Tecpower TEC-001 Ipad Docking Station User Manual FINAL Digital DOCKr Manual

Tecpower(H.K.) Limited Ipad Docking Station FINAL Digital DOCKr Manual

User Manual

inNuevo takes no responsibility for any damage or malfuncon in any implied or expressed warranty or guarentee for your seperately purchased Apple iPad. For warranty informaon, visit our website. If you need assistance, call us at 202-537-1107.
TO OPEN AND CLOSE THE DOCKRTO USE THE DOCKR SPEAKERSTO USE THE INNUEVO OR APPLE WIRELESS KEYBOARD1. Put your thumb under the top lip of the DOCKr, and hold the boom8 of the DOCKr while opening Note: DOCKr baery must be charged to play the DOCKr speakers1. Slide the top of the DOCKr towards you with two hands1. inNuevo Keyboard: Locate the buons in the upper right corner and turn “on,” then push the “connect” buon2. Using two hands, slide the top of the DOCKr towards you12 3. Place your iPad in the DOCKr holding tray9 and slide the locks10 in the top corners to secure your iPad (applies to portrait and landscape modes)4. To close the DOCKr into a carrying case, use two hands to slide the top of the DOCKr to the back posion11, lock the iPad in landscape mode and close. Make sure your iPad is secured with DOCKr locks10 before closing2. Locate the buons in the back right corner of DOCKr, press the baery buon7 unl you see LED lights flash ON 3. Press and hold the speaker buon13 for four seconds, speakers are on when you hear the beep sounds, the LED lights will remain on4. Go to “Sengs” on your electron-ic device and turn on “Bluetooth”5. Touch the “DOCKr Wireless Speakers” device under Bluetooth sengs to connect6. To turn off, press speaker buon (LED lights will turn off)2. Go to “Sengs” on your iPad or electronic device and turn on “Bluetooth”3. Touch the “Wireless Keyboard” device under Bluetooth sengs to connect and follow any addional instruconsVisit our inNuevo website FAQ at hp://www.innuevo.com/faq.html1. Plug2. USB cable end3. Micro USB cable end4. Micro USB port5. LED lights6. Top of DOCKr7. Baery buon8. Boom of DOCKr9. DOCKr holding tray10. DOCKr Locks11. Back Posion12. Forward Posion13. Speakers buon14. Speakers15. Storage compartment16. USB port17. USB power cableTO CHARGE YOURELECTRONIC DEVICE1. Slide the top of the DOCKr towards you with two hands 2. Press the baery buon 3. Locate the USB power cable17 from the storage compartment15 under the keyboard (or use your own USB-compable cable)4. Plug the USB cable into the DOCKr’s USB outlet16 on the right side 5. Aach the other end of the cable to your electronic device TO CHARGE YOUR DOCKR3. Connect the plug to an outlet1. Slide the top6 of your DOCKr forward and locate the baery buon72. Hold the baery buon, the number of LED lights5 will show the baery life (5 lights reflect a fully charged baery)2. Plug the Micro USB cable end3 into the Micro USB port4 on the right side of the DOCKr1. Connect the plug1 to the USB cable end2Apple Keyboard: Li up the keyboard and push the power buon on the right sideCAPS Charge Power CONNECT OFF/ONTO CHECK THE DOCKR’S BATTERY
FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Changes or modification warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between theequipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. * RF warning for Portable device: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Navigation menu