 9 Missisauga, Ontario L4Z 2E5 Canada Phone: +1 905 8904646 Fax: +1 905 8904567 http://www.tallygenicom.com SINGAPORE TallyGenicom Pte. Ltd 63 Hillview Avenue #08-22, Lam Soon Industrial Building Singapore 669569 Phone: +65 6760 8833 Fax: +65 6760 1066 http://www.tallygenicom.com.sg MALAYSIA TallyGenicom Sdn. Bhd. Wisma KT, Suite 3.02 No 14 Jalan 19/1 46300 Petaling Jaya Selangor Darul Ehsan Malaysia Phone: +3 7625 1988 Fax: +3 7625 2688 http://www.tallygenicom.com.my © June 2005 TallyGenicom Computerdrucker GmbH FRANCE TallyGenicom S.A. 19 avenue de L'lle Saint Martin F-92237 Nanterre Cedex France Tél.: +33 1 41 30 11 00 Fax: +33 1 41 30 11 10 http://www.tallygenicom.fr AUSTRIA TallyGenicom Ges.m.b.H. Eduard-Kittenberger-Gasse 95B A-1232 Wien Austria Tel.: +43 1 863 40 0 Fax: +43 1 863 40 240 http://www.tallygenicom.co.at Russian Federation and C.I.S. TallyGenicom Representative Park Place Moscow Office D-206 Leninsky Prospekt 113/1 117198 Moscow Russian Federation Phone: +7 095 956 56 40 Fax: +7 095 956 56 41 http://www.tallygenicom.ru 043 398a
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Create Date : 2005:06:06 13:34:12+02:00 Modify Date : 2006:01:19 02:11:02+08:00 Page Count : 15 Creation Date : 2005:06:06 11:34:12Z Mod Date : 2005:06:06 11:34:12Z Producer : Acrobat Distiller 5.0 (Windows) Author : J.rgen Metadata Date : 2005:06:06 11:34:12Z Creator : J.rgen Title : Quick Start-en.bookEXIF Metadata provided by EXIF.tools