Teletronics TT900 TT Bridge Router User Manual IP3K Rev TT900
Teletronics International Inc TT Bridge Router IP3K Rev TT900
Contents
- 1. Professional installation User Manual
- 2. User Manual
User Manual
TT™900 User Manual 802.11b/g 200mW Table of Contents Disclaimers ………………………….………….….…….……….….………........3 Introduction ……………………………………………………………………….4 Product Features ………………………………………………………………...5 Product Specifications ………………………………………………………….5 Installation ………………………………………………………………..………10 Configuring windows for IP Networking ……………………………………11 Web Configuration Interface ………………………………………………….13 Client Bridge Mode …………………….………….…….………………………13 Access Point Mode …………………………………………………………...…30 Appendix A: Warranty Policy ……………………………………………...…..50 Appendix B: RMA Policy …………………………………………………...…..51 Appendix C: Regulatory Information ……………………………………...…52 Appendix D: Contact Information ………………………………………...…..54 Appendix E: WDS Explained ……………………………………………...…..55 Appendix F: TT900 Upgrade FAQ …….…………………...…...……………..57 Appendix G: Antenna Diversity ……………………………………………....59 Appendix H: Troubleshooting ………………………………………………...60 Appendix I: Key Requirement Chart.…………………..……………………..61 Appendix J: Glossary ……………………………………..……………………62 Disclaimers No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation or adaptation) without written permission from the copyright owner. All other trademarks and registered trademarks are the property of their respective owners. Statement of Conditions We may make improvements or changes in the product described in this documentation at any time. The information regarding the product in this manual is subject to change without notice. We assume no responsibility for errors contained herein or for direct, indirect, special, incidental or consequential damages with the furnishing, performance or use of this manual or equipment supplied with it, even if the suppliers have been advised about the possibility of such damages. Electronic Emission Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. FCC INFORMATION The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph: The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment usage generates radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no grantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. The equipment is for home or office use. IMPORTANT NOTE FCC RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the antenna and your body and must not be co-located or operating in conjunction with any other antenna or transmitter. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Introduction The TT900 is Teletronics’s answer to the ever growing demand for higher bandwidth and security in a wireless network environment. It is based on a brand new redesigned platform that not only offers faster performance and capacity but also supports all current pre IEEE 802.11i wireless security standards. The TT900 is housed in a weather-proof NEMA 4 enclosure, supports high power 802.11 b/g radio, industrial grade construction, multiple antenna options, surge protection on the radio and PoE (Power Over Ethernet) adaptor, and RoHS compliance. TT5800 Product Photos TT900 PCB IEEE 802.11a miniPCI Card TT900 Enclosure (Die Cast Aluminum NEMA 4 Box) Product Features • • • • • • • • • Compact size for small enterprise or system integrate service market Compliant with IEEE 802.11b/g specifications Supports 64/128-bit WEP, WPA and IEEE802.1x Intelligent firmware upgrade via Web browser Built-in Web-based utility for easy configuration from any Web browser Support POE (IEEE 802.3af) function Supports wireless bridging and MAC address filtering Provide 10/100M, auto sensing MDI/MDI-X Ethernet port EzManager Support Product Specifications Main Chips • • CPU: Ubicom IP3023 Radio: Supports 802.11b/g Atheros AR5414 Mechanical • Chassis Dimension (W x D x L): 7.5” x 2.75”x 9” Board Specifications Specification Description Network Standard IEEE 802.11 b/g, IEEE 802.3, IEEE802.3x Ethernet 10/100BaseT Ethernet, Auto MDI/MDI-X Network Architecture Infrastructure; Ad-Hoc MAC CSMA/CA POWER, Wireless LAN(RF),Ethernet LAN, Receives Signal Strength(RSS) Reset to Default Button Status Indicators Push Button Radio Specifications • IEEE 802.11b/g 2.4 GHz mini-PCI card Specification Chipset Description MAC/BB Processor Atheros AR5414 Power Consumption IEEE 802.11b TX: ~1100 mA RX: ~600 mA IEEE 802.11g TX: ~1100 