Tecpower TEC-001 Ipad Docking Station User Manual FINAL Digital DOCKr Manual
Tecpower(H.K.) Limited Ipad Docking Station FINAL Digital DOCKr Manual
Tecpower >
User Manual
inNuevo takes no responsibility for any damage or malfunction in any implied or expressed warranty or guarentee for your seperately purchased Apple iPad. For warranty information, visit our website. If you need assistance, call us at 202-537-1107. TO CHARGE YOUR DOCKR 1. Connect the plug1 to the USB cable end2 2. Plug the Micro USB cable end3 into the Micro USB port4 on the right side of the DOCKr 1. Plug 2. USB cable end 3. Micro USB cable end 4. Micro USB port 5. LED lights 6. Top of DOCKr 7. Battery button 8. Bottom of DOCKr 9. DOCKr holding tray 10. DOCKr Locks 11. Back Position 12. Forward Position 13. Speakers button 14. Speakers 15. Storage compartment 16. USB port 17. USB power cable 3. Connect the plug to an outlet TO CHECK THE DOCKR’S BATTERY 1. Slide the top6 of your DOCKr forward and locate the battery button7 2. Hold the battery button, the number of LED lights5 will show the battery life (5 lights reflect a fully charged battery) TO OPEN AND CLOSE THE DOCKR 3. Place your iPad in the DOCKr holding tray9 and slide the locks10 in the top corners to secure your iPad (applies to portrait and landscape modes) 1. Put your thumb under the top lip of the DOCKr, and hold the bottom8 of the DOCKr while opening 4. To close the DOCKr into a carrying case, use two hands to slide the top of the DOCKr to the back position11, lock the iPad in landscape mode and close. Make sure your iPad is secured with DOCKr locks10 before closing 2. Using two hands, slide the top of the DOCKr towards you12 TO USE THE DOCKR SPEAKERS Note: DOCKr battery must be charged to play the DOCKr speakers 1. Slide the top of the DOCKr towards you with two hands 3. Press and hold the speaker button13 for four seconds, speakers are on when you hear the beep sounds, the LED lights will remain on 4. Go to “Settings” on your electronic device and turn on “Bluetooth” 5. Touch the “DOCKr Wireless Speakers” device under Bluetooth settings to connect 2. Locate the buttons in the back right corner of DOCKr, press the battery button7 until you see LED lights flash ON 6. To turn off, press speaker button (LED lights will turn off) TO USE THE INNUEVO OR APPLE WIRELESS KEYBOARD 1. inNuevo Keyboard: Locate the buttons in the upper right corner and turn “on,” then push the “connect” button Apple Keyboard: Lift up the keyboard and push the power button on the right side CAPS Charge Power CONNECT OFF/ON TO CHARGE YOUR ELECTRONIC DEVICE 1. Slide the top of the DOCKr towards you with two hands 2. Press the battery button 2. Go to “Settings” on your iPad or electronic device and turn on “Bluetooth” 3. Touch the “Wireless Keyboard” device under Bluetooth settings to connect and follow any additional instructions 3. Locate the USB power cable17 from the storage compartment15 under the keyboard (or use your own USB-compatible cable) 4. Plug the USB cable into the DOCKr’s USB outlet16 on the right side 5. Attach the other end of the cable to your electronic device Visit our inNuevo website FAQ at http://www.innuevo.com/faq.html FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Changes or modification warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between theequipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. * RF warning for Portable device: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39 Format : application/pdf Title : FINAL Digital DOCKr Manual Metadata Date : 2013:05:13 00:01:32+08:00 Modify Date : 2013:05:13 00:01:32+08:00 Create Date : 2013:05:02 09:36:18-04:00 Creator Tool : Adobe Illustrator CS6 (Windows) Thumbnail Width : 256 Thumbnail Height : 160 Thumbnail Format : JPEG Thumbnail Image : (Binary data 11590 bytes, use -b option to extract) Instance ID : uuid:f61d2892-25fa-45c2-9e2b-b474c078ec3c Document ID : xmp.did:FDD696432DB3E211AD4BAE4E5646BEDD Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:7e7ada27-7421-4288-81bb-b51f3bc01bda Derived From Document ID : xmp.did:30CAB08C94B2E211B6EE84A60A436D91 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:BAAAC873E1B0E211927E9764B1C103F1, xmp.iid:FDD696432DB3E211AD4BAE4E5646BEDD History When : 2013:04:29 11:28:33-04:00, 2013:05:02 09:36:16-04:00 History Software Agent : Adobe Illustrator CS6 (Windows), Adobe Illustrator CS6 (Windows) History Changed : /, / Startup Profile : Print Has Visible Overprint : False Has Visible Transparency : True N Pages : 1 Max Page Size W : 11.000000 Max Page Size H : 17.000000 Max Page Size Unit : Inches Font Name : Calibri, GENISO, Calibri-Bold, MyriadPro-Regular Font Family : Calibri, GENISO, Calibri, Myriad Pro Font Face : Regular, Regular, Bold, Regular Font Type : Open Type, TrueType, Open Type, Open Type Font Version : Version 5.62, Version 1.000, Version 5.62, Version 2.102;PS 2.000;hotconv 1.0.67;makeotf.lib2.5.33168 Font Composite : False, False, False, False Font File Name : calibri.ttf, GENISO.ttf, calibrib.ttf, MyriadPro-Regular.otf Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Group Name : Brights Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 60.000004 Swatch Groups Colorants Magenta : 90.000000 Swatch Groups Colorants Yellow : 0.003099 Swatch Groups Colorants Black : 0.003099 Producer : Adobe PDF library 10.01 Page Count : 3 Creator : Adobe Illustrator(R) 16.0 For : Staff8, Bounding Box : -1 -1308 2088 1 Container Version : 11 Creator Version : 16EXIF Metadata provided by EXIF.tools