mA RX: ~600 mA Antenna Connector SMA connector IEEE 802.11b: • • • • Output Power IEEE 802.11g: • • • • Receiver Sensitivity 23dBm (± 1.5dB) @ 1Mbps 22dBm (± 1.5dB) @ 2Mbps 21dBm (± 1.5dB) @ 5.5Mbps 20dBm (± 1.5dB) @ 11Mbps 23dBm (±1.5dB) @ 54Mbps 22dBm (±1.5dB) @ 48Mbps 21dBm (±1.5dB) @ 36Mbps 20dBm (±1.5dB) @ 1~24 Mbps IEEE 802.11b/g Sensitivity @ 8% Packet Error Rate • • 54Mbps:-72dBm 6Mbps:-92dBm IEEE 802.11b (DSSS) • • • 5.5/11 Mbps (CCK) 2 Mbps (DQPSK) 1 Mbps (DBPSK) IEEE 802.11g (OFDM/DSSS) Modulation Operating Frequency • • • • • • • 48/54 Mbps (QAM-64) 24/36 Mbps (QAM-16) 12/18 Mbps (QPSK) 6/9 Mbps (BPSK) 5.5/11Mbps (CCK) 2Mbps (DQPSK) 1Mbps (DBPSK) • USA(FCC): 902 MHz ~ 928 MHz LED Definition (Optional) Item Power RF(WLAN) LAN ON (Red) Off Specification Power on No power On (Yellow) Connected Off Not connected Blinking(Green) Connected and transmitting On (Green) Connected Off Not connected Blinking(Green) Connected and transmitting Blinking left to Received Signal Strength right Indicator (RSSI) On Not connected (Scanning for AP) Connected, indicating Received Signal Strength. Software Specification Item Bridge Features Security Features Management Features • • • • • • • • • • • Specification Universal Bridging MAC Address Cloning RTS Threshold/Fragmentation Threshold Infrastructure or Ad-Hoc Mode Non-IP Traffic Bridging 64-Bit/128-Bit WEP Encryption WPA Personal Using TKIP or AES WPA Enterprise Using TKIP or AES 802.1x Authenticator Cisco LEAP Support MAC Address Filter • • • • • • Web Access (Username/Password Protected) Static IP Automatic Device Discovery & Configuration SNMP v1, DHCP and PPPoE (Ethernet or Wireless) Firmware Upgrade via Web Browser Transmit Power Adjustment External AC Power Adapter Item Specification Input Voltage 110-240VAC Line Frequency 50/60Hz Power Output to M/B 48VDC, 1A Environmental Item Operating Temperature Storage Temperature Specification -20 C to 70 C (-4 F to 158 F), 10 to 90% (non-condensing) -25 C to 80 C (-13 F to 176 F), 10 to 90% (non-condensing) Standards / Regulatory Compliance • CE, FCC Product Kit Part Listing 1. 2. 3. 4. 5. 6. 7. 8. TT900 802.11b/g PCBA (1) IEEE 802.11b/g mini-PCI radio card (1) Power over Ethernet Injector (1) 48VDC Power Adapter (1) Ethernet Cable (2) Waterproof RJ-45 Connector (1) Mounting Hardware (1) User Manual Note: If any item listed above is damaged or missing, please contact your dealer immediately. System Requirements • • • • Any desktop or laptop with an Ethernet interface TCP/IP protocol suite installed Standard CAT5 Ethernet cables with RJ45 connectors Internet Explorer 5.0 or later / Firefox 1.0 or higher Note: Professional must install this device. End-user cannot set the functionality by hardware or software from one to another directly. End-user can adjust output power through a drop down menu, but cannot adjust the output power over the applicati on. The EUT will be settled output power not greater than the application by Manufacturer. Installation of this device should be accomplished only by a qualified wireless LAN system installer who is: • Knowledgeable of the use. Installation and configuration procedures and associated networking components. • Knowledgeable of each system component’s equipment User and Installation Guide. • Knowledgeable of the installation procedures, safety, and code requirements for the site’s antenna, antenna mast, antenna cabling, and installation. TELETRONICS highly recommends that the antenna installation be performed by a qualified antenna installation professional. The intended use is generally not for the general public. It is generally for industry/commercial use. The device cannot be sold retail, to the general public or by mall order. It must be sold to dealers or have strict marketing control. The intended use is generally not for the general public. It is generally for industry/commercial use.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Encryption : Standard V2.3 (128-bit) User Access : Print Modify Date : 2007:07:05 10:19:37+08:00 Create Date : 2007:07:05 10:18:03+08:00 Title : Microsoft Word - IP3K User Manual Rev TT900.doc Author : tiimisu Creator : PScript5.dll Version 5.2.2 Producer : Acrobat Distiller 7.0.5 (Windows) Page Count : 8 Mod Date : 2007:07:05 10:19:37+08:00 Creation Date : 2007:07:05 10:18:03+08:00 Metadata Date : 2007:07:05 10:19:37+08:00 Has XFA : NoEXIF Metadata provided by EXIF.tools